Engineering topics
Publications and source records attributed to Moeckel, W E.
Charts have been prepared relating the thermodynamic properties of air in chemical equilibrium for temperatures to 15,000 degrees k and for pressures 10(-5) to 10 (plus 4) atmospheres. Also included are charts showing the composition of air, the isentropic exponent, and the speed of sound. These charts are based on thermodynamic data calculated by the National Bureau of Standards.
Previous papers of this conference have described rocket systems capable of launching sizable payloads into satellite orbits. Propulsion systems that might be suitable for the next steps are discussed in this paper. Some of the uses for propulsion systems once satellites have been established are as follows: (1) increasing lifetime of low-altitude satellite, (2) controlling and altering satellite orbits, (3) lunar and interplanetary exploration and (4) auxiliary electric power. (author)
Explore the source record for details and available documents.
Large downstream movements of transition observed when the leading edge of a hollow cylinder or a flat plate is slightly blunted are explained in terms of the reduction in Reynolds number at the outer edge of the boundary layer due to the detached shock wave. The magnitude of this reduction is computed for cones and wedges for Mach numbers to 20. Concurrent changes in outer-edge Mach number and temperature occur in the direction that would increase the stability of the laminar boundary layer. The hypothesis is made that transition Reynolds number is substantially unchanged when a sharp leading edge or tip is blunted. This hypothesis leads to the conclusion that the downstream movement of transition is inversely proportional to the ratio of surface Reynolds number with blunted tip or leading edge to surface Reynolds number with sharp tip or leading edge. The conclusion is in good agreement with the hollow-cylinder result at Mach 3.1.
Explore the source record for details and available documents.
The effects of lip thickness on inlet performance are estimated as functions of mass flow for subsonic and supersonic flight speeds. At subsonic speeds, pressure-recovery losses and additive drag are shown to decrease linearly with increasing lip frontal area if the maximum suction force is attained. At supersonic speeds, inlet drag increases linearly with inlet lip frontal area at full mass flow. For reduced mass flow, some reduction in additive drag is possible with lips of moderate thickness, but the magnitude of this reduction becomes negligible as flight speed increases.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Use of flow separation on a rod projecting upstream of a blunt body to decelerate the supersonic stream ahead of an annular nose inlet was investigated at Mach numbers of 1.76, 1.93, and 2.10. Maximum pressure recoveries were obtained with rod tip projections about 1.5 times the radius of the spherical nose and were higher than those obtained with single-shock solid cones. Subcritical operation was similar to that observed with solid-cone inlets, but the effect of angle of attack on maximum pressure recovery was more severe.
The pressure distribution and drag were determined for a spherical-nosed axially symmetric body with thin projecting rods at Mach numbers of 1.76, 1.93, and 2.10. The upstream projection distance of the rods was varied over a wide range to study changes in the character of the flow separation and to determine the variation of drag and pressure distribution with tip projection. Drag coefficients between 0.18 and 0.30 were obtained for most tip projections at each Mach number.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.