Engineering PapersSearch

Engineering topics

Martin, James A.

Publications and source records attributed to Martin, James A..

At least 19 records

Simple Cell Balance Circuit

A method has been developed for continuous cell voltage balancing for rechargeable batteries (e.g. lithium ion batteries). A resistor divider chain is provided that generates a set of voltages representing the ideal cell voltage (the voltage of each cell should be as if the cells were perfectly balanced). An operational amplifier circuit with an added current buffer stage generates the ideal voltage with a very high degree of accuracy, using the concept of negative feedback. The ideal voltages are each connected to the corresponding cell through a current- limiting resistance. Over time, having the cell connected to the ideal voltage provides a balancing current that moves the cell voltage very close to that ideal level. In effect, it adjusts the current of each cell during charging, discharging, and standby periods to force the cell voltages to be equal to the ideal voltages generated by the resistor divider. The device also includes solid-state switches that disconnect the circuit from the battery so that it will not discharge the battery during storage. This solution requires relatively few parts and is, therefore, of lower cost and of increased reliability due to the fewer failure modes. Additionally, this design uses very little power. A preliminary model predicts a power usage of 0.18 W for an 8-cell battery. This approach is applicable to a wide range of battery capacities and voltages.

Johnson, Steven D.

Earth-to-Geostationary Orbit Transportation for Space Solar Power System Development

Space solar power satellites have the potential to provide abundant quantities of electricity for use on Earth. One concept, the Sun Tower, can be assembled in geostationary orbit from pieces transferred from Earth. The cost of transportation is one of the major hurdles to space solar power. This study found that autonomous solar-electric transfer is a good choice for the transportation from LEO to GEO.

Martin, James A.

In-Space Transportation for Geo Space Solar Satellites

Space solar power satellites have the potential to provide abundant quantities of electricity for use on Earth. One concept, the Sun Tower, can be assembled in geostationary orbit from pieces transferred from Earth. The cost of transportation from Earth is one of the major hurdles to space solar power. This study found that a two-stage rocket launch vehicle with autonomous solar-electric transfer can provide the transportation at prices close to the goal of $800/kg

Martin, James A.

In-Space Transportation for GEO Space Solar Power Satellites

This report summarizes results of study tasks to evaluate design options for in-space transportation of geostationary Space Solar Power Satellites. Referring to the end-to-end architecture studies performed in 1988, this current activity focuses on transportation of Sun Tower satellite segments from an initial low Earth orbit altitude to a final position in geostationary orbit (GEO; i.e., 35,786 km altitude, circular, equatorial orbit). This report encompasses study activity for In-Space Transportation of GEO Space Solar Power (SSP) Satellites including: 1) assessment of requirements, 2) design of system concepts, 3) comparison of alternative system options, and 4) assessment of potential derivatives.

Martin, James A.

Access to space studies

The National Aeronautics and Space Administration is currently considering possible directions in Earth-to-orbit vehicle development under a study called 'Access to Space.' This agency-wide study is considering commercial launch vehicles, human transportation, space station logistics, and other space transportation requirements over the next 40 years. Three options are being considered for human transportation: continued use of the Space Shuttle; development of a small personnel carrier (personnel logistics system (PLS)); or development of an advanced vehicle such as a single-stage-to-orbit (SSTO). Several studies related to the overall Access to Space study are reported in this document.

Martin, James A.

Atlas Centaur Rocket With Reusable Booster Engines

Proposed modification of Atlas Centaur enables reuse of booster engines. Includes replacement of current booster engines with engine of new design in which hydrogen used for both cooling and generation of power. Use of hydrogen in new engine eliminates coking and clogging and improves performance significantly. Primary advantages: reduction of cost; increased reliability; and increased payload.

Martin, James A.

Alternate vehicles for engine/vehicle optimization

The space shuttle main engine, full flow staged combustion, integrated modular engine concept, split expander, and expander bleed rocket engine cycles were studied for use on Single-Stage-to-Orbit fully reusable vehicles. The vehicle uses vertical take-off and horizontal landing and liquid hydrogen rockets for propulsion. The PROPSIZE computer code was modified for use on the available computers. Vehicle sizing was done after trajectory optimization for various engine designs. The various rocket engine cycles were compared and it was found that the full flow staged combustion cycle had the lowest vehicle dry mass. The split expander cycle could have advantages in safety and cooling which could make it the preferred choice in some cases. Comparison to previous work with two-stage heavy-lift vehicles showed that the same ranking of the cycles was found for both vehicle concepts.

Venkatasubramanyam, G.

Supersonic Air-Breathing Stage For Commercial Launch Rocket

Concept proposed to expand use of air-breathing, reusable stages to put more payload into orbit at less cost. Stage with supersonic air-breathing engines added to carry expendable stages from subsonic airplane to supersonic velocity. Carry payload to orbit. Expendable stages and payload placed in front of supersonic air-breathing stage. After releasing expendable stages, remotely piloted supersonic air-breathing stage returns to takeoff site and land for reuse. New concept extends use of low-cost reusable hardware and increases payload delivered from B-52.

