Engineering Papers⌕ Search

Engineering topics

Malik, Mujeeb R.

Publications and source records attributed to Malik, Mujeeb R..

42 records · Page 3

Supersonic laminar-flow control

Detailed, up to date systems studies of the application of laminar flow control (LFC) to various supersonic missions and/or vehicles, both civilian and military, are not yet available. However, various first order looks at the benefits are summarized. The bottom line is that laminar flow control may allow development of a viable second generation SST. This follows from a combination of reduced fuel, structure, and insulation weight permitting operation at higher altitudes, thereby lowering sonic boom along with improving performance. The long stage lengths associated with the emerging economic importance of the Pacific Basin are creating a serious and renewed requirement for such a vehicle. Supersonic LFC techniques are discussed.

Bushnell, Dennis M.↗

Design and fabrication requirements for low noise supersonic/hypersonic wind tunnels

A schematic diagram of the new proposed Supersonic Low Disturbance Tunnel (SLDT) is shown. Large width two dimensional rapid expansion nozzles guarantee wide quiet test cores that are well suited for testing models at large angle of attack and for swept wings. Hence, this type of nozzle will be operated first in the new proposed large scale SLDT. Test results indicate that the surface finish of pilot nozzles is critical. The local roughness Reynolds number criteria R sub k is approx. = 10 will be used to specify allowable roughness on new pilot nozzles and the new proposed tunnel. Experimental data and calculations for M = 3.0, 3.5, and 5.0 nozzles give N-factors from 6 to 10 for transition caused by Goertler vortices. The use of N is approx. = 9.0 for the Goertler instability predicts quiet test cores in the new M = 3.5 and M = 6.0 axisymmetric long pilot nozzles that are 3 to 4 times longer than observed in the test nozzles to date. The new nozzles utilize a region of radial flow which moves the inflection point far downstream and delays the onset and amplification of the Goertler vortices.

Beckwith, Ivan E.↗

Experimental and theoretical investigation of boundary-layer instability mechanisms on a swept leading edge at Mach 3.5

A brief outline of the experimental and theoretical investigation of boundary layer instability mechanisms on a swept leading edge at Mach 3.5 is presented. Transition is affected by wind tunnel noise only when roughness is present. Local bar-R sub * Reynolds number and k/eta sub * are useful correlation parameters for a wide range of free stream Mach numbers. Stability theory is in good agreement with the experimental cross flow vortex wavelength. These conclusions are briefly discussed.

Creel, Theodore R., Jr.↗

The growth of Goertler vortices in compressible boundary layers

The linear instability of Goertler vortices in compressible boundary layers is considered. Using asymptotic methods in the high wavenumber regime, it is shown that a growth rate estimate can be found by solving a sequence of linear equations. The growth rate obtained in this way takes non-parallel effects into account and can be found much more easily than by ordinary differential equation eigenvalue calculations associated with parallel flow theories.

Hall, Philip↗

Prediction and control of transition in hypersonic boundary layers

In this paper, the role of compressible linear stability theory in prediction of boundary layer transition at supersonic and hypersonic speeds is investigated. Computations for sharp cones, using the e exp N method with N = 10, show that the first oblique Tollmien-Schlichting mode is responsible for transition at adiabatic wall conditions for freestream Mach numbers up to 7. For cold walls, the two-dimensional second mode dominates the transition process at lower hypersonic Mach numbers due to the well-known destabilizing effect of cooling on the second mode. It is shown that pressure gradient and suction may be used to stabilize this mode. Some results on the real gas effects on hypersonic boundary-layer stability are presented.

Malik, Mujeeb R.↗

Linear stability analysis of three-dimensional compressible boundary layers

A compressible stability analysis computer code is developed. The code uses a matrix finite-difference method for local eigenvale solution when a good guess for the eigenvalue is available and is significantly more computationally efficient than the commonly used inital-value approach. The local eigenvalue search procedure also results in eigenfunctions and, at little extra work, group velocities. A globally convergent eigenvalue procedure is also developed that may be used when no guess for the eigenvalue is available. The global problem is formulated in such a way that no unstable spurious modes appear so that the method is suitable for use in a black-box stability code. Sample stability calculations are presented for the boundary layer profiles of an LFC swept wing.

Malik, Mujeeb R.↗