Engineering Papers⌕ Search

Engineering topics

Mixson, J. S.

Publications and source records attributed to Mixson, J. S..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Consideration of some factors affecting low-frequency fuselage noise transmission for propeller aircraft

Possible reasons for disagreement between measured and predicted trends of sidewall noise transmission at low frequency are investigated using simplified analysis methods. An analytical model combining incident plane acoustic waves with an infinite flat panel is used to study the effects of sound incidence angle, plate structural properties, frequency, absorption, and the difference between noise reduction and transmission loss. Analysis shows that these factors have significant effects on noise transmission but they do not account for the differences between measured and predicted trends at low frequencies. An analytical model combining an infinite flat plate with a normally incident acoustic wave having exponentially decaying magnitude along one coordinate is used to study the effect of a localized source distribution such as is associated with propeller noise. Results show that the localization brings the predicted low-frequency trend of noise transmission into better agreement with measured propeller results. This effect is independent of low-frequency stiffness effects that have been previously reported to be associated with boundary conditions.

Mixson, J. S.↗
NASA NTRS1986

Laboratory study of the effects of sidewall treatment, source directivity and temperature on the interior noise of a light aircraft fuselage

This paper describes a laboratory study of add-on {coustic treatments for a twin-engine, propeller-driven aircraft fuselage. The sound source was a pneumatic-driver, with attached horn to simulate propeller noise distribution, powered by a white noise signal. Treatments included a double-wall, production-line treatment and various fiberglass and lead-vinyl treatments. Insertion losses, space-averaged across six interior microphone positions, were used to evaluate the treatments. In addition, the effects of sound source angle and ambient temperature on interior sound pressure level are presented. The sound source angle is shown to have a significant effect on one-third octave band localized sound pressure level. While changes in ambient temperature are shown to have little effect on one-third octave band localized sound pressure level, the change in narrowband localized sound pressure level may be dramatic.

Heitman, K. E.↗
NASA NTRS1985

Flight investigation of cabin noise control treatments for a light turboprop aircraft

The in-flight evaluation of noise control treatments for a light, twin-engined turboprop aircraft presents several problems associated with data analysis and interpretation. These problems include data repeatability, propeller synchronization, spatial distributions of the exterior pressure field and acoustic treatment, and the presence of flanking paths. They are discussed here with regard to a specific aeroplane configuration. Measurements were made in an untreated cabin and in a cabin fitted with an experimental sidewall treatment. Results are presented in terms of the insertion loss provided by the treatment and comparison made with predictions based on laboratory measurements.

Wilby, J. F.↗
NASA NTRS1985

Review of research on structureborne noise

Publications on the topic of structureborne noise are reviewed. Recent accomplishments, including representative results, are presented for aircraft, rotorcraft, space structures, automotive vehicles, ship and building technology. Special attention is given to propeller-driven aircraft. This review demonstrates that substantial progress has been made in understanding the characteristics of structureborne noise. Possible future research efforts and development of technology for control of structureborne noise are discussed.

Vaicaitis, R.↗
NASA NTRS1984

Theoretical design of acoustic treatment for cabin noise control of a light aircraft

An analytical procedure has been used to design an acoustic treatment for cabin noise control of a light aircraft. Using this approach acoustic add-on treatments capable of reducing the average noise levels in the cabin by about 17 dB from the untreated condition are developed. The added weight of the noise control package is about 2 percent of the total gross take-off weight of the aircraft. The analytical model uses modal solutions wherein the structural modes of the sidewall and the acoustic modes of the receiving space are accounted for. The additional noise losses due to add-on treatments are calculated by the impedance transfer method. The input noise spectral levels are selected utilizing experimental flight data. The add-on treatments considered for cabin noise control include aluminum honeycomb panels, constrained layer damping tape, porous acoustic materials, noise barriers and limp trim panels. To reduce the noise transmitted through the double wall aircraft windows to acceptable levels, changes in the design of the aircraft window are recommended.

