Engineering Papers⌕ Search

Engineering topics

Meissner, H.

Publications and source records attributed to Meissner, H..

9 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Treatment of CELSS and PCELSS waste to produce nutrients for plant growth

The research program entitled 'Development of a Prototype Experiment for Treating CELSS (Controlled Ecological Life Support Systems) and PCELSS (Partially Controlled Ecological Life Support Systems) Wastes to Produce Nutrients for Plant Growth' consists of two phases: (1) the development of the neccessary facilities, chemical methodologies and models for meaningful experimentation, and (2) the application of what methods and devices are developed to the interfacing of waste oxidation with plant growth. Homogeneous samples of freeze-dried human feces and urine have been prepared to ensure comparability of test results between CELSS waste treatment research groups. A model of PCELSS food processing wastes has been developed, and an automated gas chromatographic system to analyze oxidizer effluents was designed and brought to operational status. Attention is given the component configuration of the wet oxidation system used by the studies.

Modell, M.↗
NASA NTRS1974

The SNS Josephson junction with a third terminal

Discussion of the operating characteristics of a three-terminal thin-film SNS Josephson junction whose diameter is much greater than the electron pair coherence length in the N metal. It is shown that a junction of this type is essentially a two-terminal device even though the third terminal of the junction supplies the control current. The mechanism underlying this finding is discussed.

Prans, G. P.↗
NASA NTRS1973

An investigation of the SNS Josephson junction as a three-terminal device

A particular phenomenon of the SNS Josephson junction was investigated; i.e., control by a current entering the normal region and leaving through one of the superconducting regions. The effect of the control current on the junction was found to be dependent upon the ration of the resistances of the two halves of the N layer. A low frequency, lumped, nonlinear model was proposed to describe the electrical characteristics of the device, and a method was developed to plot the dynamic junction resistance as a function of junction current. The effective thermal noise temperature of the sample was determined. Small signal linearized analysis of the device suggests its use as an impedance transformer, although geometric limitations must be overcome. Linear approximation indicates that it is reciprocal and no power gain is possible. It is felt that, with suitable metallurgical and geometrical improvements, the device has promise to become a superconducting transistor.

Meissner, H.↗
NASA NTRS1972

Proximity effect between superconductivity and normal metals

The SNS junctions were limited to having gold (n) layers of less than 3000 A in order to avoid having the tin (S) films become normal under the influence of the signal current in the gold. The gold layer was alloyed with 10 wt% copper to shorten its electronic mean free path, increasing the tin layer critical current while decreasing the Josephson critical current. It was also found that a previously reported anomalous voltage shift in the presence of I2 is caused by the tin being driven normal. After deposition, the samples were transferred to a conventional cryostat to provide better thermal contact to the films. This reduction of heating in the films produced more linear I-V characteristics and a change in the constant voltage current gain. In order to achieve power gain the SNS device must be operated at lower temperatures were the effects of fluctuations are less and be constructed such that the input resistance is much reduced and the dynamic output resistance increased. A geometry is proposed using a more sophisticated evaporator.

Meissner, H.↗
NASA NTRS1971

Proximity effect between superconducting and normal metals

Electrical characteristics of thin films of tin vapor deposited on gold substrates are described. Favorable characteristics of these films include: (1) shiny and smooth finishes; (2) higher Josephson critical currents; (3) smaller electronic mean paths; and (4) consistent current-voltage curve shapes. One unfavorable characteristic is a much steeper increase of the Josephson critical current with decreasing temperature. The functional variation of the Josephson current with the control current is described. Two functional forms have been observed and a brief description as to possible mechanisms for this behavior have been included.

Meissner, H.↗
NASA NTRS1970

Superconducting ''transistor'' acts as high-speed switch

Cryogenic, three-terminal device yields current-voltage characteristics of ordinary transistor. Device consists of two superconducting tin rods in a crossed-wire geometry, separated by a thin gold film. New construction technique is described and possible applications are discussed.

Meissner, H.↗