Engineering topics

Mason, Harris E.

Publications and source records attributed to Mason, Harris E..

26 records · Page 2

DOE OSTI2021

Reversing the Irreversible: Thermodynamic Stabilization of LiAlH 4 Nanoconfined Within a Nitrogen-Doped Carbon Host

A general problem when designing functional nanomaterials for energy storage is the lack of control over the stability and reactivity of metastable phases. Using the high-capacity hydrogen storage candidate LiAlH4 as an exemplar, we demonstrate an alternative approach to the thermodynamic stabilization of metastable metal hydrides by coordination to nitrogen binding sites within the nanopores of N-doped CMK-3 carbon (NCMK-3). The resulting LiAlH 4 @NCMK-3 material releases H 2 at temperatures as low as 126 °C with full decomposition below 240 °C, bypassing the usual Li 3 AlH 6 intermediate observed in bulk. Moreover, >80% of LiAlH 4 can be regenerated under 100 MPa H 2 , a feat previously thought to be impossible. Nitrogen sites are critical to these improvements, as no reversibility is observed with undoped CMK-3. Density functional theory predicts a drastically reduced Al–H bond dissociation energy and supports the observed change in the reaction pathway. Finally, the calculations also provide a rationale for the solid-state reversibility, which derives from the combined effects of nanoconfinement, Li adatom formation, and charge redistribution between the metal hydride and the host.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

LX-17 Thermal Decomposition-Characterization of Solid Residues from Cook-Off in a Small-Scale Vessel Under Confinement

Concerns surround whether insensitive (or any) energetic materials are more dangerous to handle when exposed to abnormal thermal environments. This study characterizes the residual material remaining after LX-17 (92.5 % 1,3,5-triamino 2,4,6-trinitro benzene (TATB) and 7.5 % Kel-F) is exposed to various thermal environments in a sealed small-scale vessel cook-off test reactor (heated at 0.1 to 100 °C/min until the reactor opened at 3000 psi (20.7 MPa)). Previous work has shown no additional sensitivity of these residues as evaluated by small-scale safety analysis, but characterization on the molecular scale indicates the TATB is transformed to more reactive compounds as well as the residue could be precursors to toxic gases. The solids and chars were characterized by various analytical methods. Heat-flow measurements indicated exothermic release is due to a mixture of residual TATB and related decomposition products (which may be more energetic). The N/C and O/N ratios indicated a material much more degraded than TATB. Primarily, the solids were a network of amorphous C inter-dispersed with N and O. Types of bonding include C–C, C–N, N–H, N–C, N=C, N≡C, C–O=, and –OH. Solvent extracts of the solids showed TATB decomposition intermediates benzo-furazans and benzo-furoxans, substituted TATB (mono-nitroso, hydroxyl, and chlorinated) along with several unidentified smaller molecules. These results indicate thermal treatment produces an amorphous carbon residue with heteroatoms incorporated through differing functionality, varying depending upon the thermal severity of exposure. These structures also could further decompose producing toxic light gases (such as cyanide).

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Spectroscopic Signatures of MQ-Resins in Silicone Elastomers

Polysiloxane elastomers have a large application space due to their versatile cross-linking chemistry and highly tunable physical and mechanical properties. One approach for improving the mechanical integrity of commercial polysiloxane “silicone” elastomers while maintaining their optical transparency is the addition of small, silicone-resin molecules to the network. However, both the poly(dimethylsiloxane) (PDMS) network and the silicone-resin particles have an amorphous structure and complex chemistry, which makes the characterization of their structural properties and segmental network dynamics difficult. Here, we report the synthesis and characterization of a series of model silicone networks modified with a specific class of silicone-resin known as MQ-resin using Raman and advanced nuclear magnetic resonance (NMR) spectroscopy methods. Raman spectroscopy was successfully used to quantify the contribution of the MQ-resin to the network, to determine the type of MQ-resin present in the network, and to investigate the completeness of the network cross-linking reaction. Furthermore, solid-state and 1H double-quantum (DQ) NMR spectroscopies were used not only as a detection method for the MQ-resins but also to quantify changes in the segmental dynamics of the network as a function of MQ-resin concentration. The combination of Raman and NMR spectroscopies describes a series of samples where the MQ-resin particles and PDMS chains maintain their independent segmental dynamics up to high concentrations of MQ-resins (40–50% MQ), where the physical properties of the resin dominate the physical properties of the overall network. The results from our spectroscopic analyses are consistent with the results from macroscopic characterization techniques such as solvent uptake and mechanical testing. The spectroscopic insights into the structure–property relationships of PDMS-MQ composites presented in this study are a valuable tool not only for the synthesis and reverse engineering of future generations of commercial silicone elastomers but also for understanding the mechanisms of aging and degradation over the material lifetime.

36 MATERIALS SCIENCE↗

DOE OSTI2021

Landfilled coal ash for carbon dioxide capture and its potential as a geopolymer binder for hazardous waste remediation

In this report, the legacy of global fossil fuel usage is not just the increase in global warming due to CO 2 production, but also the billions of tons of toxic coal ash disposed in landfills. This investigation evaluates the merits of using high-calcium landfilled coal fly ash of different disposal durations and granulated blast furnace (GBF) slag as primary raw materials for production of a new class of geopolymer binder. Processing of landfilled coal fly ash, GBF slag and supplementary raw materials into a geopolymer binder was accomplished by a simple, scalable milling process in the absence of heating under a carbon dioxide environment. The resultant geopolymer cement binders were tested for carbon dioxide uptake, compressive strength, and heavy metal stabilization. The geopolymer binder demonstrated a desired balance of carbon dioxide uptake, strength and safety. These results also indicate that the performance of the geopolymer binder depends on the landfill disposal age of the coal fly ash.

