Engineering Papers⌕ Search

Engineering topics

Mcmillan, O. J.

Publications and source records attributed to Mcmillan, O. J..

17 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

A study of prediction methods for the high angle-of-attack aerodynamics of straight wings and fighter aircraft

Work is described dealing with two areas which are dominated by the nonlinear effects of vortex flows. The first area concerns the stall/spin characteristics of a general aviation wing with a modified leading edge. The second area concerns the high-angle-of-attack characteristics of high performance military aircraft. For each area, the governing phenomena are described as identified with the aid of existing experimental data. Existing analytical methods are reviewed, and the most promising method for each area used to perform some preliminary calculations. Based on these results, the strengths and weaknesses of the methods are defined, and research programs recommended to improve the methods as a result of better understanding of the flow mechanisms involved.

Mcmillan, O. J.↗
NASA NTRS1982

Mean-flow measurements of the flow field diffusing bend

Time-average measurements of the low-speed turbulent flow in a diffusing bend are presented. The experimental geometry consists of parallel top and bottom walls and curved diverging side walls. The turning of the center line of this channel is 40 deg, the area ratio is 1.5 and the ratios of height and center-line length to throat width are 1.5 and 3, respectively. The diffusing bend is preceded and followed by straight constant area sections. The inlet boundary layers on the parallel walls are artificially thickened and occupy about 30% of the channel height; those on the side walls develop naturally and are about half as thick. The free-stream speed at the inlet was approximately 30 m/sec for all the measurements. Inlet boundary layer mean velocity and turbulence intensity profiles are presented, as are data for wall static pressures, and at six cross sections, surveys of the velocity-vector and static-pressure fields. The dominant feature of the flow field is a pair of counter-rotating streamwise vortices formed by the cross-stream pressure gradient in the bend on which an overall deceleration is superimposed.

Mcmillan, O. J.↗
NASA NTRS1981

An implicit method for the calculation of inlet flow fields

Inlet flow fields are calculated by an implicit, time marching procedure to solve the thin layer Navier-Stokes equations formulated in body fitted coordinates. Because the method can be used for a flow field with both subsonic and supersonic regions, it is applicable to subcritical as well as supercritical inlet operation. Results are presented and discussed for an inlet of current design practice. Results include inviscid calculations performed for supercritical inlet operation with uniform and nonuniform inflow boundary conditions as well as for subcritical inlet operation with uniform inflow boundary conditions. Results for viscous calculations performed for supercritical inlet operation with uniform inflow boundary conditions are also discussed.

Biringen, S.↗
NASA NTRS1981

Calculation of two-dimensional inlet flow fields by an implicit method including viscous effects: User's manual

Inlet flow fields for airbreathing missiles are calculated by the adaptation of a two dimensional computational method developed for the flow around airfoils. A supersonic free stream is assumed to allow the forebody calculation to be uncoupled from the inlet calculation. The inlet calculation employs an implicit, time marching finite difference procedure to solve the thin layer Navier-Stokes equations formulated in body fitted coordinates. The mathematical formulation of the problem and the solution algorithm are given. Numerical stability and accuracy as well as the initial and boundary conditions used are discussed. Instructions for program use and operation along with the overall program logic are also given.

Biringen, S.↗
NASA NTRS1981

A numerical simulation of two-dimensional inlet flow fields

Inlet flow fields for airbreathing missiles are calculated by the adaptation of a two-dimensional computational method developed for the flow around airfoils. A supersonic free stream is assumed to allow the forebody calculation to be uncoupled from the inlet calculation. The inlet calculation employs an implicit, time-marching finite-difference procedure to solve the thin-layer Navier-Stokes equations formulated in body-fitted coordinates. Because the method can be used for a flow field with both subsonic and supersonic regions, it is applicable to subcritical as well as supercritical inlet operation.

Biringen, S.↗
NASA NTRS1980

Data base for the prediction of inlet external drag

Results are presented from a study to define and evaluate the data base for predicting an airframe/propulsion system interference effect shown to be of considerable importance, inlet external drag. The study is focused on supersonic tactical aircraft with highly integrated jet propulsion systems, although some information is included for supersonic strategic aircraft and for transport aircraft designed for high subsonic or low supersonic cruise. The data base for inlet external drag is considered to consist of the theoretical and empirical prediction methods as well as the experimental data identified in an extensive literature search. The state of the art in the subsonic and transonic speed regimes is evaluated. The experimental data base is organized and presented in a series of tables in which the test article, the quantities measured and the ranges of test conditions covered are described for each set of data; in this way, the breadth of coverage and gaps in the existing experimental data are evident. Prediction methods are categorized by method of solution, type of inlet and speed range to which they apply, major features are given, and their accuracy is assessed by means of comparison to experimental data.

