Engineering PapersSearch

Engineering topics

Mcavoy, N.

Publications and source records attributed to Mcavoy, N..

At least 19 records

Submillimeter heterodyne detection of interstellar carbon monoxide at 434 micrometers

Laser heterodyne observations of submillimeter emissions from carbon monoxide in the Orion molecular cloud are reported. High frequency and spatial resolution observations were made at the NASA Infrared Telescope Facility on Mauna Kea by the use of an optically pumped laser local oscillator and quasi-optical Schottky diode mixer for heterodyne detection of the J = 6 - 5 rotational transition of CO at 434 microns. Spectral analysis of the 434-micron emission indicates that the emitting gas is optically thin and is at a temperature above 180 K. Results thus demonstrate the potential contributions of ground-based high-resolution submillimeter astronomy to the study of active regions in interstellar molecular clouds.

Fetterman, H. R.

Detection of the J = 6 - 5 transition of carbon monoxide

The J = 6 - 5 rotational transition of carbon monoxide has been detected in emission from the KL 'plateau source' in the Orion molecular cloud. The corrected peak antenna temperature is 100 K, and the FWHM line width is 26 km/sec. These observations were carried out using the 3 m telescope of the NASA IRTF (Infrared Telescope Facility) on Mauna Kea, Hawaii, and constitute the first astronomical data obtained at submillimeter wavelengths with a heterodyne system using a laser local oscillator. The data support the idea that the high-velocity dispersion CO in Orion is optically thin and set a lower limit to its temperature of approximately 180 K.

Goldsmith, P. F.

433 micron laser heterodyne observations of galactic CO from Mauna Kea

A submillimeter heterodyne radiometer, developed for astronomical applications, uses an optically pumped laser local oscillator and a quasi-optical Schottky diode mixer. The resultant telescope-mounted system, which has a noise temperature less than 4000 K (double sideband) and high frequency and spatial resolution, has been used to detect the J = 6 to 5 rotational transition of carbon monoxide at 434 micrometers in the Orion molecular clouds. The measurements, when compared with previous millimeter-wave data, indicate that the broad carbon monoxide emission feature is produced by an optically thin gas whose temperature exceeds 180 K.

Buhl, D.

A stable submillimeter laser local oscillator for heterodyne radiometry and spectroscopy

A submillimeter laser with off-axis pump beam injection is described. This design concept achieves complete isolation of the pump laser with respect to the pump radiation reflected from the submillimeter resonator. Active line independent stabilization of the pump laser is obtained by the use of an external tunable etalon as a frequency reference. The submillimeter output power is constant to within 4% over periods of hours. Mean frequency drifts of less than 2 parts in 100 million per minute were measured by mixing with very high harmonics of an X-band synthesizer in a planar Schottky diode.

Koepf, G. A.

Design criteria for FIR waveguide laser cavities

The geometrical design parameters of coherently pumped far infrared waveguide laser cavities are analyzed with respect to minimization of pump power losses. The advantages of highly degenerate cavities and off axis displacement of the injection hole are outlined. Relations between the cavity parameters are given which simplify the design of cavities with high pumping efficiency.

Koepf, G. A.

CO2 laser communication systems for near-earth space applications

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data-transmission requirement of 300 Mbit/s and above. The most efficient technique to return the data from a sensing satellite to a ground station is through a geosynchronous data relay satellite. A laser system is most attractive for the space-to-space link. A five-year program was conducted which has shown the basic technical feasibility of accomplishing this link with a CO2 laser system operating at a wavelength near 10 microns. The system uses a mercury-cadmium-telluride infrared mixer cooled to approximately 100 K by a radiative cooler. The laser local oscillator and coupling-modulated laser transmitter use conductively cooled beryllium oxide construction. The optical antenna for transmission and reception has a gain of nominally 92 dB with a 3-dB beamwidth of 80 microrad. Tracking jitter is less than ten microrad, and signal acquisition occurs in less than 1 min. The receiver subsystem has a sensitivity of 10 to the -19th power W/Hz, accommodates a 300-Mbit/s data rate, and can track Doppler frequency variations over a + or - 700-MHz range.

Mcelroy, J. H.

Detection of upper atmospheric constituents using submillimeter wave /SMMW/ heterodyne radiometry

Submillimeter wave heterodyne radiometry has been applied to the detection and sounding of upper atmospheric constituents. The use of room-temperature Schottky-diode mixers for the receivers has yielded measurements of 70,000 K noise temperature. Coupling losses into the diode and matching of the IF output limit are observed to limit noise temperature. The technique is evaluated by calculating spectra with assumed temperature and constituent profiles. Vertical integrations are made with a multilayer atmosphere and the direct summation of absorption coefficients for the individual spectral lines is used. Results are presented for tangent path parameters for a mid-latitude summer model and the fractional parts of upper atmospheric constituents as a function of altitude.

