Engineering Papers⌕ Search

Engineering topics

Melfi, S. H.

Publications and source records attributed to Melfi, S. H..

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Lower atmospheric temperature profile measurements using a Raman lidar

A Raman lidar system was used to measure the temperature profile of the upper troposphere and lower stratosphere. The system consists of a tripled Nd-YAG laser and a 1.5 meter diameter telescope. Two photomultipliers are used at the output of the telescope to allow for measurements at both the laser wavelength and at the Raman shifted wavelength due to atmospheric nitrogen. The signal from the photomultipliers is recorded as photon counts in 1 microsec bins. The results of a number of laser shots are summed together to provide atmospheric returns which have acceptable signal to noise characteristics. Measurements of the Raman nitrogen return were acquired up to an altitude in excess of 20 km. Temperature profiles were retrieved from the attenuation corrected Raman nitrogen return assuming the atmosphere to be in hydrostatic equilibrium and using the ideal gas law. Retrieved temperature profiles are shown compared with independent temperature measurements.

Melfi, S. H.↗
NASA NTRS1986

Lidar observations and modeling of cold air outbreaks during MASEX and GALE

As part of MASEX and GALE a number of research flights were carried out over the Marine Boundary Layer (MBL) during periods when extremely cold and dry continental air was flowing out over the warm coastal waters at the east coast of the U.S. Such periods, which are named cold air outbreaks are characterized by massive warming and moistening of the MBL resulting in rapid entrainment conditions. As the MBL deepens as a function of fetch over the ocean, clouds develop. The line of cloud formation typically follows the coast line closely as has been observed many times from satellite imagery. The backscatter data from the NASA Goddard airborne lidar, which was used to measure the depth of the MBL in great detail, is ideally suited to verify parametrized models of boundary layer growth rate. The data indicates that the deepening MBL gradually develops clouds at its top. Those clouds form an integral part of the MBL and exercise an important influence on the energy cycle within the MBL. It is suggested that the rapid entrainment observed during overcast conditions represent an increase in efficiency of conversion of available turbulence kinetic energy into entrainment energy.

Boers, R.↗
NASA NTRS1985

Observation of lower-atmospheric moisture structure and its evolution using a Raman lidar

Observations of the water-vapor mixing ratio in the lower atmosphere and its temporal evolution have been made with a Raman lidar. Comparison with an independent radiosonde measurement indicated excellent agreement. The moisture structure, observed up to an altitude of 5 km and over an 80-min period during the early morning of April 30, 1985 (the present lidar is limited to night operation), showed temporal variations of several atmospheric features which could not be resolved by balloon soundings. Application of the lidar should provide the opportunity to study details of atmospheric moisture, its structure, and its evolution in a manner never before realized.

Melfi, S. H.↗
NASA NTRS1985

Lidar observations of vertically organized convection in the planetary boundary layer over the ocean

Observations of a convective planetary boundary layer (PBL) were made with an airborne, downward-looking lidar system over the Atlantic Ocean during a cold air outbreak. The lidar data revealed well-organized, regularly spaced cellular convection with dominant spacial scales between two and four times the height of the boundary layer. It is demonstrated that the lidar can accurately measure the structure of the PBL with high vertical and horizontal resolution. Parameters important for PBL modeling such as entrainment zone thickness, entrainment rate, PBL height and relative heat flux can be inferred from the lidar data. It is suggested that wind shear at the PBL top may influence both entrainment and convective cell size.

Melfi, S. H.↗
NASA NTRS1985

Lidar observations of the planetary boundary layer

The application of an airborne downward-looking lidar to the study of organized cellular convection in the planetary boundary layer (PBL) over the ocean is described. The lidar consisted of a frequency doubled Nd-YAG 530 mm-wavelength laser whose axis was aligned colinearly with the optical axis of an all-reflecting 40 mm-diameter Newtonian telescope. The airborne lidar provided a unique observation of both microscale and mesoscale variations of the PBL top. The lidar data, presented as constant backscatter isopleth soundings, provide a visual indication of the presence of vertically organized convection cells. Comparisons of the lidar-derived PBL structure with both a conceptual model of the PBL and laboratory simulations of Deardorf et al. (1980) of a developing convective PBL showed that the observations are consistent with a model of mixing in the PBL, which involves a field of organized updrafts separated by downdrafts.

Melfi, S. H.↗
NASA NTRS1974

Dustsonde and lidar measurements of stratospheric aerosols - A comparison

Comparison of lidar and in situ measurements of stratospheric aerosol profiles obtained by backscattered ruby laser light and by direct in situ sampling over Laramie, Wyoming, on two nights in mid-September 1972. The lidar backscattering and the particle number density profiles correlated well. Based on these initial comparative experiments, the ground-based lidar coupled with temperature soundings appears to be a possible method for determining the relative aerosol profile under given stratospheric loading conditions.

