Rapid Lightweight Firmware Architecture of the Mobile Metamaterial Internal Co-Integrator Robot
Explore the source record for details and available documents.
Damiana Catanoso↗
Engineering topics
Megan Ochalek
Publications and source records attributed to Megan Ochalek.
Geometry Systems for Lattice-Based Reconfigurable Space Structures
We describe analytic methods for the design of the discrete elements of ultralight lattice structures. This modular building block strategy allows for relatively simple element manufacturing as well as relatively simple robotic assembly of low mass-density structures on orbit, with potential for disassembly and reassembly into highly varying and large structures. This method also results in a structure that is easily navigable by relatively small, mobile robots. The geometry of the cell can allow for high packing efficiency to minimize wasted payload volume while maximizing structural performance and constructability. We describe the effect of geometry choices on the mechanical properties and automated robotic constructability of a final system. Geometric properties considered include number of attachments per voxel, number of attachments per coefficient of volume, and effects of vertex, edge, and face connectivity of the unit cell. Mechanical properties considered include strength scaling, modulus scaling, and packing efficiency of the lattice. Automated constructibility metrics include volume allowance for an end-effector, strut clearance angle for an end-effector, and packing efficiency. These metrics were applied to six lattice unit cell geometries: cube, cuboctahedron, octahedron, octet, rhombic dodecahedron, and truncated octahedron. A case study is presented to determine the most suitable lattice system for a specific set of strength and modulus scaling requirements while optimizing for ease of robotic assembly.
digital materials↗
Rapid Lightweight Firmware Architecture of the Mobile Metamaterial Internal Co-Integrator Robot
The Mobile Metamaterial Internal Co-Integrator (MMIC-I) is a structure assembly and servicing robot for in-space servicing, assembly, and manufacturing of primary structures and infrastructure. MMIC-I is a battery-powered crawling robot that can travel through periodic structures such as trusses and open framework mechanical metamaterials. It does this through sequences of component extension, contraction, and gripping. This paper provides a detailed discussion of MMIC-I’s lightweight and rapidly developed firmware architecture, to enable demonstration of robot locomotion, secondary operations, and communications with a central command source. The rationale for the lightweight rapid development approach is to allow for assessment of long term system requirements in parallel with the mechatronics development, including optimization of system and subsystem power densities, to inform a future choice of flight ready software frameworks. MMIC-I system computing and I/O requirements are much lower than what is provided by proven baseline computing hardware for existing flight ready software frameworks such as the core Flight System, F prime, and the Robot Operating System. Development of earth gravity ground demonstration of the robotic systems is greatly benefited by limited power and mass factors for computing hardware. Here, we implement inter-process communication, commanding, and telemetry with the Espressif ESP32 module running the Arduino OS.
Damiana Catanoso↗
SOLL-E: A Module Transport and Placement Robot for Autonomous Assembly of Discrete Lattice Structures
This paper presents the design and development of a transport and placement robot that demonstrates autonomous assembly of structural building blocks. The robots are intended to serve as a critical component of automated structural assembly and maintenance systems. The Scaling Omni-directional Lattice Locomoting Explorer (SOLL-E) uses a 5-DoF bipedal inchworm locomotion architecture with locking foot and cargo grippers. The locomotion system employs large magnet gap diameter BLDC motors with moderate timing belt gearing for primary joints, and DC planetary gearmotors for turning. Foot and cargo grippers are identical, with servo-actuated locking mechanisms. Three modular controller boards are used to control these actuators in real-time, with command and telemetry data transferred between the server and each controller board via WiFi. Functionality and performance were evaluated in a ground demonstration.
robotics↗