Engineering PapersSearch

Engineering topics

Montgomery, R. C.

Publications and source records attributed to Montgomery, R. C..

At least 19 records

Analytic redundancy management for large flexible structures

An analytic redundancy management approach for on-line component failure detection is described and illustrated using a simulation of the NASA Langley Spacecaft Control Laboratory Experiment (SCOLE) research facility. The SCOLE experimental apparatus simulated is a functional model of the Space Shuttle with a large, flexible, offset-feed antenna cantilevered from the payload bay. This approach uses a single, active, Kalman filter selected from a bank of filters, each element of which was previously designed to accommodate a specific failure condition. The residuals of this active filter are processed through a sequential probability ratio test (SPRT) filter to identify the failure state of the system and, hence, closing the failure accommodation loop, to select the active filter. Results are presented that illustrate the ability of the system to detect and recover from failures introduced in the angular rate and linear acceleration sensors on the SCOLE facility.

Shenhar, J.

Application of optical distributed sensing and computation to control of a large flexible spacecraft

Advances in real-time holography make possible the development of new distributed optical sensors and processors that may have application to the control of flexible structures. This paper presents the analytic evaluation of control system concepts utilizing this new technology on realistic spacecraft. The design of a distributed estimator based on this new optical sensing technique is targeted to vibration control of a complex spacecraft with multiple optical sensors, each of which views a portion of the spacecraft. A simulation of a complex truss structure that was flown in the Solar Array Flight Experiment is utilized to evaluate the performance of the estimator. It is shown that good performance can be obtained from a distributed estimator even in the presence of significant sensor noise.

Montgomery, R. C.

Linear estimation and control studies of vibration suppression of SCOLE flexible mast

A Kalman filter and a controller are presented for vibration suppression of the Spacecraft Control Laboratory Experiment flexible mast mounted in the cantilevered configuration. Mode shapes and frequencies of the structure obtained from a finite element analysis are used to compute the controller and filter gains. The paper presents results and discussion from simulation and experimental studies. Comparison of experimental results with those obtained by simulation show close agreement.

Ghosh, D.

Attitude control system testing on SCOLE

This paper presents implementation of two control policies on SCOLE (Space Control Laboratory Experiment), a laboratory apparatus representing an offset-feed antenna attached to the Space Shuttle by a flexible mast. In the first case, the flexible mast was restrained by cables, permitting modeling of SCOLE as a rigid-body. Starting from an arbitrary state, SCOLE was maneuvered to a specified terminal state using rigid-body minimum-time control law. In the second case, the so called single step optimal control (SSOC) theory is applied to suppress vibrations of the flexible mast mounted as a cantilever beam. Based on the SSOC theory, two parameter optimization algorithms were developed.

Shenhar, J.

LQC control for the Mini-Mast experiment

The Mini-Mast system is briefly reviewed, and results of a simulation study of the LQG control for the Mini-Mast experiment are reported. In particular, attention is given to problems and limitations related to the testing of control laws using reaction mass actuators, such as accounting for force and stroke limits of these devices. The local controller used in the study and the algorithm for converting the force commands of the LQG algorithm to position commands for the reaction mass device are described. It is shown that the LQG generated damping is reduced when a local controller is used and the position command is not saturated; it drops still further when the position command is saturated.

Montgomery, R. C.

Parameter identification for vibration control of SCOLE

A least-squares identification method has been used to derive an empirical model of the vibrational dynamics of the Spacecraft Control Laboratory Experiment, an apparatus for testing parameter identification and control schemes for large flexible space structures. Testing is performed by exciting the structure with torque wheels. Linear least-squares analysis is employed to obtain the parameters that best fit the output of an autoregressive model to the data, and to determine the control effectiveness of the torque wheels using the excitation portion of the test data.

Sparks, D. W., Jr.

Problems associated with reaction mass actuators used in conjunction with LQG control on the Mini-Mast

The work being done at NASA LaRC on developing control laws for the Mini-Mast experimental facility is reviewed with particular attention given to the problems associated with the stroke limit of the reaction mass actuators used in conjunction with the LQG control. An algorithm for converting the force commands of the LQG algorithm into position command for the reaction mass devices is described. It is shown that the position command can be used as an input to a local controller so that the relative position of the reaction mass would track the commanded relative position. The stabilization of the integration scheme makes it possible to avoid the position drift arising in the direct double integration method of converting force commands to position commands.

Ghosh, D.

On-line identification and attitude control for SCOLE

This paper documents on-line linear least-square identification and attitude control of SCOLE, a laboratory apparatus representing an offset-feed antenna attached to the Space Shuttle. Identification is done autonomously by starting a slew maneuver in pitch or roll with reaction jets and observing the time history data of associated Euler angles when the jets are quiescent. Linear least-square analysis is used to select the parameters that best fit the output of an Autoregressive (AR) model to the data. The control effectiveness of the jets is determined in a subsequent test, again using linear least squares. The parameters so derived are used to design switching lines for time-optimal attitude control. This report describes the identification and control algorithms and the experimental apparatus and procedures used. Also, experimental data are presented that reflect the performance of the identification algorithms and the attitude control system.

Montgomery, R. C.

