Engineering PapersSearch

Engineering topics

Margolis, Jack S.

Publications and source records attributed to Margolis, Jack S..

At least 19 records

Atmospheric CO2 retrieved from ground-based near IR solar spectra

The column-averaged volume mixing ratio (VMR) of CO2 over Kitt Peak, Arizona, has been retrieved from high-resolution solar absorption spectra obtained with the Fourier transform spectrometer on the McMath telescope. Simultaneous column measurements of CO2 at approx.6300/cm and O2 at approx.7900/cm were ratioed to minimize systematic errors. These column ratios were then scaled by the mean O2 VMR (0.2095) to yield column- averaged vmrs of CO2. These display similar behavior to the Mauna Loa in situ surface measurements. During the period 1977- 1995, the column-averaged mixing ratio of CO2 increased at an avenge rate of 1.49 +/- 0.04 ppmv/yr with seasonal variations of approx.7 ppmv peak-to-peak. Our retrievals demonstrate that this remote technique is capable of precisions better than 0.5%.

Yang, Zhong-Hua

Comparison Of Measurments Of Atmospheric Water Vapor

Report presents experimental intercomparison among measurements by four spectrometric instruments for determining concentration of atmospheric water vapor. Three instruments ground-based and needed to provide independent data to calibrate and validate measurements taken by fourth instrument, which is airborne visible/infrared imaging spectrometer (AVIRIS). Remote down-looking instruments like AVIRIS increases accuracy and coverage of water-vapor measurements.

Bruegge, Carol J.

Hydrogen broadening and collision-induced line shifts of methane at 4200/cm

Many of the lines of the nu1 + nu4 and nu3 + nu4 bands of methane in the vicinity of 4200/cm have been assigned and are reported in the HITRAN data-base which is commonly used for atmospheric transmission calculations in the IR. The collision-induced broadening coefficients of hydrogen for more than 200 of these lines are reported. Also, by using the water-vapor lines which occur in the spectra as calibration marks, the frequencies of the broadened lines are determined. This permitted the collision-induced line shifts to be measured for lines sufficiently isolated from interfering blends: all of the shifts which could be reliably determined in this way were negative.

Margolis, Jack S.

Water vapor column abundance retrievals during FIFE

A variation of the modified Langley plot algorithm is reported here and applied to the retrieval of atmospheric water column abundance from a filtered sunphotometer. In this new methodology an absorption data base (LOWTRAN 7) is used to compute a water abundance versus transmittance curve of growth, rather than the square-root dependence previously assumed. Validation of the technique is provided from an uncertainty analysis, and plans to further validate using Fourier transform spectrometers are detailed. The new sunphotometer technique is used to report local column water vapor during the First ISLSCP Field Experiment (FIFE), and comparisons are made with abundances retrieved via FIFE radiosonde observations. The sunphotometer data can best be utilized, however, to in turn validate data from airborne or in-orbit measurements of water vapor. With these flight sensors, horizontal and topographic variability within the scene can be viewed. An example of the airborne data set is given using an image from the airborne visible infrared imaging spectrometer, as acquired on August 31, 1990.

Bruegge, Carol J.

In-flight calibration of the spectral and radiometric characteristics of AVIRIS in 1991

On 7 Mar. 1991, an in-flight calibration experiment was held at the Ivanpah Playa in southeastern California for the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS) imaging spectrometer. Five AVIRIS overflights were acquired of a calibration target designated on the Ivanpah Playa surface. At the time of the overflights, the reflectance of the calibration target was measured with a field spectrometer. In addition, the atmospheric optical depths and water vapor abundance were measured from a radiometer station adjacent to the calibration target. These in-situ measurements were used to constrain the MODTRAN radiative transfer code to model the upwelling spectral radiance incident to the sensor aperture during the overflights. Analyses of this modeled radiance in conjunction with the laboratory-calibrated radiance were used to determine the spectral and radiometric calibration of AVIRIS while in flight.

Green, Robert O.

AVIRIS Spectrometer Maps Total Water Vapor Column

Airborne Visible/Infrared Imaging Spectrometer (AVIRIS) processes maps of vertical-column abundances of water vapor in atmosphere with good precision and spatial resolution. Maps provide information for meteorology, climatology, and agriculture.

Conel, James E.

Low temperature hydrogen broadened linewidths of ammonia in the (0,1,0,0)-(0,0,0,0) band at 200 K

Results are reported of extensive and systematic measurements of hydrogen broadening of the ammonia (0,1,0,0)-(0,0,0,0) band at 200 K. The measured linewidths for each of the observed branches in this band were determined with an average rms of 5 percent or less. Plots of the K manifolds for four of the five branches that were measured are presented. It is suggested that these width data can be used for analyzing atmospheric spectra of the outer planets and for validating theories of foreign-gas broadening of ammonia.

Margolis, Jack S.

Determination of the in-flight spectral and radiometric characteristics of the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS)

AVIRIS is a science research imaging spectrometer that measures radiance in 224 channels between 400 to 2450 nm in the electromagnetic spectrum. To determine the inflight spectral and radiometric characteristics of AVIRIS a validation and calibration experiment was performed. Five data sets were acquired over a calibration site on the homogeneous playa of Rogers Dry Lake, California, U.S. Surface reflectance, atmospheric optical depths, and atmospheric water vapor measurements were acquired concurrently with the overflights. These in situ measurements were used to constrain the LOWTRAN 7 radiative transfer code to predict the total spectral radiance incident at the AVIRIS aperture. These predicted radiances and the AVIRIS measured radiances were analyzed to validate the inflight characteristics. Inflight spectral channel positions and response functions over the AVIRIS spectral range were derived. Radiometric calibration coefficients were calculated for each channel as well as radiometric accuracy, intraflight stability, and noise equivalent delta radiance.

