Engineering Papers⌕ Search

Engineering topics

Martin, Elijah H.

Publications and source records attributed to Martin, Elijah H..

Complex multicomponent spectrum analysis with Deep Neural Network

Here, in this paper, we present the use of deep neural networks to estimate physical parameters from complex optical emission spectra of the D β /H β transition. Specifically, we focus on estimating the radio frequency electric field vector of the lower hybrid wave and isotope ratio within the scrape-off-layer plasma of the WEST tokamak. Fitting the spectral data using a traditional non-linear least squares analysis requires many free parameters and is computationally expensive, rendering the data unusable for real-time control. By implementing relatively small neural networks, the physical parameters can be directly extracted from the spectral data with reasonable accuracy in a few milliseconds. The deep neural network prediction can serve as input for a reduced model using least-squares fitting or for real-time control. We show that deep neural networks can be an effective tool for analyzing complex multicomponent spectra, providing a speedup of more than 10 5 times compared to least residual analysis, with an accuracy of 0.5% for the isotope ratio, and 0.09 kV/cm and 0.38 kV/cm for the RF radial and poloidal electric field respectively.

47 OTHER INSTRUMENTATION↗

Developing high performance RF heating scenarios on the WEST tokamak

High power experiments, up to 9.2 MW with LHCD and ICRH, have been carried out in the full tungsten tokamak WEST. Here, quasi non inductive discharges have been achieved allowing to extend the plasma duration to 53 s with stationary conditions in particular with respect to tungsten contamination. Transitions to H mode are observed, and H-modes lasting up to 4 s have been obtained. The increase in stored energy is weak since the power crossing the separatrix is close to the L–H threshold. Hot L mode plasmas (central temperature exceeding 3 keV) with a confinement time following the ITER L96 scaling law are routinely obtained. The weak aspect ratio dependence of this scaling law is confirmed. Tungsten accumulation is generally not an operational issue on WEST. Difficulty of burning through tungsten can prevent the discharge from accessing to a hot core plasma in the ramp-up phase, or can lead to rapid collapse of the central temperature when radiation is enhanced by a slight decrease of the temperature. Except a few pulses post-boronization, the plasma radiation is rather high (P rad /P tot ~ 50%) and is dominated by tungsten. This fraction does not vary as the RF power is ramped up and is quite similar in ICRH and/or LHCD heated plasmas. An estimate of the contribution of the RF antennas to the plasma contamination in tungsten is given.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Full-wave model for the lower hybrid wave electric field vector with synthetic turbulence on Alcator C-Mod

The effects of synthetic turbulence on lower hybrid (LH) wave field magnitude and polarization are studied on Alcator C-Mod. Three synthetic turbulence models are evaluated to assess the impact of filaments, holes, and periodic fluctuations on the LH wave electric fields. For all three cases, the synthetic turbulence can greatly impact the LH wave magnitude and polarization. Back scattering, interference and edge/SOL absorption of the LH wave is observed. This impact is shown to depend on the wavelength and amplitude of the fluctuations. The strongest effect appears for fluctuations at high amplitudes and wavelengths comparable to the LH wavelength. This synthetic turbulence model can be used as inputs into a synthetic diagnostic to calculate the lower hybrid wave field magnitude and direction measured by dynamic Stark effect spectroscopy. It will be shown that fluctuations at these high amplitudes and wavelengths may explain the experimentally measured results. Here, the effect of fluctuations on modifying LH polarization are also shown to be anti-correlated with SOL power losses, similar to recently observed experimental trends on Alcator C-Mod. These SOL losses may have detrimental impact on LHCD efficiency.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Machine learning for analysis of atomic spectral data

Physics based forward models are the basis on which many experimental diagnostics are interpreted. For some diagnostics, models can be computationally expensive which precludes their use in real time analysis. Reduced models have the potential to capture sufficient physics thereby enabling the desired real time analysis. Using statistical inference and machine learning techniques the application of reduced models for inversion of atomic spectral data used to diagnose magnetic fields in a plasma will be examined. Two approaches are considered, (a) a reduction of the forward model where traditional inversion can be performed on the proxy model, and (b) a reduction of the direct inverse where parameters are a function of measured signal. The resulting inversion is sufficiently fast to be utilized in an online context for digital twinning, and ultimately real-time prediction, design, and control of plasma systems, such as tokamaks. Furthermore, these methods will be demonstrated on both simulated and experimentally measured data.