Distributed control for COFS 1

An overview is given of the work being done at NASA LaRC on developing the Control of Flexible Structures (COFS) 1 Flight Experiment Baseline Control Law. This control law currently evolving to a generic control system software package designed to supply many, but not all, guest investigators. A system simulator is also described. It is currently being developed for COFS-1 and will be used to develop the Baseline Control Law and to evaluate guest investigator control schemes. It will be available for use whether or not control schemes fall into the category of the Baseline Control Law. First, the hardware configuration for control experiments is described. This is followed by a description of the simulation software. Open-loop sinusoid excitation time histories are next presented both with and without a local controller for the Linear DC Motor (LDCM) actuators currently planned for the flight. The generic control law follows and algorithm processing requirements are cited for a nominal case of interest. Finally, a closed-loop simulation study is presented, and the state of the work is summarized in the concluding remarks.

Montgomery, R. C.

Control effectiveness characterization for state estimation and control on a highly flexible grid

Control effectiveness tests of reaction wheel actuators on a highly flexible grid are reported herein. Analytic determination of actuator control effectiveness is accomplished with finite element modelling. Experimental determination is done with two algorithms. The first is an equation error parameter identification scheme which estimates the control coefficients of the second order difference equation model of each vibration mode. The second is a least square error algorithm using the same model. For both methods there is a lack of agreement with analytic prediction.

Montgomery, R. C.

Progress in adaptive control of flexible spacecraft using lattice filters

This paper reviews the use of the least square lattice filter in adaptive control systems. Lattice filters have been used primarily in speech and signal processing, but they have utility in adaptive control because of their order-recursive nature. They are especially useful in dealing with structural dynamics systems wherein the order of a controller required to damp a vibration is variable depending on the number of modes significantly excited. Applications are presented for adaptive control of a flexible beam. Also, difficulties in the practical implementation of the lattice filter in adaptive control are discussed.

Sundararajan, N.

Experimental Development of a Failure Detection Scheme for Large Space Structures

Large flexible spacecraft may require control systems consisting of large numbers of sensors and actuators. To assure a viable mission, the control system should tolerate failures of some of the control components. Hence, it is desirable to automate the process of failure detection, identification, and control system reconfiguration (FDI&R). Some of the opportunities to accommodate failure in the spacecraft design are reviewed. Some methods for FDI&R are presented in overview, and the method chosen for experimental testing is described. Finally, the experimental activities leading to the validation of the technique are presented.

Montgomery, R. C.

Experiments in structural dynamics and control using a grid

Future spacecraft are being conceived that are highly flexible and of extreme size. The two features of flexibility and size pose new problems in control system design. Since large scale structures are not testable in ground based facilities, the decision on component placement must be made prior to full-scale tests on the spacecraft. Control law research is directed at solving problems of inadequate modelling knowledge prior to operation required to achieve peak performance. Another crucial problem addressed is accommodating failures in systems with smart components that are physically distributed on highly flexible structures. Parameter adaptive control is a method of promise that provides on-orbit tuning of the control system to improve performance by upgrading the mathematical model of the spacecraft during operation. Two specific questions are answered in this work. They are: What limits does on-line parameter identification with realistic sensors and actuators place on the ultimate achievable performance of a system in the highly flexible environment? Also, how well must the mathematical model used in on-board analytic redundancy be known and what are the reasonable expectations for advanced redundancy management schemes in the highly flexible and distributed component environment?

Montgomery, R. C.

Adaptive identification and control of structural dynamics systems using recursive lattice filters

A new approach for adaptive identification and control of structural dynamic systems by using least squares lattice filters thar are widely used in the signal processing area is presented. Testing procedures for interfacing the lattice filter identification methods and modal control method for stable closed loop adaptive control are presented. The methods are illustrated for a free-free beam and for a complex flexible grid, with the basic control objective being vibration suppression. The approach is validated by using both simulations and experimental facilities available at the Langley Research Center.

Sundararajan, N.

Testing of a failure accommodation system on a highly flexible grid

This paper presents a scheme for on-line failure detection in systems with appreciable structural dynamics. The design is suboptimal because of extensive computational requirements of optimal schemes. To accomplish failure detection, the innovations sequence of a finite order Kalman filter is examined. Because of the heavy dependence of the system on the zero-mean character of the innovations sequence of the filter much attention has been given to the design and evaluation of the Kalman filters used. The filter designs are based on modal models of the structural dynamics. Two modal models were considered, one based on an analytic finite element model and the other based on empirically derived frequency and damping. Experiments using a grid structure are presented which illustrate operation and performance of the filter designs based on these models. The general character of the results presented is that appreciable errors exist in the filter design based on the finite element model. Substantial improvement results if the design model is modified to include empirically derived frequency and damping.

Montgomery, R. C.

Failure detection and accommodation in structural dynamics systems using analytic redundancy

The concept of analytic redundancy is extended to identify nonzero constant output failures in large spacecraft active control sensors and actuators, using a set of distributed sensors which do not nominally produce equivalent signals but are related through the structural dynamics of the system. The suboptimal technique uses a Sequential Probability Ratio Test on the residual sequence of a Kalman filter based on a modal structure model, to determine failure of a component based on an assumed failure hypothesis. The specific failure is identified and then the Kalman filter gains are reconfigured for the identified remaining working sensor set. Experimental data using an apparatus whose dynamics are representative of a large spacecraft show the nominal filter performance under failed and unfailed conditions.

Williams, J. P.