Engineering Papers⌕ Search

Engineering topics

Magen, C.

Publications and source records attributed to Magen, C..

Indium segregation in Gd 5 (Si, Ge) 4 magnetocaloric materials

Chemical substitution is one of the most efficient tools to tune and optimize magnetic and magnetocaloric properties of the giant magnetocaloric materials. In particular, Indium substitutions could be useful both for tuning properties of these interesting intermetallic materials and to unveil their local-scale behavior across the magnetostructural transition via hyperfine techniques. Hence, in order to investigate the effect of Indium additions on the crystal structure, micro-structure, magnetic and magnetocaloric properties, a series of In-containing samples derived from the base Gd 5 Si 1.2 Ge 2.8 stoichiometry were prepared. Here, the major findings are that while In is insoluble in the 5:4 phase, it will instead promote the emergence of the impurity 5:3 phase and segregates into this phase. Hence, In leads to major crystallographic changes, which enhance atomic disorder and disrupt the Si to Ge ratio in the 5:4 phase. Subsequently, a higher 5:4 unit cell volume and a lower magnetic ordering temperature are found in the In-substituted samples. Finally, the magnetocaloric properties of the In-substituted samples reveal a detrimental effect on the maximum magnetic entropy change.

36 MATERIALS SCIENCE↗

Insights on the origin of the Tb5Ge4 magnetocaloric effect

In this report the magnetic, atomic structures and spin-lattice coupling have been thoroughly studied through high magnetic field magnetometry, Synchrotron X-ray diffraction under applied magnetic field and magnetostriction measurements in the Tb5Ge4 compounds. A field induced phase transition from an antiferromagnetic towards a ferromagnetic ordering was confirmed but with absence of structural transformation. This absence has been confirmed experimentally through synchrotron x-ray diffraction under applied field (up to 30 T). Moreover, this absence was explained via a thermodynamic free energy model: first principles calculations determined a large energy gap (ΔE=0.65 eV) between the two possible structures, O(I) and O(II). From magnetic and structural properties, a H-T phase diagram has been proposed for Tb5Ge4. Finally it was observed a large magnetostriction (up to 600 ppm) induced by ΔH=7 T.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Highly strained AlAs-type interfaces in InAs/AlSb heterostructures

Spontaneously formed Al-As type interfaces of the InAs/AlSb system grown by molecular beam epitaxy for quantum cascade lasers were investigated by atomic resolution scanning transmission electron microscopy. Experimental strain profiles were compared to those coming from a model structure. High negative out-of-plane strains with the same order of magnitude as perfect Al-As interfaces were observed. The effects of the geometrical phase analysis used for strain determination were evidenced and discussed in the case of abrupt and huge variations of both atomic composition and bond length as observed in these interfaces. Intensity profiles performed on the same images confirmed that changes of chemical composition are the source of high strain fields at interfaces. The results show that spontaneously assembled interfaces are not perfect but extend over 2 or 3 monolayers.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Abrupt GaP/Si hetero-interface using bistepped Si buffer

We evidence the influence of the quality of the starting Si surface on the III-V/Si interface abruptness and on the formation of defects during the growth of III-V/Si heterogeneous crystal, using high resolution transmission electron microscopy and scanning transmission electron microscopy. GaP layers were grown by molecular beam epitaxy on vicinal Si (001). The strong effect of the Si substrate chemical preparation is first demonstrated by studying structural properties of both Si homoepitaxial layer and GaP/Si heterostructure. It is then shown that choosing adequate chemical preparation conditions and subsequent III-V regrowth conditions enables the quasi-suppression of micro-twins in the epilayer. Finally, the abruptness of GaP/Si interface is found to be very sensitive to the Si chemical preparation and is improved by the use of a bistepped Si buffer prior to III-V overgrowth.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Formation of strained interfaces in AlSb/InAs multilayers grown by molecular beam epitaxy for quantum cascade lasers

Structural and chemical properties of InAs/AlSb interfaces have been studied by transmission electron microscopy. InAs/AlSb multilayers were grown by molecular beam epitaxy with different growth sequences at interfaces. The out-of-plane strain, determined using high resolution microscopy and geometrical phase analysis, has been related to the chemical composition of the interfaces analyzed by high angle annular dark field imaging. Considering the local strain and chemistry, we estimated the interface composition and discussed the mechanisms of interface formation for the different growth sequences. In particular, we found that the formation of the tensile AlAs-type interface is spontaneously favored due to its high thermal stability compared to the InSb-type interface. We also showed that the interface composition could be tuned using an appropriate growth sequence.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Elastic strains at interfaces in InAs/AlSb multilayer structures for quantum cascade lasers

InAs/AlSb multilayers similar to those used in quantum cascade lasers have been grown by molecular beam epitaxy on (001) InAs substrates. Elastic strain is investigated by high resolution transmission electron microscopy. Thin interfacial regions with lattice distortions significantly different from the strain of the AlSb layers themselves are revealed from the geometrical phase analysis. Strain profiles are qualitatively compared to the chemical contrast of high angle annular dark field images obtained by scanning transmission electron microscopy. The strain and chemical profiles are correlated with the growth sequences used to form the interfaces. Tensile strained AlAs-like interfaces tend to form predominantly due to the high thermal stability of AlAs. Strongly asymmetric interfaces, AlAs-rich and (Al, In)Sb, respectively, can also be achieved by using appropriate growth sequences.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Effects of pressure on the magnetic-structural and Griffiths-like transitions in Dy5Si3Ge

Magnetization studies have been performed on a polycrystalline sample of Dy5Si3Ge as a function of an applied magnetic field (up to 50 kOe) and hydrostatic pressure (up to 10 kbar) in the 5–300 K temperature range. The anomalous behavior of the magnetic susceptibility indicates that a Griffiths-like phase exists at low magnetic fields and pressures up to 10 kbar. We present evidence that the high-temperature second-order ferromagnetic transition can be coupled with the low-temperature first-order crystallographic transformation into a single first-order magnetic-crystallographic transformation using a magnetic field and hydrostatic pressure as tuning parameters. The effect of pressure on the Griffiths-like phase is reported and analyzed in the framework of the complex competition between the interslab and intraslab magnetic interactions.

36 MATERIALS SCIENCE↗

Optimized cobalt nanowires for domain wall manipulation imaged by in situ Lorentz microscopy

Direct observation of domain wall (DW) nucleation and propagation in focused electron beam induced deposited Co nanowires as a function of their dimensions was carried out by Lorentz microscopy (LTEM) upon in situ application of magnetic field. Optimal dimensions favoring the unambiguous DW nucleation/propagation required for applications were found in 500-nm-wide and 13-nm-thick Co nanowires, with a maximum nucleation field and the largest gap between nucleation and propagation fields. The internal DW structures were resolved using the transport-of-intensity equation formalism in LTEM images and showed that the optimal nanowire dimensions correspond to the crossover between the nucleation of transverse and vortex walls.

77 NANOSCIENCE AND NANOTECHNOLOGY↗