74 ATOMIC AND MOLECULAR PHYSICS↗

Experimental evidence of lower hybrid wave scattering in Alcator C-Mod due to scrape off layer density fluctuations

Novel experimental measurements of the lower hybrid (LH) wave electric field vector, E LH , obtained in Alcator C-Mod using dynamic Stark spectroscopy are presented. Three key results were obtained by comparison with 3D full-wave COMSOL simulations using the cold plasma dielectric tensor and reflectometry-measured density profiles. (1) As a function of space and LH power, the magnitude of E LH was found to agree with the full-wave simulation result. (2) The direction of E LH was found to have a substantial poloidal component and is in strong disagreement with the nearly radial full-wave simulation result. (3) The addition of scrape off layer density fluctuations to the density profile implemented in the full-wave simulations can be used to explain the E LH direction discrepancy. It is concluded that diffraction and scattering by turbulence-driven scrape off layer density fluctuations is the responsible mechanism behind the modification in the direction of E LH . Furthermore, these results further support the previously reported proposition that edge turbulence is an important mechanism behind the strong anomalous drop in LH current drive efficiency for diverted plasmas in the high-density regime.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

High resolution magnetic field measurements in hydrogen and helium plasmas using active laser spectroscopy

Passive spectroscopic measurements of Zeeman splitting have been used reliably to measure magnetic fields in plasmas for decades. However, a requirement is that the field magnitude must be sufficiently strong to be resolved over Doppler and instrument broadening (typically >10 000 G). A diagnostic for measuring magnetic fields spectroscopically well below this limit (>20 G) with high sensitivity has been developed at the Oak Ridge National Laboratory. The diagnostic relies on measuring a high resolution spectral profile using Doppler-free saturation spectroscopy (DFSS) and then fitting the spectrum to a quantum mechanical model. DFSS is an active, laser based technique that greatly reduces the influence of Doppler broadening and eliminates instrument broadening. To date, the diagnostic has been successfully employed to measure the magnetic field in magnetized (550-900 G), low-temperature (5-10 eV), low-density (10 10 –10 12 cm –3 ), hydrogen and helium plasmas in the 5-200 mTorr pressure range using a low power (25 mW) diode laser. Implementing an approximate crossover resonance model, the measurements are shown to be accurate within 5 G for helium and 83 G for hydrogen. The accuracy in hydrogen can be improved to 39 G if the crossover resonances are neglected. As a result, a more robust crossover model can decrease this error to <1 G.

47 OTHER INSTRUMENTATION↗

Summary of RF Technology Program Activities, October 2013 - September 2017

The goals of the National RF Research and Development Program (NRRDP) are to advance the basic understanding of high-power radio frequency (RF) in a plasma environment, and to maintain the high-power transmitters and cooling water systems required to support the ITER Ion Cylcotron Range of Frequencies (ICRF) transmission line high power component testing and operation of the Proto-Material Plasma Exposure eXperiment (MPEX) device. The work includes the study of the RF sheath, and development of RF-related diagnostics. These include active and passive spectroscopic diagnostics that can provide local and line integrated measurements of RF and Direct Current (DC) electric fields in the edge plasma of fusion devices, as well as measurements of other parameters. One of these, the Doppler Free Saturation Spectroscopy (DFSS) diagnostic, utilizes a laser beam split into two intersecting, counter-propagating pump and probe beams, whose intersection defines the measurement region. DFSS has demonstrated measurements of atomic spectra with 500 times greater resolution than passive Optical Emission Spectroscopy (OES). This allows Stark effect based electric field measurements to be made with two orders of magnitude high sensitivity than with OES. Measurements have been made using an ORNL electron-cyclotron resonant (ECR) plasma source producing densities up to 10 19 m -3 , in the vicinity of an RF-biased planar electrode.