Vaicaitis, R.↗
NASA NTRS1984

Noise transmission through an acoustically treated and honeycomb stiffened aircraft sidewall

The noise transmission characteristics of test panels and acoustic treatments representative of an aircraft sidewall are experimentally investigated in the NASA Langley Research Center transmission loss apparatus. The test panels were built to represent a segment sidewall in the propeller plane of a twin-engine, turboprop light aircraft. It is shown that an advanced treatment, which uses honeycomb for structural stiffening of skin panels, has better noise transmission loss characteristics than a conventional treatment. An alternative treatment, using the concept of limp mass and vibration isolation, provides more transmission loss than the advanced treatment for the same total surface mass. Effects on transmission loss of a variety of acoustic treatment materials (acoustic blankets, septa, damping tape, and trim panels) are presented. Damping tape does not provide additional benefit when the other treatment provides a high level of damping. Window units representative of aircraft installations are shown to have low transmission loss relative to a completely treated sidewall.

Grosveld, F. W.↗
NASA NTRS1984

Laboratory tests on an aircraft fuselage to determine the insertion loss of various acoustic add-on treatments

This paper describes a laboratory study of add-on acoustic treatments for a propeller-driven light aircraft fuselage. The treatments included: no treatment (i.e., baseline fuselage); a production-type double-wall interior; and various amounts of high density fiberglass added to the baseline fuselage. The sound source was a pneumatic-driver with attached exponential horn, supplied with a broadband signal. Data were acquired at the approximate head positions of the six passenger seats. The results were analyzed on space-averaged narrowband, one-third octave band and overall insertion loss basis. In addition, insertion loss results for the different configurations at specific frequencies representing propeller tone spectra are presented. The propeller tone data includes not only the space-averaged insertion loss, but also the variation of insertion loss at these particular frequencies across the six microphone positions.

Heitman, K. E.↗
NASA NTRS1984

Review of recent research of interior noise of propeller aircraft

Publications on the topics of propeller source noise, airborne noise transmission, and passenger comfort response to noise and vibration are reviewed. Of the 187 publications referenced, 140 have appeared since 1978. Examples of research accomplishments are presented to illustrate the state of the art. Emphasis is on comparisons of theoretical and measured results, but the description of the theories is left to the references. This review shows that substantial progress has been made in understanding the characteristics of propeller noise, airborne noise, and passenger response, and in the development of prediction methods. Application of the technology to cabin noise control and possible future research directions are discussed.

Mixson, J. S.↗
NASA NTRS1984

Investigation of fuselage acoustic treatment for a twin-engine turboprop aircraft in flight and laboratory tests

A flight and laboratory study of sidewall acoustic treatment for cabin noise control is described. In flight, cabin noise levels were measured at six locations with three treatment configurations. Noise levels from narrow-band analysis are reduced to one-third octave format and used to calculate insertion loss, IL, defined as the reduction of interior noise associated with the addition of a treatment. Laboratory tests used a specially constructed structural panel modeled after the propeller plane section of the aircraft sidewall, and acoustic treatments representing those used in flight. Lab measured transmission loss and absorption values were combined using classical acoustic procedures to obtain a prediction of IL. Comparison with IL values measured in flight for the boundary layer component of the noise indicated general agreement.

Mixson, J. S.↗
NASA NTRS1984

Noise transmission through aircraft panels

This paper describes analytical and experimental studies of noise transmission through aircraft panels. The theoretical solutions of the governing acoustic-structural equations are developed utilizing modal decomposition and a Galerkin-type procedure. Single, discretely stiffened, and double wall panels are considered. Theoretical predictions are compared with experimental measurements and differences are identified.

Vaicaitis, R.↗
NASA NTRS1982

Interior noise considerations for advanced high-speed turboprop aircraft

This paper describes recent research on noise generated by high-speed propellers, on noise transmission through acoustically treated aircraft sidewalls and on subjective response to simulated turboprop noise. Propeller noise discussion focuses on theoretical prediction methods for complex blade shapes designed for low noise at Mach = 0.8 flight and on comparisons with experimental test results. Noise transmission experiments using a 168 cm. diameter aircraft fuselage model and scaled heavy-double-wall treatments indicate that the treatments perform well and that the predictions are usually conservative. Studies of subjective comfort response in an anechoic environment are described for noise signatures having combinations of broadband and propeller-type tone components.

Mixson, J. S.↗