Engineering topics

Mueller, Eric R.

Publications and source records attributed to Mueller, Eric R..

12 records

NASA NTRS2016

Air Traffic Controller Acceptability of Unmanned Aircraft System Detect-and-Avoid Thresholds

A human-in-the-loop experiment was conducted with 15 retired air traffic controllers to investigate two research questions: (a) what procedures are appropriate for the use of unmanned aircraft system (UAS) detect-and-avoid systems, and (b) how long in advance of a predicted close encounter should pilots request or execute a separation maneuver. The controller participants managed a busy Oakland air route traffic control sector with mixed commercial/general aviation and manned/UAS traffic, providing separation services, miles-in-trail restrictions and issuing traffic advisories. Controllers filled out post-scenario and post-simulation questionnaires, and metrics were collected on the acceptability of procedural options and temporal thresholds. The states of aircraft were also recorded when controllers issued traffic advisories. Subjective feedback indicated a strong preference for pilots to request maneuvers to remain well clear from intruder aircraft rather than deviate from their IFR clearance. Controllers also reported that maneuvering at 120 seconds until closest point of approach (CPA) was too early; maneuvers executed with less than 90 seconds until CPA were more acceptable. The magnitudes of the requested maneuvers were frequently judged to be too large, indicating a possible discrepancy between the quantitative UAS well clear standard and the one employed subjectively by manned pilots. The ranges between pairs of aircraft and the times to CPA at which traffic advisories were issued were used to construct empirical probability distributions of those metrics. Given these distributions, we propose that UAS pilots wait until an intruder aircraft is approximately 80 seconds to CPA or 6 nmi away before requesting a maneuver, and maneuver immediately if the intruder is within 60 seconds and 4 nmi. These thresholds should make the use of UAS detect and avoid systems compatible with current airspace procedures and controller expectations.

unmanned aircraft systems↗

NASA NTRS2016

Piloted "Well Clear" Performance Evaluation of Detect-and-Avoid Systems with Suggestive Guidance

This study evaluated the performance of four prototype unmanned aircraft detect-and-avoid (DAA) display configurations, each with different informational elements driven by alerting and guidance algorithms. Sixteen unmanned aircraft pilots flew each combination of the display configurations, with half being given zero DAA surveillance sensor uncertainty and the other half experiencing errors that were comparable, and in some cases slightly better than, errors that were measured in DAA system flight tests. The displays that showed intruder alert information in altitude and heading bands had significantly fewer losses of well clear compared with alternative displays that lacked that information. This difference was significant from a statistical and practical perspective: those losses that did occur lasted for shorter periods and did not penetrate as far into the geometric "separation cylinder" as those in the non-banded displays. A modest level of DAA surveillance sensor uncertainty did not affect the proportion of losses of well clear or their severity. It is recommended that DAA traffic displays implement a band-type display in order to improve the safety of UAS operations in the National Airspace System. Finally, this report provides pilot response time distributions for responding to DAA alerts.

unmanned aircraft system↗

NASA NTRS2015

Pilot Evaluation of a UAS Detect-and-Avoid System's Effectiveness in Remaining Well Clear

Unmanned aircraft will equip with a detect-and-avoid (DAA) system that allows them to comply with the requirement to see and avoid other aircraft, an important layer in the overall set of procedural, strategic and tactical separation methods designed to prevent mid-air collisions. Although the effectiveness of the DAA system will be set to a minimum threshold by regulators, different combinations of algorithms, displays and procedures could be used to meet that minimum. The research presented in this paper indicates the effectiveness of the combined pilot-DAA system as a function of the DAA design requirements and provides data that may be used to model the behavior of pilots when employing such systems. Over the course of two simulations 21 professional UAS pilots evaluated eight different DAA system designs and metrics were collected on their ability to maintain the well clear separation standard. The independent variables were the time horizon at which pilots were alerted to potential losses of well clear, the location of the traffic display, and the tools and informational elements available on the display to aid the pilot in detecting and resolving those potential losses. In the second experiment the UAS encountered two categories of aircraft: those equipped with simulated transponders that could be seen dozens of miles away and those without that were only detectable by a simulated radar within a range of six nautical miles. The data indicate that integrating the traffic display with the primary mission map directly in front of the pilot reduced the frequency of losses of well clear. Improved detection and resolution tools, including explicit maneuver guidance and a trial planning capability, had less of an effect in reducing the frequency of losses but significantly reduced the time in loss when they occurred. The amount of warning time provided to the pilot had a strong effect on their ability to remain well clear: when alerts were first presented with less than about 15 seconds to a predicted loss of well clear pilots were able to maneuver successfully in only 26 percent of encounters, whereas they were about 83 percent successful when they had more than 15 seconds. Pilots' ability to separate from the two categories of aircraft was nearly the same after accounting for the amount of alert time provided in each encounter, although the limited surveillance volume for the non-transponder equipped aircraft meant alerts tended to occur later and therefore were more difficult to resolve.

