Engineering topics

Malcolm, G. N.

Publications and source records attributed to Malcolm, G. N..

At least 19 records

NASA NTRS1991

Wing rock suppression using forebody vortex control

Static and free-to-roll tests were conducted in a water tunnel with a configuration that consisted of a highly-slender forebody and 78-deg sweep delta wings. Flow visualization was performed and the roll angle histories were obtained. The fluid mechanisms governing the wing rock of this configuration were identified. Different means of suppressing wing rock by controlling the forebody vortices using small blowing jets were also explored. Steady blowing was found to be capable of suppressing wing rock, but significant vortex asymmetries had to be induced at the same time. On the other hand, alternating pulsed blowing on the left and right sides of the forebody was demonstrated to be potentially an effective means of suppressing wing rock and eliminating large asymmetric moments at high angles of attack.

Ng, T. T.↗

NASA NTRS1990

Forebody vortex control as a complement to thrust vectoring

The desire to enhance the controllability of fighter aircraft at high angles of attack, particularly yaw control, has fostered an interest in both vectored thrust and active control of forebody vortices. This paper reviews several methods of forebody vortex control that have been investigated with water and wind tunnel tests of both generic and actual fighter configurations. The methods investigated include pneumatic or blowing techniques using surface-mounted jets and slots, surface suction, variable-height deployable strakes, and rotatable tip strakes. Flow visualization, and force and moment measurements have shown that all of the methods are effective in manipulating the forebody vortices over a wide range of angles of attack and sideslip, primarily through control over flow separation on the surface of the forebody. All are most effective when applied near the forebody tip. The advantages and limitations of the various methods are reviewed.

Malcolm, G. N.↗

NASA NTRS1986

Water facilities in retrospect and prospect: An illuminating tool for vehicle design

Water facilities play a fundamental role in the design of air, ground, and marine vehicles by providing a qualitative, and sometimes quantitative, description of complex flow phenomena. Water tunnels, channels, and tow tanks used as flow-diagnostic tools have experienced a renaissance in recent years in response to the increased complexity of designs suitable for advanced technology vehicles. These vehicles are frequently characterized by large regions of steady and unsteady three-dimensional flow separation and ensuing vortical flows. The visualization and interpretation of the complicated fluid motions about isolated vehicle components and complete configurations in a time and cost effective manner in hydrodynamic test facilities is a key element in the development of flow control concepts, and, hence, improved vehicle designs. A historical perspective of the role of water facilities in the vehicle design process is presented. The application of water facilities to specific aerodynamic and hydrodynamic flow problems is discussed, and the strengths and limitations of these important experimental tools are emphasized.

Erickson, G. E.↗

NASA NTRS1985

Recent developments in rotary-balance testing of fighter aircraft configurations at NASA Ames Research Center

Two rotary balance apparatuses were developed for testing airplane models in a coning motion. A large scale apparatus, developed for use in the 12-foot Pressure Wind Tunnel primarily to permit testing at high Reynolds numbers, was recently used to investigate the aerodynamics of 0.05-scale model of the F-15 fighter aircraft. Effects of Reynolds number, spin rate parameter, model attitude, presence of a nose boom, and model/sting mounting angle were investigated. A smaller apparatus, which investigates the aerodynamics of bodies of revolution in a coning motion, was used in the 6-by-6 foot Supersonic Wind Tunnel to investigate the aerodynamic behavior of a simple representation of a modern fighter, the Standard Dynamic Model (SDM). Effects of spin rate parameter and model attitude were investigated. A description of the two rigs and a discussion of some of the results obtained in the respective tests are presented.

Malcolm, G. N.↗

NASA NTRS1985

Recent developments in rotary-balance testing of fighter aircraft configurations at NASA Ames Research Center

Two rotary balance apparatuses were developed for testing airplane models in a coning motion. A large scale apparatus, developed for use in the 12-Foot Pressure Wind tunnel primarily to permit testing at high Reynolds numbers, was recently used to investigate the aerodynamics of 0.05-scale model of the F-15 fighter aircraft. Effects of Reynolds number, spin rate parameter, model attitude, presence of a nose boom, and model/sting mounting angle were investigated. A smaller apparatus, which investigates the aerodynamics of bodies of revolution in a coning motion, was used in the 6-by-6 foot Supersonic Wind Tunnel to investigate the aerodynamic behavior of a simple representation of a modern fighter, the Standard Dynamic Model (SDM). Effects of spin rate parameter and model attitude were investigated. A description of the two rigs and a discussion of some of the results obtained in the respective test are presented.