Mcavoy, N.

Frequencies above 10 GHz

The paper discusses some of the problems associated with extending the frequencies used by satellite communication services above 10 GHz. The principal propagation limitation above 10 GHz occurs when precipitation intercepts the earth-space propagation path and causes attenuation and depolarization of the transmitted signal. World attenuation statistics at 12 GHz for earth-space paths are discussed, revealing the effect of climate on attenuation properties. Space diversity is discussed as an effective means of overcoming precipitation-caused attenuation problems.

Mcavoy, N.

Spaceborne CO2 laser communications systems

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data transmission requirement of 300 Mbps and above. Mission constraints and objectives lead to the conclusion that the most efficient technique to return the data from the sensing satellite to a ground station is through a geosynchronous data relay satellite. Of the two links that are involved (sensing satellite to relay satellite and relay satellite to ground), a laser system is most attractive for the space-to-space link. The development of CO2 laser systems for space-to-space applications is discussed with the completion of a 300 Mpbs data relay receiver and its modification into a transceiver. The technology and state-of-the-art of such systems are described in detail.

Mcelroy, J. H.

Spaceborne CO2 laser communications systems

Projections of the growth of earth-sensing systems for the latter half of the 1980's show a data transmission requirement of 300 Mbps and above. Mission constraints and objectives lead to the conclusion that the most efficient technique to return the data from the sensing satellite to a ground station is through a geosynchronous data relay satellite. Of the two links that are involved (sensing satellite to relay satellite and relay satellite to ground), a laser system is most attractive for the space-to-space link. During 1975 a major step toward the development of CO2 laser systems for space-to-space applications is being completed. This step is the completion of a 300 Mbps data relay receiver and its modification into a transceiver. The technology and state-of-the-art of such systems are described in detail in this paper.

Mcelroy, J. H.

Optical communication in free space

Two classes of laser communication systems for handling very high data rates across inter-satellite distances are considered that provide for high antenna gains, wide modulation bandwidths, and optical receiver sensitivities. System design considerations are based upon the carbon dioxide laser modulation to accommodate digital or analog information, and the neodymium doped YAG laser pulse for digital modulation.

Plotkin, H. H.

A curve-fitting technique for the determination of gain and saturation intensity in homogeneously-broadened gas lasers: Application to a waveguide CO2 laser

A least squares curve-fitting algorithm is derived which allows the simultaneous estimation of the small signal gain and the saturation intensity from an arbitrary number of data points relating power output to the incidence angle of an internal coupling plate. The method is used to study the dependence of the two parameters on tube pressure and discharge current in a waveguide CO2 laser having a 2 mm diameter capillary. It is found that, at pressures greater than 28 torr, rising CO2 temperature degrades the small signal gain at current levels as low as three milliamperes.

Degnan, J. J.

Multichannel television coupling modulation experiments using a CO2 laser.

Experiments are described in which a carbon dioxide laser oscillating at 28.4 THz has been modulated simultaneously by three commercial television signals with carriers at 54, 66, and 82 MHz. Signal-to-noise degradation in the system was measured to be less than 1 dB, corresponding to modulator drive power of 1 W. This combination of wide bandwidth and low power consumption was made possible by the application of coupling modulation. This technique employs an intracavity electrooptic crystal to which the modulating fields are applied. Despite the fact that the crystal is positioned inside the laser cavity, the maximum bandwidth attainable is independent of both the cavity Q and the laser transition linewidth, and is limited only by modulator characteristics and optical transit time. Rigrod's (1965) method has been adapted to obtain an expression for the power coupled out of the laser. Modulator frequency response and drive power requirements are also summarized. It is seen that the noise bandwidth performance of the system would allow simultaneous modulation by 17 color television channels, or equivalently, more than a 300-megabit/sec capacity.

Hall, D. R.

Broadband CO2 laser coupling modulation.

The application of coupling modulation is described for achieving a 110-MHz bandwidth using CO2 lasers and GaAs electrooptic crystals. Coupling modulation is a technique that has no bandwidth limitations and allows the modulation bandwidth to exceed that of the laser resonator.

Mcavoy, N.

10-micrometer band communication terminals in space.

Ten-micrometer band communication systems using CO2 lasers for space to space links are discussed. Particular emphasis is on low earth orbiting earth observation satellites to geosynchronous satellites at high data rate. Four key technology areas are discussed: wideband mixers for Doppler tracking; tunable laser local oscillators; high data rate modulators; and laser transmitters.

Mcavoy, N.