Engineering Papers⌕ Search

Engineering topics

Muller, J.-P.

Publications and source records attributed to Muller, J.-P..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Topography of Apollinaris Patera and Ma'adim Vallis

Digital elevation models of the northern part of Ma'adim Vallis (603a41 607m/pix, 639a91 721m/pix), and Apollinaris Patera (603a42 612m/pix, 639a92 717m/pix), covering the area between 180 degrees to 190 degrees long and -2 degrees to -20 degrees lat. were obtained using a method described here. The results for the Ma'adim Vallis area show broad agreement with the United States Geological Survey (USGS) topographic map of the area with a channel depth of 1 to 2 km. A detailed study of the variations in the channel depth along its course and calculations of its discharge rate from channel cross section and slope are currently being undertaken. Results for Apollinaris Patera have been obtained, although the absolute heights relative to the Mars datum are not well constrained. However, the relative heights are sufficient for some analysis. Again, the topographic map is in reasonable agreement with the USGS map of the area, although there are significant differences.

Thornhill, G. D.↗
NASA NTRS1991

Measurement of surface microtopography

Acquisition of ground truth data for use in microwave interaction modeling requires measurement of surface roughness sampled at intervals comparable to a fraction of the microwave wavelength and extensive enough to adequately represent the statistics of a surface unit. Sub-centimetric measurement accuracy is thus required over large areas, and existing techniques are usually inadequate. A technique is discussed for acquiring the necessary photogrammetric data using twin film cameras mounted on a helicopter. In an attempt to eliminate tedious data reduction, an automated technique was applied to the helicopter photographs, and results were compared to those produced by conventional stereogrammetry. Derived root-mean-square (RMS) roughness for the same stereo-pair was 7.5 cm for the automated technique versus 6.5 cm for the manual method. The principal source of error is probably due to vegetation in the scene, which affects the automated technique but is ignored by a human operator.

Wall, S. D.↗
NASA NTRS1989

Measurement of surface microtopography using helicopter-mounted stereo film cameras and two stereo matching techniques

A common problem in acquiring ground-truth data for use in microwave interaction modeling is the capture of surface roughness data that are both sampled at distances comparable to a fraction of the wavelength and extensive enough to represent the surface statistics in at least one resolution cell of the microwave remote sensor used. A technique has been developed for acquiring the necessary photogrammetric data using twin 70-mm film cameras mounted on a helicopter boom. The apparatus is described, and the accuracy with which ground surface roughness can be characterized using this device is estimated. Both standard and cross-correlation methods were used for data reduction. Stereogrammetry is compared with a completely automated image-matching technique. Dense disparity images were generated from the helicopter stereo pairs. Using interior orientation parameters supplied by the camera manufacturers, and assuming that exterior orientation parameters remain constant between control target and test field photography, an extremely dense DEM (digital elevation model) for a test field has been derived. Results are compared, and accuracy estimates are presented.

Wall, S. D.↗
NASA NTRS1981

Interaction of eddies and mean zonal flow on Jupiter as inferred from Voyager 1 and 2 images

Voyagers 1 and 2 narrow angle frames are used to obtain displacements of features at resolutions of 130 km over time intervals of 1 Jovian rotation. It is shown that the mean zonal velocity profile does not change by a measurable amount between Voyagers 1 and 2, which is consistent with previous observations. It is also shown that the curvature of the velocity profile vanes varies with latitudes in the range from -3 beta to +2 beta. The barotropic stability criterion is violated at 10 latitudes between + and - 60 deg, and the rate of conversion of eddy kinetic energy into zonal mean kinetic energy is in the range from 1.5 to 3.0 per sq Wm for a layer 2.5 bar deep. The rate of energy conversion is more than 10% of the total infrared heat flux for Jupiter, as compared to the earth where it is only 0.1% of the infrared, which suggests that the two planets possess fundamentally different thermomechanical energy cycles.

Ingersoll, A. P.↗
NASA NTRS1979

Jovian cloud structure and velocity fields

A global view of Jovian small-scale morphologies and zonal velocity profiles has been discussed previously. In the present paper, a regional comparison is made of the structures and velocity fields (meridional and zonal velocities) in the Jovian atmosphere as observed by Voyager I imaging system. The cloud structures discussed are fairly independent of the visual wavelength. The analysis shows that although both Jovian hemispheres exhibit similar patterns of diminishing and alternating eastward and westward jets as one progresses polewards, there is a pronounced asymmetry in the structural appearance of the two hemispheres.

Mitchell, J. L.↗