Engineering topics

Marmalyuk, A. A.

Publications and source records attributed to Marmalyuk, A. A..

5 records

DOE OSTI2020

AlGaInAs/InP semiconductor lasers with an ultra-narrow waveguide and an increased electron barrier

Semiconductor lasers based on AlGaInAs/InP heterostructures with an ultra-narrow waveguide and an increased electron barrier layer are developed. It is shown that the use of this waveguide in conjunction with profiled doping ensures a balance between internal optical losses and heat resistance. Additional use of strained wide-bandgap layers as blocking barriers limiting electron leakage from the active region makes it possible to increase the output power at the same pump current. The developed lasers with a stripe contact 100 μm wide demonstrate at room temperature an output optical power of 4.0 – 4.4 W (pump current 14 A) in a continuous-wave regime and 15 – 17 W (100 A) in a pulsed regime (100 ns, 1 kHz) at wavelengths of 1450 – 1500 nm. (paper)

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

DOE OSTI2020

Triple integrated laser – thyristor

A triple laser – thyristor, i. e., a semiconductor laser with three emitting sections monolithically integrated with an electronic switch (thyristor) is experimentally studied. For comparison, the output characteristics of single and double laser – thyristors are presented. It is shown that the functional integration of a laser with a thyristor in one heterostructure allows the laser to efficiently operate in a pulsed regime (output power ∼50 W), the use of vertical integration of two laser sections increases the power to ∼90 W, and the integration of three laser sections makes it possible to increase the output optical power to ∼120 W with all other conditions being the same. (paper)

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2020

Superluminescent diodes in the spectral range of 1.5 – 1.6 μm based on strain-compensated AlGaInAs/InP quantum wells

Superluminescent diodes based on AlGaInAs/InP separate-confinement double heterostructures with strain-compensated quantum wells are investigated. The influence of elastic strains in the active region on the output characteristics of the devices is analysed. It is shown that such a design of a superluminescent diode allows an optical power of more than 5 mW, a radiation spectrum width of more than 60 nm, a degree of output radiation polarisation up to 30 dB to be obtained at the output of a single-mode fibre, and has a great potential for further improvement. (paper)

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

DOE OSTI2020

1.5 – 1.6 μm semiconductor lasers with an asymmetric periodic optically coupled waveguide

High-power 1.5 – 1.6-μm semiconductor lasers with an asymmetric periodic optically coupled waveguide are developed and their current – voltage, light – current, and spectral characteristics are experimentally studied. The characteristics of these lasers are compared with the characteristics of traditional lasers based on double separate-confinement heterostructures. It is shown that the developed lasers have lower divergence and almost the same threshold and power characteristics as conventional lasers with Fabry – Perot resonators. The developed lasers with a cavity length of 1.6 mm and a mesa-stripe contact width of 3 μm mounted in a housing 11 mm in diameter have a power no lower than 200 mW at a pump current not exceeding 700 mA with a divergence of 25 – 35° versus 45° typical for conventional lasers. (lasers)

36 MATERIALS SCIENCE↗

DOE OSTI2020

Experimental studies of 1.5 – 1.6 μm high-power single-frequency semiconductor lasers

High-power semiconductor laser systems based on 1.5 – 1.6 μm single-frequency distributed feedback (DFB) lasers with a sidewall Bragg diffraction grating are developed and their current – voltage, light – current, and spectral characteristics are experimentally studied. The characteristics of conventional lasers with a Fabry – Perot cavity and DFB lasers fabricated from one and the same heterostructure are compared. At a pump current not exceeding 700 mA, a conventional laser with a cavity length of 1.6 mm and a mesa-stripe width of 3 μm emits a power no lower than 200 mW versus 150 mW of the DFB laser; both lasers are mounted in a housing 11 mm in diameter. The DFB laser mounted in a butterfly housing emits a power no lower than 100 mW at the exit of the single-mode cable at a pump current not exceeding 500 mA, which, at a 60 % coupling efficiency, corresponds to a power no lower than 165 mW; the side-mode suppression ratio in this case is no lower than 53 dB. It is shown that the wavelength deviation with changing pump current and temperature is almost an order of magnitude lower for the DFB laser than for the conventional laser. (paper)

36 MATERIALS SCIENCE↗