Transitioning the NASA SLR Network to Event Timing Mode for Reduced Systematics, Improved Stability and Data Precision
NASA's legacy Satellite Laser Ranging (SLR) network produces about one-third of the global SLR data to support spacegeodesy. This network of globally distributed stations has been using Time Interval Units (TIU) for range measurements for thelast 25 + years. To improve the reliability of the SLR network and satisfy the need for stable millimeter precision data, a phasedreplacement of the TIUs in the network with picosecond-precise Event Timer Modules was initiated in 2015. This schemeallowed the time of flight and laser transmit epoch measurement to one picosecond resolution. For a network with globalscientific impact, transitioning to a new data generation metrological scheme requires significant data scrutiny and long-termscience data validation. Any long-term testing/measurement has the potential to interrupt the station's daily operational dataflow to the International Laser Ranging Service (ILRS) as the station under test will have to put its test data into quarantine.We have demonstrated a very effective way to test and implement the new device without removing the old hardware andwithout the need for the orbit analysis. This operationally noninvasive scheme performed concurrent test measurements enablinguninterrupted operational data flow to the users, while allowing simultaneous test data capture for short- and long-termsystematics and stability analysis. Extensive analysis of the test data was performed by the NASA SLR engineering team andthe ILRS Analysis Standing Committee, to uncover biases and any dependencies on the satellite ranges (for nonlinear scaleissues). Multi-ETM comparison was also performed at two of the SLR stations through the interchange of hardware to establishthe inter-device range biases and stability. Such benchmarked hardware was subsequently sent to the remaining stationsto allow traceability and normalize the network performance. The range bias intercomparison performed using the multiyearSLR data analysis agreed well with the engineering changes, thus validating the approach to flush out station-specific rangingsystematics affecting precise orbit determination. Such an improvement and rebalancing of the current network will allowan orderly transition of the current NASA SLR network operating at a maximum rate of 10 Hz to the NASA next generationSpace Geodesy Satellite Laser Ranging (SGSLR) network operating at 2 kHz (McGarry et al. in J Geod, 2018. https ://doi.org/10.1007/s0019 0-018-1191-6; Merkowitz et al. in J Geod, 2018. https ://doi.org/10.1007/s0019 0-018-1204-5).