Engineering PapersSearch

Engineering topics

Morgan, William C.

Publications and source records attributed to Morgan, William C..

A vision for planetary exploration

A vision for planetary exploration is proposed which combines historical perspective and current NASA studies with the realities of changing political climates, economic environments, and technological directions. The concepts of Strategic Implementation Architectures (SIA), Open System Infrastructure Standards (OSIS), and Minimum Service Level Infrastructure (MSLI) are presented in order to propose a structure for the SEI which allows the realization of incremental mission objectives, establishes an investment strategy that efficiently uses public resources, and encourages partnerships with the government. The SIA is a hypothetical master plan which will allow the implementation of the complete spectrum of envisioned system capabilities for planetary exploration. OSIS consists of standards for interconnection, interoperability, and administration. MSLI can be defined as the minimum level of services provided by the system that are not justified by profit or parochial motives.

Connolly, John F.

Air-Cooled Turbine Blades with Tip Cap For Improved Leading-Edge Cooling

An investigation was conducted in a modified turbojet engine to determine the cooling characteristics of the semistrut corrugated air- cooled turbine blade and to compare and evaluate a leading-edge tip cap as a means for improving the leading-edge cooling characteristics of cooled turbine blades. Temperature data were obtained from uncapped air-cooled blades (blade A), cooled blades with the leading-edge tip area capped (blade B), and blades with slanted corrugations in addition to leading-edge tip caps (blade C). All data are for rated engine speed and turbine-inlet temperature (1660 F). A comparison of temperature data from blades A and B showed a leading-edge temperature reduction of about 130 F that could be attributed to the use of tip caps. Even better leading-edge cooling was obtained with blade C. Blade C also operated with the smallest chordwise temperature gradients of the blades tested, but tip-capped blade B operated with the lowest average chordwise temperature. According to a correlation of the experimental data, all three blade types 0 could operate satisfactorily with a turbine-inlet temperature of 2000 F and a coolant flow of 3 percent of engine mass flow or less, with an average chordwise temperature limit of 1400 F. Within the range of coolant flows investigated, however, only blade C could maintain a leading-edge temperature of 1400 F for a turbine-inlet temperature of 2000 F.

Calvert, Howard F.

Structural Design and Preliminary Evaluation of a Lightweight, Brazed, Air-Cooled Turbine Rotor Assembly

A lightweight turbine rotor assembly was devised, and components were evaluated in a full-scale jet engine. Thin sheet-metal airfoils were brazed to radial fingers that were an integral part of a number of thin disks composing the turbine rotor. Passages were provided between the disks and in the blades for air cooling. The computed weight of the assembly was 50 percent less than that of a similar turbine of normal construction used in a conventional turbojet engine. Two configurations of sheet-metal test blades simulating the manner of attachment were fabricated and tested in a turbojet engine at rated speed and temperature. After 8-1/2 hours of operation pieces broke loose from the tip sections of the better blades. Severe cracking produced by vibration was determined as the cause of failure. Several methods of overcoming the vibration problem are suggested.

Meyer, Andre J., Jr.