Green, Robert O.

In-flight validation and calibration of the spectral and radiometric characteristics of the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS)

Through an in-flight calibration experiment at Rogers Dry Lake, California on September 20, 1989, the radiometric and spectral properties of AVIRIS were determined. In-flight spectral channel positions and the spectral response function in 10 regions of the AVIRIS spectral range, taking in all four spectrometers, are shown to agree closely with the corresponding parameters measured in the laboratory. The intraflight stability for the Rogers Dry Lake calibration site is better than 2 percent with the exception of the strong atmospheric water absorptions where the measured radiance is close to zero. This experiment has provided both direct generation of an in-flight spectral and radiometric calibration and validation of the laboratory calibration at the reported level accuracy.

Green, Robert O.

In-situ atmospheric water-vapor retrieval in support of AVIRIS validation

A comparison is made between two ground-based atmospheric water-vapor measurement techniques, each of which uses data from a solar-pointing radiometer. One technique uses visible wavelength channels to retrieve aerosol loading, surface pressure readings for Rayleigh scattering analyses, and the 0.94 micron channel to extract water vapor from the residual of total versus scattering opacity. The other technique requires only the ratio of channels centered at 0.94 and 0.87 micron. Results are given for the April 13, 1989 AVIRIS in-flight calibration.

Bruegge, Carol J.

Two-Frequency Electro-Optic Gas-Correlation Spectrometer

Acoustical modulator not necessary. Two-frequency electro-optic gas-correlation spectrometer relatively simple. Illumination provided by ordinary lamp, no moving parts, and filtered output of detector is beat-frequency signal directly proportional to correlation between spectra of gases in cells.

Margolis, Jack S.

Phase-Modulation Gas-Correlation Spectroscopy

Electro-optic phase-modulation gas-correlation spectroscopy demonstrated in laboratory tests promising candidate technique for remote sensing of gases, temperatures, and wind velocities in atmosphere. In technique radiation emitted by sample atmosphere passed through electro-optic phase modulator, and modulated and unmodulated versions of spectrum alternately passed through reference absorption cell containing gas to be detected. Radiation emerging from reference cell band-pass filtered and detected. Correlation signal is difference in intensity between phase-modulated and unmodulated detected signals.

Rider, David M.

Measured line positions and strengths of methane between 5500 and 6180/cm

Calculations for the positions and strengths of over 2000 methane absorption lines stronger than 0.0001/sq cm per atm have been obtained in the 5500-6180/cm spectral region. Spectra were obtained at room temperature using the Fourier transform spectrometer at the Kitt Peak National Observatory solar telescope. The 2nu3 band strength of C-12H4 was shown to be 1.641/sq cm per atm. A Herman-Wallis-type correction of 1 + 0.0298 m + 0.000536 sq m was also found.

Margolis, Jack S.

Atmospheric water mapping with the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS), Mountain Pass, California

Observations are given of the spatial variation of atmospheric precipitable water using the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS) over a desert area in eastern California, derived using a band ratio method and the 940 nm atmospheric water band and 870 nm continuum radiances. The ratios yield total path water from curves of growth supplied by the LOWTRAN 7 atmospheric model. An independent validation of the AVIRIS-derived column abundance at a point is supplied by a spectral hygrometer calibrated with respect to radiosonde observations. Water values conform to topography and fall off with surface elevation. The edge of the water vapor boundary layer defined by topography is thought to have been recovered. The ratio method yields column abundance estimates of good precision and high spatial resolution.

Conel, James E.

In-flight radiometric calibration of the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS)

A reflectance-based method was used to provide an analysis of the in-flight radiometric performance of AVIRIS. Field spectral reflectance measurements of the surface and extinction measurements of the atmosphere using solar radiation were used as input to atmospheric radiative transfer calculations. Five separate codes were used in the analysis. Four include multiple scattering, and the computed radiances from these for flight conditions were in good agreement. Code-generated radiances were compared with AVIRIS-predicted radiances based on two laboratory calibrations (pre- and post-season of flight) for a uniform highly reflecting natural dry lake target. For one spectrometer (C), the pre- and post-season calibration factors were found to give identical results, and to be in agreement with the atmospheric models that include multiple scattering. This positive result validates the field and laboratory calibration technique. Results for the other spectrometers (A, B and D) were widely at variance with the models no matter which calibration factors were used. Potential causes of these discrepancies are discussed.

Conel, James E.

In-flight radiometric calibration of the airborne visible/infrared imaging spectrometer (AVIRIS)

A reflectance-based method was used to provide an analysis of the in-flight radiometric performance of AVIRIS. Field spectral reflectance measurements of the surface and extinction measurements of the atmosphere using solar radiation were used as input to atmospheric radiative transfer calculations. Five separate codes were used in the analysis. Four include multiple scattering, and the computed radiances from these for flight conditions were in good agreement. Code-generated radiances were compared with AVIRIS-predicted radiances based on two laboratory calibrations for a uniform highly reflecting natural dry lake target. For one spectrometer, the pre- and post-season calibration factors were found to give identical results, and to be in agreement with the atmospheric models that include multiple scattering. Results for the other spectrometers were widely at variance with the models no matter which calibration factors were used. Potential causes of these discrepancies are discussed.

Conel, James E.