Engineering Papers⌕ Search

Engineering topics

Mcelroy, J. H.

Publications and source records attributed to Mcelroy, J. H..

18 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

CO2 laser communication systems for near-earth space applications

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data-transmission requirement of 300 Mbit/s and above. The most efficient technique to return the data from a sensing satellite to a ground station is through a geosynchronous data relay satellite. A laser system is most attractive for the space-to-space link. A five-year program was conducted which has shown the basic technical feasibility of accomplishing this link with a CO2 laser system operating at a wavelength near 10 microns. The system uses a mercury-cadmium-telluride infrared mixer cooled to approximately 100 K by a radiative cooler. The laser local oscillator and coupling-modulated laser transmitter use conductively cooled beryllium oxide construction. The optical antenna for transmission and reception has a gain of nominally 92 dB with a 3-dB beamwidth of 80 microrad. Tracking jitter is less than ten microrad, and signal acquisition occurs in less than 1 min. The receiver subsystem has a sensitivity of 10 to the -19th power W/Hz, accommodates a 300-Mbit/s data rate, and can track Doppler frequency variations over a + or - 700-MHz range.

Mcelroy, J. H.↗
NASA NTRS1975

An infrared heterodyne radiometer for high-resolution measurements of solar radiation and atmospheric transmission

A tunable, Dicke-switched, infrared heterodyne radiometer (IHR) has been designed, fabricated, tested, and used to observe solar radiation and determine the atmospheric transmissivity in the 9-11-micron spectral band. The IHR provides a spectral resolution of 0.0067 reciprocal cm, a minimum detectable power level of 2.9 times ten to the minus twenty-third power W/Hz, and a temperature resolution of less than 1 K for a source temperature of 1000 K, an IF predetection bandwidth of 100 MHz, and an integration time of 30 s. Detailed design equations and measured IHR performance are presented. The IHR was used to make solar and atmospheric transmission measurements, and a vertical-path atmospheric attenuation of 2.3 dB has been established under favorable weather conditions. The attenuation of solar radiation due to cloud cover and haze has also been investigated.

Peyton, B. J.↗
NASA NTRS1975

Spaceborne CO2 laser communications systems

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data transmission requirement of 300 Mbps and above. Mission constraints and objectives lead to the conclusion that the most efficient technique to return the data from the sensing satellite to a ground station is through a geosynchronous data relay satellite. Of the two links that are involved (sensing satellite to relay satellite and relay satellite to ground), a laser system is most attractive for the space-to-space link. The development of CO2 laser systems for space-to-space applications is discussed with the completion of a 300 Mpbs data relay receiver and its modification into a transceiver. The technology and state-of-the-art of such systems are described in detail.

Mcelroy, J. H.↗
NASA NTRS1975

Laser tuners using circular piezoelectric benders

The paper presents the results of an experimental evaluation of a new type of piezoelectric ceramic device designed for use as a laser mirror tuner. Thin plates made from various materials were assembled into a circular bimorph configuration and tested for linearity of movement, maximum travel, and resonant frequency for varying conditions of clamping torque and mirror loading values. Most of the devices tested could accept mirror diameters up to approximately 1.3 cm and maintain a resonant frequency above 2 kHz. Typical mirror translation without measurable tilt was plus or minus 20 micrometers or greater for applied voltages of less than plus or minus 300 V.

Mcelroy, J. H.↗
NASA NTRS1975

Spaceborne CO2 laser communications systems

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data transmission requirement of 300 Mbps and above. Mission constraints and objectives lead to the conclusion that the most efficient technique to return the data from the sensing satellite to a ground station is through a geosynchronous data relay satellite. Of the two links that are involved (sensing satellite to relay satellite and relay satellite to ground), a laser system is most attractive for the space-to-space link. During 1975 a major step toward the development of CO2 laser systems for space-to-space applications is being completed. This step is the completion of a 300 Mbps data relay receiver and its modification into a transceiver. The technology and state-of-the-art of such systems are described in detail in this paper.