Malcolm, G. N.↗

NASA NTRS1985

Rotary-balance experiments on a modern fighter aircraft configuration at high Reynolds numbers

NASA Ames Research Center's research program to investigate high-angle-of-attack aerodynamic phenomena associated with high-performance aircraft includes the development and use of rotary balance apparatuses for wind balance apparatuses for wind tunnel tests of airplane models in a coning motion. A large scale apparatus, developed for testing models at high Reynolds numbers in the Ames 12-Foot Pressure Wind Tunnel, was recently tested with an 0.05-scale F-15 fighter model. Measurements were made at low subsonic Mach numbers and chord Reynolds numbers of 1 to 5.5 million, with angles of attack from 0 to 90 deg and sideslip angles from -15 to +15 deg. Effects of Reynolds number, spin-rate parameter, model attitude, presence of a nose boom, and model/sting mounting angle were investigated.

Malcolm, G. N.↗

NASA NTRS1983

Subsonic high-angle-of-attack aerodynamic characteristics of a cone and cylinder with triangular cross sections and a cone with a square cross section

Experiments were conducted in the 12-Foot Pressure Wind Tunnel at Ames Research Center on three models with noncircular cross sections: a cone having a square cross section with rounded corners and a cone and cylinder with triangular cross sections and rounded vertices. The cones were tested with both sharp and blunt noses. Surface pressures and force and moment measurements were obtained over an angle of attack range from 30 deg to 90 deg and selected oil-flow experiments were conducted to visualize surface flow patterns. Unit Reynolds numbers ranged from 0.8x1,000,000/m to 13.0x1,000,000/m at a Mach number of 0.25, except for a few low-Reynolds-number runs at a Mach number of 0.17. Pressure data, as well as force data and oil-flow photographs, reveal that the three dimensional flow structure at angles of attack up to 75 deg is very complex and is highly dependent on nose bluntness and Reynolds number. For angles of attack from 75 deg to 90 deg the sectional aerodynamic characteristics are similar to those of a two dimensional cylinder with the same cross section.

Clarkson, M. H.↗

NASA NTRS1981

Impact of high-alpha aerodynamics on dynamic stability parameters of aircraft and missiles

The aerodynamic phenomena associated with high angles of attack and their effects on the dynamic stability characteristics of airplane and missile configurations are examined. Information on dynamic effects is limited. Steady flow phenomena and their effects on the forces and moments are reviewed. The effects of asymmetric vortices and of vortex bursting on the dynamic response of flight vehicles are reviewed with respect to their influence on: (1) nonlinearity of aerodynamic coefficients with attitude, rates, and accelerations; (2) cross coupling between longitudinal and lateral directional models of motion; (3) time dependence and hysteresis effects; (4) configuration dependencey; and (5) mathematical modeling of the aerodynamics.

Malcolm, G. N.↗

NASA NTRS1981

Rotary and Magnus balances

Two wind tunnel techniques for determining part of the aerodynamic information required to describe the dynamic bahavior of various types of vehicles in flight are described. Force and moment measurements are determined with a rotary-balance apparatus in a coning motion and with a Magnus balance in a high-speed spinning motion. Coning motion is pertinent to both aircraft and missiles, and spinning is important for spin stabilized missiles. Basic principles of both techniques are described, and specific examples of each type of apparatus are presented. Typical experimental results are also discussed.

Malcolm, G. N.↗

NASA NTRS1980

Unsteady aerodynamics of conventional and supercritical airfoils

The unsteady aerodynamics of a conventional and a supercritical airfoil are compared by examining measured chordwise unsteady pressure time-histories from four selected flow conditions. Although an oscillating supercritical airfoil excites more harmonics, the strength of the airfoil's shock wave is the more important parameter governing the complexity of the unsteady flow. Whether they are conventional or supercritical, airfoils that support weak shock waves induce unsteady loads that are qualitatively predictable with classical theories; flows with strong shock waves are sensitive to details of the shock-wave and boundary-layer interaction and cannot be adequately predicted.

Davis, S. S.↗

NASA NTRS1980

Mathematical modeling of the aerodynamics of high-angle-of-attack maneuvers

This paper is a review of the current state of aerodynamic mathematical modeling for aircraft motions at high angles of attack. The mathematical model serves to define a set of characteristic motions from whose known aerodynamic responses the aerodynamic response to an arbitrary high angle-of-attack flight maneuver can be predicted. Means are explored of obtaining stability parameter information in terms of the characteristic motions, whether by wind-tunnel experiments, computational methods, or by parameter-identification methods applied to flight-test data. A rationale is presented for selecting and verifying the aerodynamic mathematical model at the lowest necessary level of complexity. Experimental results describing the wing-rock phenomenon are shown to be accommodated within the most recent mathematical model by admitting the existence of aerodynamic hysteresis in the steady-state variation of the rolling moment with roll angle. Interpretation of the experimental results in terms of bifurcation theory reveals the general conditions under which aerodynamic hysteresis must exist.