Northam, G. B.↗
NASA NTRS1973

Comparison of Lidar and In-Situ Measurements of Stratospheric Aerosols

This paper will present the results of a comparative study conducted in Laramie, Wyoming, during the summer and fall of 1972, as part of the Department of Transportation's Climatic Impact Assessment Program (ClAP). The study included independent, and nearly simultaneous, measurements of stratospheric aerosols using a LIDAR system and a balloon-borne in-situ particle counter. The LIDAR provides a remote measurement of volume backscatter (aerosols and molecules) in a narrow wavelength region centered at the ruby wavelength (6943R); whereas the balloon-borne in-situ counter measures aerosol concentration by counting aerosols greater than approx. 0.30 microns in diameter as they are pumped through a chamber and scatter white light forward into photo-detectors. The comparison of measurements that will be discussed using the two techniques involves formulating the LIDAR data so that it is compatible with the counter data. The formulation includes separation of the scattering due to aerosols from the total and displaying this in terms of aerosol scattering function. Aerosol scattering function is proportional to aerosol concentration if the aerosol parameters, such as size distribution and composition, are constant with altitude. In separating the aerosol scattering from the total, the need for real atmospheric number density over the Standard Atmosphere is also discussed.

Melfi, S. H.↗
NASA NTRS1973

Lidar Observations of Raman Scattering from S02 in a Power Plant Stack Plume

LIDAR techniques have been successfully applied to the detection of the Raman backscatter from S02 in the plume of a 200 megawatt coal-burning electrical- generating plant from a distance of 210 meters. The LIDAR system used consists of a 61-centimeter-diameter, f /4 Newtonian telescope and a 1.0-1.5-joules per pulse, 1-pulse-per-second ruby laser. Narrow band interference filters are used to select the 7546-angstrom v (sub 1) vibrational line of S02. The signal from a photomultiplier tube was sequentially applied to each 254-nanosecond-wide channel of a 15-cihannel photon counting system, resulting in a direct correlation between channel number and range increment. Photon counts were accumulated from the backscatter of a number of laser pulses (typically 50 or 100), and the accumulated counts per channel printed on paper tape. One sequence of measurements was made during a two-hour period while the plant electrical output was being reduced by approximately 50 percent. Although the Raman system had not been quantitatively calibrated, the LIDAR data correlated well with the varying plant electrical output. N2 scattering observations were also made and an approximate quantitative S02 concentration obtained by ratioing the S02 data to N2 data. This ratio compared well to the in-situ measurements made during the same period by Environmental Protection Agency sampling instruments.

Brumfield, M. L.↗
NASA NTRS1973

Remote monitoring of the atmosphere with Raman LIDAR

Some of the Raman LIDAR applications for monitoring the atmosphere are reviewed. Following a definition of Raman scattering, the basic design of a Raman LIDAR system is described and the atmosphere-monitoring potentialities and limitations of the system are discussed, along with the possibilities of further progress.

Melfi, S. H.↗
NASA NTRS1973

Standard methods for analysis and interpretation of Lidar data for environmental monitoring

Lidar is similar in principle to microwave radar but uses a pulsed laser as the source and an optical telescope as the receiver. Lidar observations of elastic scattering from aerosols and more recently Raman scattering from molecules have been performed in the atmosphere with favorable results. A description of the Lidar technique is provided. Lidar measurements of remote visibility are discussed together with the measurement of remote visibility and the determination of molecular concentrations.

Melfi, S. H.↗
NASA NTRS1972

Mixing-height measurement by lidar, particle counter, and rawinsonde in the Williamette Valley, Oregon

The feasibility of using laser radar (lidar) to measure the spatial distribution of aerosols and water vapor in the earth's mixing or boundary layer is shown. From these data the important parameter of actual mixing height was determined, that is, the maximum height to which particulate pollutants actually mix. Data are shown for simultaneous lidar, rawinsonde, and aircraft-mounted condensation nuclei counter and temperature measurements. The synoptic meteorology is also presented. The Williamette Valley, Oregon, was chosen for the measurements because of its unique combination of meteorology, terrain, and pollutant source, along with an ongoing Oregon State University study of the natural ventilation of this valley.

Mccormick, M. P.↗
NASA NTRS1972

Remote measurements of the atmosphere using Raman scattering.

Raman optical radar measurements of the atmosphere demonstrate that the technique may be used to obtain quantitative measurements of the spatial distribution of individual atmospheric molecular trace constituents (in particular water vapor) and of the major constituents. It is shown that monitoring Raman signals from atmospheric nitrogen aids in interpreting elastic scattering measurements by eliminating attenuation effects. In general, the experimental results show good agreement with independent meteorological measurements. Finally, experimental data are utilized to estimate the Raman backscatter cross section for water vapor excited at 3471.5 A.

Melfi, S. H.↗