Engineering topics

Mineck, R. E.

Publications and source records attributed to Mineck, R. E..

23 records · Page 2

NASA NTRS1974

Wind tunnel investigation of a simulated gunship helicopter engine-exhaust-windstream interaction

A wind tunnel investigation of the engine exhaust and windstream flow interaction on a gunship helicopter model was conducted in the Langley V/STOL tunnel. The investigation utilized a flow visualization technique employing neutrally buoyant helium filled bubbles to determine the cause of exhaust shield overheating during cruising flight and to evaluate means of eliminating the problem. The flow patterns were recorded with still cameras and on television magnetic tape. Exhaust flow impingement on the exhaust shield during cruise was found to cause the problem. Several flow altering devices were evaluated to find suitable ways to correct the problem. A flow deflector located on the model cowling upstream of the exhaust provides an effective solution.

Wilson, J. C.↗

NASA NTRS1974

Effect of ground proximity on the longitudinal aerodynamic characteristics of an aspect-ratio-1 wing with and without wing-tip blowing

An investigation has been conducted to determine the effect of ground proximity on the aerodynamic characteristics of an aspect-ratio-1 wing with and without wing-tip blowing. This investigation was conducted in the Langley towing tank no. 1 with the model towed over the water to eliminate the effects of walls and of wind-tunnel ground-board boundary layers. The results indicate that the model is stable with height and pitch at positive angles of attack and that the lift-drag ratio is improved at small ground heights with some blowing at the wing tips.

Mineck, R. E.↗

NASA NTRS1974

Pressure distribution on a vectored-thrust V/STOL fighter in the transition-speed range

A wind-tunnel investigation has been conducted in the Langley V/STOL tunnel with a vectored-thrust V/STOL fighter configuration to obtain detailed pressure measurements on the body and on the wing in the transition-speed range. The vectored-thrust jet exhaust induced a region of negative pressure coefficients on the lower surface of the wing and on the bottom of the fuselage. The location of the jet exhaust relative to the wing was a major factor in determining the extent of the region of negative pressure coefficients.

Mineck, R. E.↗

NASA NTRS1974

Wind tunnel investigation of helicopter rotor wake effects on three helicopter fuselage models

The effects of rotor downwash on helicopter fuselage aerodynamic characteristics were investigated. A rotor model for generating the downwash was mounted close to each of three fuselage models. The main report presents the force and moment data in both graphical and tabular form and the pressure data in graphical form. This supplement presents the pressure data in tabular form. Each run or parameter sweep is identified by a unique run number. The data points in each run are identified by a point number. The pressure data can be matched to the force data by matching the run and point number.

Wilson, J. C.↗

NASA NTRS1973

Aerodynamic characteristics of a vectored-thrust V/STOL fighter in the transition speed range

A wind-tunnel investigation was conducted with a vectored-thrust V/STOL fighter configuration. The model was equipped with two nacelle-mounted vectored-thrust jet simulators and one lift-jet simulator. The vectored-thrust jet could be tested at two alternate longitudinal positions and three nozzle deflection angles. The vectored-thrust configuration with the rear nozzles showed an increase in lift and a decrease in pitching moment when compared with the forward nozzles. The rear nozzles also improve stall characteristics.

Mineck, R. E.↗