29 ENERGY PLANNING, POLICY, AND ECONOMY↗

DOE OSTI2021

Influence of Uranium Concentration and pH on U-Phosphate Biomineralization by Caulobacter OR37

Uranium contamination of soils and groundwater in the United States represents a significant health risk and will require multiple remediation approaches. Microbial phosphatase activity coupled to the addition of an organic P source has recently been studied as a remediation strategy that provides an extended release of inorganic P (Pi) into U-contaminated sites, resulting in the precipitation of meta-autunite minerals. Previous laboratory- and field-based biomineralization studies have investigated environments with relatively high U concentrations (>20 μM). However, most contaminated sites have much lower U concentrations (<2 μM). The Environmental Protection Agency (EPA) limit for U in drinking water is 0.126 μM. Reaching this regulatory limit becomes challenging as U concentrations approach autunite solubility. Furthermore, we studied the precipitation of U(VI)-phosphate minerals by an environmental isolate of Caulobacter sp. (strain OR37) from an Oak Ridge, Tennessee, U-contaminated site. Abiotic U(VI) solubility experiments reveal that U(VI)-phosphate minerals do not form in the presence of excess Pi (500 μM) when U(VI) concentrations are <1 μM and pH is <5. When OR37 cells are reacted under the same conditions with Pi or glycerol-2-phosphate, U(VI)-phosphate mineral formation was observed, along with the formation of intracellular polyphosphate granules. These results show that bacteria provide supersaturated microenvironments needed for U(VI)-phosphate mineralization while hydrolyzing organic P sources. This provides a pathway to lower U concentrations to below EPA limits for drinking water.

38 RADIATION CHEMISTRY, RADIOCHEMISTRY, AND NUCLEA↗

DOE OSTI2020

Local Structure of Glassy Lithium Phosphorus Oxynitride Thin Films: A Combined Experimental and Ab Initio Approach

Abstract Lithium phosphorus oxynitride (LiPON) is an amorphous solid‐state lithium ion conductor displaying exemplary cyclability against lithium metal anodes. There is no definitive explanation for this stability due to the limited understanding of the structure of LiPON. Herein, we provide a structural model of RF‐sputtered LiPON. Information about the short‐range structure results from 1D and 2D solid‐state NMR experiments. These results are compared with first principles chemical shielding calculations of Li‐P‐O/N crystals and ab initio molecular dynamics‐generated amorphous LiPON models to unequivocally identify the glassy structure as primarily isolated phosphate monomers with N incorporated in both apical and as bridging sites in phosphate dimers. Structural results suggest LiPON′s stability is a result of its glassy character. Free‐standing LiPON films are produced that exhibit a high degree of flexibility, highlighting the unique mechanical properties of glassy materials.

Marple, Maxwell A. T.↗

DOE OSTI2020

Local Structure of Glassy Lithium Phosphorus Oxynitride Thin Films: A Combined Experimental and Ab Initio Approach

Lithium phosphorus oxynitride (LiPON) is an amorphous solid–state lithium ion conductor displaying exemplary cyclability against lithium metal anodes. There is no definitive explanation for this stability due to the limited understanding of the structure of LiPON. Herein, we provide a structural model of RF–sputtered LiPON. Information about the short–range structure results from 1D and 2D solid–state NMR experiments. These results are compared with first principles chemical shielding calculations of Li–P–O/N crystals and ab initio molecular dynamics–generated amorphous LiPON models to unequivocally identify the glassy structure as primarily isolated phosphate monomers with N incorporated in both apical and as bridging sites in phosphate dimers. Structural results suggest LiPON's stability is a result of its glassy character. In conclusion, free–standing LiPON films are produced that exhibit a high degree of flexibility, highlighting the unique mechanical properties of glassy materials.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Low Molecular Weight Dissolved Organic Carbon: Aging, Compositional Changes, and Selective Utilization During Global Ocean Circulation

The composition and cycling dynamics of marine dissolved organic carbon (DOC) have received increased interest in recent years; however, little research has focused on the refractory, low molecular weight (LMW) component that makes up the majority of this massive C pool. In this study, we measured stable isotopic (δ 13 C), radioisotopic (Δ 14 C), and compositional (C/N, 13 C solid-state NMR) properties of separately isolated high molecular weight (HMW) and LMW DOC fractions collected using a coupled ultrafiltration and solid phase extraction approach from throughout the water column in the North Central Pacific and Central North Atlantic. The selective isolation of LMW DOC material allowed the first investigation of the composition and cycling of a previously elusive fraction of the DOC pool. The structural composition of the LMW DOC material was homogeneous throughout the water column and closely matched carboxylic-rich alicyclic material that has been proposed as a major component of the marine refractory DOC pool. Examination of offsets in the measured parameters between the deep waters of the two basins provides the first direct assessment of changes in the properties of this material with aging and utilization during ocean circulation. While our direct measurements largely confirm hypotheses regarding the relative recalcitrance of HMW and LMW DOC, we also demonstrate a number of novel observations regarding the removal and addition of DOC during global ocean circulation, including additions of fresh carbohydrate-like HMW DOC to the deep ocean and large-scale removal of both semilabile HMW and recalcitrant LMW DOC.

58 GEOSCIENCES↗