Engineering topics

Minahan, J. A.

Publications and source records attributed to Minahan, J. A..

3 records

NASA NTRS1981

Silicon solar cell process development, fabrication and analysis

The fabrication of solar cells from several unconventional silicon materials is described, and cell performance measured and analyzed. Unconventional materials evaluated are edge defined film fed grown (EFG), heat exchanger method (HEM), dendritic web grown, and continuous CZ silicons. Resistivity, current voltage, and spectral sensitivity of the cells were measured. Current voltage was measured under AM0 and AM1 conditions. Maximum conversion efficiencies of cells fabricated from these and other unconventional silicons were compared and test results analyzed. The HEM and continuous CZ silicon were found to be superior to silicon materials considered previously.

Minahan, J. A.↗

NASA NTRS1981

Solar cells fabricated with unconventional silicon materials

Solar cells have been fabricated using silicon materials supplied in the DOE/JPL Large Solar Array program. Each of the silicon materials studied in this program was produced in a unique manner and with intent of producing silicon in a grade and form that would offer the possibility of economic deployment in photovoltaic arrays for generation of electricity. This report will attempt to provide an overview of the results for some of the materials and highlight in particular results obtained for solar cells fabricated from the advanced CZ silicon. Emphasis will be given to consideration of the purity of virgin silicon material used in the heat exchange method.

Minahan, J. A.↗

NASA NTRS1979

Silicon Solar Cell Process Development, Fabrication and Analysis

Solar cells were constructed from polycrystalline silicon sheet material (10 cm x 10 cm). These cells were made using conventional aerospace methods and serve as the so-called baseline cell for analysis and comparison with cells to be made from similar material, but using optimized processing techniques. Before and during the processing of the baseline cells in a cleaned diffusion tube, control cells were built using the baseline method. All cells were measured on a solar simulator at air mass zero and 28 C. Average efficiency for the baseline cells was 9.5%. Efficiency was found to vary with location in the sheet. Center regions had higher efficiencies whereas corner and edge regions had lower efficiencies. In general, the efficiency falls off with distance from the center of the sheet.

Minahan, J. A.↗