Engineering PapersSearch

Engineering topics

Monford, L.

Publications and source records attributed to Monford, L..

Smaller SPS system sizing tradeoffs

The solar power satellite and associated microwave system was reoptimized with larger antennas (at 2.45 GHz), reduced output powers, and smaller rectennas. Four constraints were considered: (1) the 23 mw/sq cm ionospheric limit; (2) a higher (54 mW/sq cm) ionospheric limit; (3) the 23 KW/sq cm thermal limit in the antenna; and (4) an improved thermal design allowing 33% additional waste heat. The differential costs in electricity for seven antenna/rectenna configurations operating at 2.45 GHz and five satellite systems operating at 5.8 GHz were calculated. It is concluded that a larger antenna/smaller rectenna configurations are economically feasible under certain conditions; a transmit antenna diameters should be limited to 1 to 1.5 Km for 2.45 GHz operation and .75 to 1.0 Km for 5.8 GHz; the present ionospheric limit of 23 mw/sq cm is probably too low and should be raised after ionospheric heating tests and studies are completed; the 5.8 GHz configurations are constrainted by antenna thermal limitations, rather than ionospheric limits; and multiple (two to four) antennas on a single solar satellite are recommended regardless of the particular antenna/rectenna configuration chosen.

Arndt, G. D.

Cost and sizing sensitivities for the solar power satellite

A summary is provided of the characteristics and error parameters of the reference microwave transmission system for the solar power satellite (SPS). The relative importance of electrical and mechanical tolerances upon scattered microwave power and electrical costs is investigated. It is found that small increases in efficiency and/or reduction of losses (less than one percent) can improve the revenue from a single satellite over its 30-year lifetime by several hundred million dollars. Attention is given to a system definition, cost sensitivities for the reference system, the klystron dc-RF conversion efficiency, the transmitting antenna, the rectenna collection efficiency, system sizing tradeoffs, a cost analysis, and multiple antennas.

Monford, L.

Data processing for water monitoring system

Water monitoring data acquisition system is structured about central computer that controls sampling and sensor operation, and analyzes and displays data in real time. Unit is essentially separated into two systems: computer system, and hard wire backup system which may function separately or with computer.

Monford, L.