loss of well clear↗

NASA NTRS2014

Pilot Evaluation of a UAS Detect-and-Avoid System's Effectiveness in Remaining Well Clear

Unmanned aircraft will equip with a detect-and-avoid (DAA) system that enables them to comply with the requirement to "see and avoid" other aircraft, an important layer in the overall set of procedural, strategic and tactical separation methods designed to prevent mid-air collisions. Regulators will establish minimum operating standards for DAA effectiveness, but different combinations of algorithms, displays and procedures could be used to meet those standards. The research presented in this paper indicates the effectiveness of the combined pilot-DAA system as a function of the DAA design requirements and provides data that may be used to model the behavior of pilots when employing such systems. Two simulations involving 21 professional unmanned aircraft system (UAS) pilots evaluated eight different DAA system designs in order to assess their ability to maintain the "well clear" separation standard, i.e., the state of maintaining a safe distance from other aircraft that would not normally cause the initiation of a collision avoidance maneuver by either aircraft. When the traffic display was integrated with the primary mission map directly in front of the pilot, there were fewer losses of well clear. Greater warning time provided to the pilot was strongly correlated with success in remaining well clear. Pilots' ability to separate from aircraft with cooperative and non-cooperative surveillance systems was nearly the same after accounting for the amount of alert time provided in each encounter, although the limited surveillance volume for the airborne-equipped aircraft meant alerts tended to occur later and therefore were more difficult to resolve.

detect-and-avoid↗

NASA NTRS2014

Investigating the Impacts of a Separation Standard for UAS Operations in Enroute and Transition Airspace

Unmanned aircraft systems will be required to equip with a detect and avoid system in order to satisfy the federal aviation regulations to remain well clear of other aircraft. To comply with regulations in today’s operations manned aircraft must “see and avoid” other aircraft and use subjective judgment to determine whether those aircraft are well clear. For a detect-and- avoid (DAA) system to satisfy the requirement to stay well clear, a quantitative definition of well clear needs to be defined and evaluated. Definitions for the boundary of well clear have been proposed by the Unmanned Aircraft System (UAS) Executive Committee Science and Research Panel (SaRP) and the Radio Technical Commission for Aeronautics (RTCA) Special Committee 228 on Detect and Avoid Systems. This study investigates the interoperability implications of UAS using proposed well clear definitions as a separation standard for conducting operations in the national airspace system. The first analysis in the study focuses on the effect of variations in well clear definition parameters on the rate of losses of well clear per flight hour. The second analysis considers three well clear definitions and presents the relative state conditions of intruder aircraft as they encroach upon the well clear boundary. The third analysis focuses on the definition of the alerting criteria needed to inform the UAS operator of a potential loss of well clear. All three analyses are conducted in a NAS-wide fast-time simulation environment using UAS aircraft models, proposed UAS missions, and historical air defense radar data to populate the background traffic operating under visual flight rules. The results from the three analyses presented in this study inform the safety case, requirements development, and the operational environment for the DAA minimum operational performance standards.

UAS Seperation Standard↗

NASA NTRS2011

Orion Capsule Handling Qualities for Atmospheric Entry

Two piloted simulations were conducted at NASA's Johnson Space Center using the Cooper-Harper scale to study the handling qualities of the Orion Command Module capsule during atmospheric entry flight. The simulations were conducted using high fidelity 6-DOF simulators for Lunar Return Skip Entry and International Space Station Return Direct Entry flight using bank angle steering commands generated by either the Primary (PredGuid) or Backup (PLM) guidance algorithms. For both evaluations, manual control of bank angle began after descending through Entry Interface into the atmosphere until drogue chutes deployment. Pilots were able to use defined bank management and reversal criteria to accurately track the bank angle commands, and stay within flight performance metrics of landing accuracy, g-loads, and propellant consumption, suggesting that the pilotability of Orion under manual control is both achievable and provides adequate trajectory performance with acceptable levels of pilot effort. Another significant result of these analyses is the applicability of flying a complex entry task under high speed entry flight conditions relevant to the next generation Multi Purpose Crew Vehicle return from Mars and Near Earth Objects.