Mcmillan, O. J.↗
NASA NTRS1980

Tests of subgrid-scale models in strained turbulence

Strained and sheared turbulence is computed by direct simulation and it is shown that the results are in good qualitative agreement with experiments. It is found that after large amounts of strain have been applied to turbulence, the energy flow to the small scales is reduced and, in some cases, reversed. Eddy viscosity models are shown to be very poor in strained turbulence and, when they are used, the mean strain should not be included in them. Finally, new models proposed by Bardina et al. have been tested and found to offer considerable promise for the future.

Mcmillan, O. J.↗
NASA NTRS1980

Calculation of two-dimensional inlet flow fields in a supersonic free stream: Program documentation and test cases

The use of a computer code for the calculation of two dimensional inlet flow fields in a supersonic free stream and a nonorthogonal mesh-generation code are illustrated by specific examples. Input, output, and program operation and use are given and explained for the case of supercritical inlet operation at a subdesign Mach number (M Mach free stream = 2.09) for an isentropic-compression, drooped-cowl inlet. Source listings of the computer codes are also provided.

Biringen, S. H.↗
NASA NTRS1980

A supersonic three-dimensional code for flow over blunt bodies: Program documentation and test cases

The use of a computer code for the calculation of steady, supersonic, three dimensional, inviscid flow over blunt bodies is illustrated. Input and output are given and explained for two cases: a pointed code of 20 deg half angle at 15 deg angle of attack in a free stream with M sub infinite = 7, and a cone-ogive-cylinder at 10 deg angle of attack with M sub infinite = 2.86. A source listing of the computer code is provided.

Chaussee, D. S.↗
NASA NTRS1980

Calculation of two-dimensional inlet flow fields in a supersonic free stream by an implicit marching code with nonorthogonal mesh generation: User's manual

An implicit, shock-capturing finite-difference code which is used to calculate two-dimensional inlet flow fields in a supersonic free stream is explained. The Euler equations are subjected to general nonorthogonal transformation and a body-fitted coordinate system is employed. The mathematical formulation of the problem is given along with the numerical algorithm. Initial and boundary conditions, numerical stability, program limitations, and accuracy is discussed. An overall program logic as well as instructions for program use and operation are also furnished.

Biringen, S. H.↗
NASA NTRS1980

A supersonic, three-dimensional code for flow over blunt bodies: User's manual

A computer code is described which may be used to calculate the steady, supersonic, three-dimensional, inviscid flow over blunt bodies. The theoretical and numerical formulation of the problem is given (shock-capturing, downstream marching), including exposition of the boundary and initial conditions. The overall flow logic of the program, its usage, accuracy, and limitations are discussed.

Chaussee, D. S.↗
NASA NTRS1980

Calculation of inlet flow fields by an implicit technique

Two-dimensional inlet flow fields in a supersonic free stream are calculated by an implicit, shock-capturing, finite-difference method. The Euler equations are subjected to a general curvilinear transformation and a body-fitted coordinate system is employed. The method is used to solve supercritical, critical, and subcritical flow fields which are simulated by prescribing appropriate conditions at the inlet outflow boundary. Results are presented for a drooped-cowl inlet.

Biringen, S.↗
NASA NTRS1979

Evaluation of methods for prediction of propulsion system drag

The results of a study directed toward compilation of a theoretical and experimental data base covering inlet/airframe and nozzle/afterbody integration are described, with the major emphasis on the evaluation of the adequacy for preliminary design purposes of the data base for afterbody/propulsion system interference effects. Prediction methods that exist for afterbody/airframe interference effects are evaluated with respect to the requirements of breadth, ease of application and accuracy that are important for preliminary design.

Kuhn, G. D.↗
NASA NTRS1977

Rolling moments in a trailing vortex flow field

Pressure distributions are presented which were measured on a wing in close proximity to a tip vortex of known structure generated by a larger, upstream semispan wing. Overall loads calculated by integration of these pressures are checked by independent measurements made with an identical model mounted on a force balance. Several conventional methods of wing analysis are used to predict the loads on the following wing. Strip theory is shown to give uniformly poor results for loading distribution, although predictions of overall lift and rolling moment are sometimes acceptable. Good results are obtained for overall coefficients and loading distribution by using linearized pressures in vortex-lattice theory in conjunction with a rectilinear vortex. The equivalent relation from reverse-flow theory that can be used to give economic predictions for overall loads is presented.

Mcmillan, O. J.↗
NASA NTRS1977

Rolling moments in a trailing vortex flow field

Pressure distributions are presented which were measured on a wing in close proximity to a tip vortex of known structure generated by a larger, upstream semispan wing. Overall loads calculated by integration of these pressures are checked by independent measurements made with an identical model mounted on a force balance. Several conventional methods of wing analysis are used to predict the loads on the following wing. Strip theory is shown to give uniformly poor results for loading distribution, although predictions of overall lift and rolling moment are sometimes acceptable. Good results are obtained for overall coefficients and loading distribution by using linearized pressures in vortex-lattice theory in conjunction with a rectilinear vortex. The equivalent relation from reverse-flow theory that can be used to give economic predictions for overall loads is presented.

Mcmillan, O. J.↗