Schiff, L. B.↗

NASA NTRS1979

A study of viscous cross-flow effects on circular cylinders at high Reynolds numbers

Results of experimental studies on viscous cross-flow over circular cylinders for Reynolds numbers from 0.15 x 10 to the 6th to 10.9 x 10 to the 6th at Mach numbers of less than 0.3 are presented and compared with previous work where possible. Results presented include the variation of static cross-flow drag coefficients with both Reynolds number and ratio of surface roughness to model diameter, the variation of Strouhal number with Reynolds number and the dynamic variation of surface static pressure coefficients with both angular position around the cylinder and Reynolds number. The effects of end-plates on flow around two-dimensional bluff-bodies and of tunnel blockage on drag measurements are also discussed.

James, W. D.↗

NASA NTRS1979

Experiments in unsteady transonic flow

The static and dynamic response of a 0.5-m-chord airfoil were measured in the NASA-Ames 11- by 11-Foot Transonic Wind Tunnel. The effects of mean angle of attack, Reynolds number, oscillation mode, and frequency were investigated over a range of subsonic and transonic Mach numbers. Unsteady pressure distributions and loads on an oscillating NACA 64A010 airfoil are discussed. The unsteady pressure distributions are compared with classical subsonic theory and with newer unsteady aerodynamic codes. The experimental data are also used to assess the validity of linearity and modal superposition in the transonic-flow regime.

Davis, S. S.↗

NASA NTRS1978

New NASA-Ames wind-tunnel techniques for studying airplane spin and two-dimensional unsteady aerodynamics

Two new wind tunnel test apparatuses were developed at NASA-Ames Research Center. The first is a rotary-balance apparatus to be used in the Ames 12-Foot Pressure Tunnel for investigating the effects of Reynolds number, spin rate, and angle of attack on the aerodynamics of fighter and general aviation aircraft in a steady spin motion. The second apparatus provides capability for oscillating a large two dimensional wing (0.5 m chord, 1.35 m span) instrumented with steady and unsteady pressure transducers in the Ames 11 x 11 ft. Transonic Wind Tunnel. A complete description of both apparatuses, their capabilities, and some typical wind tunnel results are presented.

Malcolm, G. N.↗

NASA NTRS1978

Canard-body-tail missile test at angles of attack to 50 deg in the Ames 11-foot transonic wind tunnel

Blunted ogive cylinder missile models with a length-to-diameter ratio of 10.4 were tested at transonic speeds and large angles of attack in an 11 foot transonic wind tunnel. The configurations are: body, body with tail panels, body with canards, and body with canards and tails. Forces and moments from the entire model and each of the eight fins were measured over the pitch range of 20 deg to 50 deg, and roll angles of 0 deg to 45 deg and canard deflection angles between 0 deg and 15 deg. The Reynolds number ranged from 3.9 x 10 to the 6th power per meter. Large side forces and yawing moments were observed for some of the test cases involving a symmetric geometry.

Allen, C. Q.↗

NASA NTRS1978

New rotation-balance apparatus for measuring airplane spin aerodynamics in the wind tunnel

An advanced rotation-balance apparatus has been developed for the Ames 12-ft pressure tunnel to study the effects of spin rate, angles of attack and sideslip, and, particularly, Reynolds number on the aerodynamics of fighter and general aviation aircraft in a steady spin. Angles of attack to 100 deg and angles of sideslip to 30 deg are possible with spin rates to 42 rad/sec (400 rpm) and Reynolds numbers to 30 million/m on fighter models with wing spans that are typically 0.7 m. A complete description of the new rotation-balance apparatus, the sting/balance/model assembly, and the operational capabilities is given.

Malcolm, G. N.↗

NASA NTRS1978

A new two-dimensional oscillating wing apparatus for unsteady aerodynamics research

An apparatus for experimental research into unsteady transonic flows is described. The apparatus, as installed in the NASA-Ames 11 by 11 Foot Transonic Wind Tunnel, can impart full two-degree-of-freedom motions at reduced frequencies to 0.3, oscillatory amplitudes to tn-2 degs, mean angles to 12 degs, Mach numbers to 1.4 and Reynolds numbers to 12x10. The test wing is fully instrumented for dynamic waveform measurements and the data can be acquired, processed, and displayed in real-time with a new computational data acquisition system. Following a description of the apparatus, sample data from a recently completed test program is presented.

Davis, S. S.↗

NASA NTRS1977

A subsonic flow investigation on a research body at high angles of attack

Tests conducted in the Ames 12-foot pressure wind tunnel on a rotating research body at angles of attack of 45 to 90 deg yielded results that were inconsistent with simple cross-flow theory. Consequently, force and pressure distribution tests along with oil and sublimation flow-visualization studies were conducted in the same tunnel on a nonrotating model to attempt to explain the behavior observed in the rotary tests. These studies indicate that at appropriate conditions of Reynolds number and angle of attack, inflectional instabilities occur in the boundary layer that materially affect separation and, hence, the aerodynamic forces. Calculations of cross-flow Reynolds numbers are made and compared with other works on inflectional instability.

Clarkson, M. H.↗