Tigges, Michael A.↗

NASA NTRS2011

Orion Handling Qualities During ISS Proximity Operations and Docking

NASA's Orion spacecraft is designed to autonomously rendezvous and dock with many vehicles including the International Space Station. However, the crew is able to assume manual control of the vehicle s attitude and flight path. In these instances, Orion must meet handling qualities requirements established by NASA. Two handling qualities assessments were conducted at the Johnson Space Center to evaluate preliminary designs of the vehicle using a six degree of freedom, high-fidelity guidance, navigation, and control simulation. The first assessed Orion s handling qualities during the last 20 ft before docking, and included both steady and oscillatory motions of the docking target. The second focused on manual acquisition of the docking axis during the proximity operations phase and subsequent station-keeping. Cooper-Harper handling qualities ratings, workload ratings and comments were provided by 10 evaluation pilots for the docking study and 5 evaluation pilots for the proximity operations study. For the docking task, both cases received 90% Level 1 (satisfactory) handling qualities ratings, exceeding NASA s requirement. All ratings for the ProxOps task were Level 1. These evaluations indicate that Orion is on course to meet NASA's handling quality requirements for ProxOps and docking.

Stephens, John-Paul↗

NASA NTRS2010

Handling Qualities of a Capsule Spacecraft During Atmospheric Entry

A piloted simulation was conducted to study handling qualities for capsule spacecraft entering the Earth s atmosphere. Eight evaluation pilots, including six pilot astronauts, provided Cooper-Harper ratings, workload ratings, and qualitative comments. The simulation began after descending through the atmospheric entry interface point and continued until the drogue parachutes deployed. There were two categories of piloting tasks, both of which required bank angle control. In one task category, the pilot followed a closed-loop bank angle command computed by the backup guidance system to manage g-loads during entry. In the other task category, the pilot used intuitive rules to determine the desired bank angle independently, based on an open-loop schedule of vertical speed, Mach, and total energy specified at several range-to-target gates along the entry trajectory. Pilots were able to accurately track the bank angle guidance commands and steered the capsule toward the recovery site with essentially the same range error as the benchmark autopilot trajectory albeit with substantially higher propellant usage, and the handling qualities for this task were satisfactory. Another key result was that the complex piloting task of atmospheric entry could be performed satisfactorily, even in the presence of large dispersions, by controlling bank angle to follow a simple open-loop schedule.

Bilimoria, Karl D.↗

NASA NTRS2010

Sub-millimeter wave frequency heterodyne detector system

The present invention relates to sub-millimeter wave frequency heterodyne imaging systems. More specifically, the present invention relates to a sub-millimeter wave frequency heterodyne detector system for imaging the magnitude and phase of transmitted power through or reflected power off of mechanically scanned samples at sub-millimeter wave frequencies.

Siegel, Peter H.↗

NASA NTRS2009

Cooper-Harper Experience Report for Spacecraft Handling Qualities Applications

A synopsis of experience from the fixed-wing and rotary-wing aircraft communities in handling qualities development and the use of the Cooper-Harper pilot rating scale is presented as background for spacecraft handling qualities research, development, test, and evaluation (RDT&E). In addition, handling qualities experiences and lessons-learned from previous United States (US) spacecraft developments are reviewed. This report is intended to provide a central location for references, best practices, and lessons-learned to guide current and future spacecraft handling qualities RDT&E.

Bailey, Randall E.↗

NASA NTRS2009

Sub-millimeter wave frequency heterodyne detector system

Siegel, Peter H.↗

NASA NTRS2007

Terahertz local oscillator for the Microwave Limb Sounder on the Aura satellite

The Microwave Limb Sounder on the Aura satellite has a radiometer at 2.5 THz to perform global mapping of OH in the atmosphere. The OH radiometer utilizes two Schottky-diode mixers pumped by an optically pumped THz gas laser local oscillator. The laser was first turned on in space on July 22, 2004, and has performed without issue for more than 30 months. The specifications, design, and modeling of this 2.5 THz laser local oscillator are presented here, along with some of the important design validation and test results.

Pickett, Herbert M.↗