47 OTHER INSTRUMENTATION↗

Helicon plasma ion temperature measurements and observed ion cyclotron heating in proto-MPEX

The Prototype-Material Plasma Exposure eXperiment (Proto-MPEX) linear plasma device is a test bed for exploring and developing plasma source concepts to be employed in the future steady-state linear device Material Plasma Exposure eXperiment (MPEX) that will study plasma-material interactions for the nuclear fusion program. The concept foresees using a helicon plasma source supplemented with electron and ion heating systems to reach necessary plasma conditions. Here in this paper, we discuss ion temperature measurements obtained from Doppler broadening of spectral lines from argon ion test particles. Plasmas produced with helicon heating alone have average ion temperatures downstream of the Helicon antenna in the range of 3 ± 1 eV; ion temperature increases to 10 ± 3 eV are observed with the addition of ion cyclotron heating (ICH). The temperatures are higher at the edge than the center of the plasma either with or without ICH. This type of profile is observed with electrons as well. Finally, a one-dimensional RF antenna model is used to show where heating of the plasma is expected.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Plasma source development for fusion-relevant material testing

Plasma facing materials in the divertor of a magnetic fusion reactor will have to tolerate steady-state plasma heat fluxes in the range of 10 MW/m2 for ~107 sec, in addition to fusion neutron fluences, which can damage the plasma facing materials to high displacements per atom (dpa) of ~50 dpa . Material solutions needed for the plasma facing components are yet to be developed and tested. The Materials Plasma Exposure eXperiment (MPEX) is a newly proposed steady state linear plasma device that is designed to deliver the necessary plasma heat flux to a target for this material testing, including the capability to expose a-priori neutron damaged material samples to those plasmas. The requirements of the plasma source needed to deliver this plasma heat flux are being developed on the Proto-MPEX device, which is a linear high-intensity radio frequency (RF) plasma source that combines a high-density helicon plasma generator with electron and ion heating sections. It is being used to study the physics of heating over-dense plasmas in a linear configuration. The helicon plasma is operated at 13.56 MHz with RF power levels up to 120 kW. Microwaves at 28 GHz (~30 kW) are coupled to the electrons in the over-dense helicon plasma via Electron Bernstein Waves (EBW), and ion cyclotron heating at 7-9 MHz (~30 kW) is via a magnetic beach approach. High plasma densities >6x1019/m3 have been produced in deuterium, with electron temperatures that can range from 2 to >10 eV. Operation with on-axis magnetic field strengths between 0.6 and 1.4 T is typical. The plasma heat flux delivered to a target can be > 10 MW/m2, depending on the operating conditions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Electric field determination in the plasma-antenna boundary of a lower-hybrid wave launcher in Tore Supra through dynamic Stark-effect spectroscopy

Interaction of radio-frequency (RF) waves with the plasma in the near-field of a high-power wave launcher is now seen to be important, both in understanding the channeling of these waves through the plasma boundary and in avoiding power losses in the edge. In a recent Letter a direct non-intrusive measurement of a near antenna RF electric field in the range of lower hybrid (LH) frequencies ($E_{LH}$) was announced (Phys. Rev. Lett., 110:215005, 2013). The measurement was achieved through the fitting of Balmer series deuterium spectral lines utilizing a time dependent (dynamic) Stark effect model. In this article, the processing of the spectral data is discussed in detail and applied to a larger range of measurements and the accuracy and limitations of the experimental technique is investigated. We find through an analysis of numerous Tore Supra pulses that good quantitative agreement exists between the measured and full-wave modeled $E_{LH}$ when the launched power exceeds 0.5MW. For low power the measurement becomes formidable utilizing the implemented passive spectroscopic technique because the spectral noise overwhelms the effect of the RF electric field on the line profile. Additionally, effects of the ponderomotive force are suspected at sufficiently high power.

47 OTHER INSTRUMENTATION↗