Mcelroy, J. H.↗
NASA NTRS1972

A curve-fitting technique for the determination of gain and saturation intensity in homogeneously-broadened gas lasers: Application to a waveguide CO2 laser

A least squares curve-fitting algorithm is derived which allows the simultaneous estimation of the small signal gain and the saturation intensity from an arbitrary number of data points relating power output to the incidence angle of an internal coupling plate. The method is used to study the dependence of the two parameters on tube pressure and discharge current in a waveguide CO2 laser having a 2 mm diameter capillary. It is found that, at pressures greater than 28 torr, rising CO2 temperature degrades the small signal gain at current levels as low as three milliamperes.

Degnan, J. J.↗
NASA NTRS1972

Circular piezoelectric bender laser tuners

The circular piezoelectric bender laser tuner to replace conventional laser tuners when mirror diameters up to 0.50 inch are sufficient is described. The circular piezoelectric bender laser tuner offers much higher displacements per applied volt and permits laser control circuits to be fabricated using standard operational amplifiers, rather than the expensive high-voltage amplifiers required by conventional tuners. The cost of the device is more than one order of magnitude lower than conventional tuners and the device is very rugged with all mechanical resonances easily designed to be greater than 3kHz. In addition to its use as a laser frequency tuner, the circular bender tuner should find many applications in interferometers and similar devices.

Mcelroy, J. H.↗
NASA NTRS1972

Infrared heterodyne solar radiometry.

An infrared heterodyne radiometer has sufficient sensitivity for application to high resolution spectrometric studies of the sun and the absorption of sunlight in the atmosphere. In the 10-micron region, the resolution can typically range from less than .0067/cm to .067/cm. The minimum detectable signal can approach 10 to the -24th power W/Hz. The infrared heterodyne radiometer (IHR) can also be used for atmospheric propagation studies at the emission frequencies of the CO2 laser for the examination of the feasibility of space-to-ground laser communication links.

Mcelroy, J. H.↗
NASA NTRS1972

The BAPE 2 balloon-borne CO2

The systems and techniques which were utilized in the experiment to establish an air-to-ground CO2 laser heterodyne link are described along with the successes and problems encountered when the heterodyne receiver and laser transmitter package were removed from the controlled environment of the laboratory. Major topics discussed include: existing systems and the underlying principles involved in their operation; experimental techniques and optical alignment methods which were found to be useful; theoretical calculations of signal strengths expected under a variety of test conditions and in actual flight; and the experimental results including problems encountered and their possible solutions.

Degnan, J. J.↗
NASA NTRS1972

Multichannel television coupling modulation experiments using a CO2 laser.

Experiments are described in which a carbon dioxide laser oscillating at 28.4 THz has been modulated simultaneously by three commercial television signals with carriers at 54, 66, and 82 MHz. Signal-to-noise degradation in the system was measured to be less than 1 dB, corresponding to modulator drive power of 1 W. This combination of wide bandwidth and low power consumption was made possible by the application of coupling modulation. This technique employs an intracavity electrooptic crystal to which the modulating fields are applied. Despite the fact that the crystal is positioned inside the laser cavity, the maximum bandwidth attainable is independent of both the cavity Q and the laser transition linewidth, and is limited only by modulator characteristics and optical transit time. Rigrod's (1965) method has been adapted to obtain an expression for the power coupled out of the laser. Modulator frequency response and drive power requirements are also summarized. It is seen that the noise bandwidth performance of the system would allow simultaneous modulation by 17 color television channels, or equivalently, more than a 300-megabit/sec capacity.

Hall, D. R.↗
NASA NTRS1971

N-type mercury-cadmium-telluride photoconductors in optical heterodyne communication systems.

Discussion of the performance of a photoconductive (Hg,Cd)Te detector/mixer in a carbon dioxide laser heterodyne communication system. The utility of computer simulation of the performance of an optical heterodyne detector/mixer is demonstrated. Certain unusual properties of this device are pointed out that, while having a substantial impact on device performance, have received little previous attention.

Cohen, S. C.↗