Martin, James A.

Directions for future Earth-to-orbit vehicles

NASA is currently assessing several programmatic possibilities. The desire is to maintain the current capability for transportation to orbit provided by the Space Shuttle and the existing fleet of commercial vehicles, develop the Space Station Freedom, and initiate a new program of exploration of the Moon and Mars, called the Space Exploration Initiative (SEI). At the same time, the NASA budget is likely to be held to current levels. Cost estimates indicate that it will not be possible to satisfy all the goals without cost reductions. One of the concepts being considered for cost reduction is to replace the Space Shuttle and existing commercial vehicles with a new set of vehicles called the National Launch System (NLS). Several concepts have been studied, but none of the concepts studied to date provides the desired combination of cost/flight reduction, acceptable development cost, and technology readiness. An additional goal is to provide a path to grow the NLS capability into a heavy-lift capability for SEI missions.

Martin, James A.

Windshield-Wiper Heater

Heated blades significantly enhance safety of aircraft and automobiles. Electrical-resistance heating strips inside cover keep wiper blade warmer than freezing temperature. Applies heat directly to windshield wipers, preventing any ice or snow from accumulating on wipers.

Martin, James A.

Integrated launch and emergency vehicle system

A heavy launch vehicle is discussed. The launch vehicle is comprised of an expendable, multi-container, propellant tank that has a plurality of winged booster propulsion modules at one end and a payload supported by adapter structure at the other end. The preferred payload is an entry module that can be adapted for docking to the space station and used as a return vehicle for the space station crew. Additionally, the payload may include communication satellites, supplies, equipment, and/or structural elements for the space station. The winged propulsion modules are released from the expendable propellant tank, in pairs, and they return to Earth in a controlled glide. After a safe landing, at or near the launch site, the modules are prepared for reuse. The rocket engines for each propulsion module are dual-fuel, dual-mode engines and use methane-oxygen and hydrogen-oxygen from the multi-containers of the propellant tank. When the propulsion modules are released from the expendable propellant tank, the rocket engines are moved into the module cargo bay for the return glide flight.

Martin, James A.

Titan improvement study - Hydrogen core stages

The performance benefits and comparative cost-effectiveness of Titan/Centaur launcher improvement options involving a new LH2/LOX second stage and/or a new LH2/LOX first stage are presented. This incremental improvement approach involves higher confidence due to high components-commonality with well-tested systems. The proposed second stage's capabilities are such as to allow it to serve as an OTV. This improvement to Titan constitutes one of several justifications for a new 500-1000 kN thrust liquid-fuel engine.

Martin, James A.

Automated Power-Distribution System

Automated power-distribution system monitors and controls electrical power to modules in network. Handles both 208-V, 20-kHz single-phase alternating current and 120- to 150-V direct current. Power distributed to load modules from power-distribution control units (PDCU's) via subsystem distributors. Ring busses carry power to PDCU's from power source. Needs minimal attention. Detects faults and also protects against them. Potential applications include autonomous land vehicles and automated industrial process systems.

Thomason, Cindy

Evaluation of Proposed Rocket Engines for Earth-to-Orbit Vehicles

The objective is to evaluate recently analyzed rocket engines for advanced Earth-to-orbit vehicles. The engines evaluated are full-flow staged combustion engines and split expander engines, both at mixture ratios at 6 and above with oxygen and hydrogen propellants. The vehicles considered are single-stage and two-stage fully reusable vehicles and the Space Shuttle with liquid rocket boosters. The results indicate that the split expander engine at a mixture ratio of about 7 is competitive with the full-flow staged combustion engine for all three vehicle concepts. A key factor in this result is the capability to increase the chamber pressure for the split expander as the mixture ratio is increased from 6 to 7.

Martin, James A.

Optimization of the propulsion cycles for advanced shuttles. II - Performance model methodology

In 1988 computer codes from NASA and DLR were combined to analyze and optimize rocket engines for advance launch vehicles. Further effort has addressed performance propulsion parameters such as chamber pressure, cycle selection (including mixed and tripropellant cycles), nozzle extension, and new technologies. Results of the study indicate that lower dry masses can be reached with the staged combustion cycle than with the gas-generator cycle, using oxygen/hydrogen at relatively high mixture ratio (7:1) and modest chamber pressure (220 bar). For low dry masses the staged combustion cycle is only excelled by the dual-expander cycle using hydrogen and propane as fuels. The emphasis here is to explain the procedure and boundary conditions used for the analysis and the variety of configurations treated, as well as to demonstrate the methods used by presenting some of the major results.

Manski, Detlef