Engineering topics
Publications and source records attributed to Marsh, E. L..
New control system damps vibrations in rotating equipment with help of phase-locked-loop techniques. Vibrational modes are controlled by applying suitable currents to drive motor. Control signals are derived from sensors mounted on equipment.
Results of a study are presented suggesting that a Galileo Jupiter orbiting mission could be performed with a concentrated solar array power source. A baseline spacecraft design using concentrated arrays is given, and the overall spacecraft implications for attitude control, propulsion, power conditioning and the resultant spacecraft mass are examined. It is noted that while the concentrated array concept still requires extensive development effort, no insurmountable system level barriers preclude the use of a concentrated solar array on this difficult mission, with its stressing radiation environment, its lengthy periods of spacecraft shadowing as it passes behind Jupiter, and, finally, its large delta v burn required for orbital insertion.
Galileo is a dual-spin spacecraft designed to deliver a probe to Jupiter and then orbit the planet. The stator, or despun section, contains four flexible modes below 10 Hz and the despun actuator is separated from the inertial sensors by this flexibility. Control loop separation by bandwidth proved unacceptable due to performance requirements. To obtain the desired performance, a control scheme was devised which consists of three parts. First, flexibility damping and control notch filtering are accomplished by phase locked loop techniques. Second, slewing maneuvers are produced by torque profiles which are nonexcitatory to the structure. Finally, a low bandwidth perturbation controller is supplied to remove spacecraft disturbances.
Computer simulations were developed to evaluate the performance of four Experiment Pointing Mounts (EPM) being considered for Spacelab experiments in the 1980-1990 time frame. The system modeled compromises a multibody system consisting of the shuttle, a mechanical isolation device, the EPM, celestial and inertial sensors, bearings, gimbal torque motors and associated nonlinearities, the experiment payload, and control and estimator algorithms. Each mount was subjected to a common disturbance (shuttle vernier thruster firing and man push off) and command (stellar pointing or solar raster scan) input. The fundamental limitation common to all mounts was found to be sensor noise. System dynamics and hardware nonlinearities have secondary effects on pointing performance for sufficiently high bandwidth.
This paper describes some results of an attitude dynamics and control study for a solar sailing vehicle. This type of vehicle is currently under study and evaluation at JPL and has very high potential for interplanetary missions in and beyond the 1980s. Crucial to the success of such a vehicle would be the performance of its onboard attitude control system. Because of the vehicle's large size and its flexibility, vehicle deformations may have a potential for causing a degradation in vehicle performance. It may therefore be necessary for the control system to take into account the vehicle deformations as well as its rigid-body motions. Distributed parameter system analysis techniques are used in the paper to study certain fundamental aspects of such a control system for the sail vehicle. The techniques can, however, be more generally applicable to other large flexible vehicles.
Shuttle Experiment Pointing Mount System concepts and technology have been investigated and assessed with regard to payload requirements having a wide range of stability, accuracy, and control functions. Pointing systems were analyzed with end-mounted and center of gravity-mounted payloads viewing stellar and solar targets. Major error sources are identified with dynamical, stochastic, and nonlinear characteristics of structures, isolators, sensors, bearings, actuators, and controller. Results are presented which place a perspective on the potential of advanced technology to satisfy the most stringent sub-arc second pointing requirements.
A computer-controlled attitude and articulation control system is proposed for a spacecraft of extremely soft structure that uses two 8-kW solar arrays with an area of nearly 100 sq m each to power six electric propulsion thrusters. The purpose of the articulation control is to point the scientific instruments, to orient the antenna toward the earth, and to reorient the thrust vector as required for trajectory control. The attitude control system provides control both during the low-thrust phase of the mission and during long-term spinning modes.
The influence of large area solar array flexibility on the attitude control of a solar electric spacecraft is analyzed. The spacecraft consists of a rigid central body, two flexible roll-out solar arrays, and a cluster of three electric propulsion engines. Each engine has gimballing or translational capacity, or both, for attitude control purposes. A parametric stability study of various spacecraft configurations was made, using hybrid coordinate techniques in an eigenvalue analysis. Parameters varied were solar array aspect ratio, solar array first natural frequency, solar array rotation angle about the yaw axis, and sensor gain factors. Only the first six modes of solar array vibration were included in the study. The attitude response characteristics of the various spacecraft configurations were obtained by means of a digital computer simulation program of the system's equations of motion. The feasibility of using the thrusters for attitude control of electric propulsion spacecraft is demonstrated. It is also shown that although the dynamics effects of large-area flexible solar arrays can be harmful, changes in the control system parameters can insure stable attitude control.
Explore the source record for details and available documents.
A study of the elastic effects of large area solar arrays on attitude control of a spacecraft was conducted. It is demonstrated for sufficiently low structural frequencies that excitation of certain modes can induce instability in the pitch axis. Stiffening the arrays can eliminate the instability. However, a severe weight penalty is associated with such modification. A more efficient means of minimizing the structural interaction effects is to change the shape of the array. For stable configurations, another problem may be encountered. This is the imposition of high rates on the spacecraft bus by oscillation of the solar arrays. Since low rates are required to obtain accurate science experiment results, it is imperative that the high rate problem be resolved. This also is possible by changing the solar array configuration.
The proposed Morgantown public transportation system will use a fleet of computer-controlled vehicles operating on a separate dedicated network of roadways called a guideway. An automatic steering system on each vehicle will permit the traversal of the proposed route of various guideway sections. A preliminary study was made to analyze the steering control for the Morgantown vehicles. The primary requirement was to design an automatic steering system that would achieve a smooth ride and eliminate the need for excess margin in the guideway width. Front and rear wheel steering and front and rear sensing capabilities were assumed in the analysis. The system finally adopted front and rear wheel steering and front sensing was shown by computer simulation and vehicle steering experiments to be adequate.
Dynamic behavior and design procedures for spacecraft control system utilizing hybrid coordinates
abstract missing
Solar panel flexibility effect on attitude control of solar electric spacecraft for deep space mission