Engineering Papers⌕ Search

Engineering topics

Ma, H

Publications and source records attributed to Ma, H.

25 records · Page 2

Measurement of the response of the ATLAS liquid argon barrel calorimeter to electrons at the 2004 combined test-beam

During summer and fall 2004, the response of a full slice of the ATLAS barrel detector to different particles was studied in controlled beam. One module of the ATLAS liquid argon barrel calorimeter - identical to the production modules and read out by the final front-end and back-end electronics - was used for electromagnetic calorimetry. This paper presents and discusses the electron performance of the LAr barrel calorimeter, including linearity, uniformity, and resolution with different amounts of material upstream the calorimeter and energies ranging from 1 to 250 GeV.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Synchrotron X-ray Diffraction and Infrared Spectroscopy Studies of C60H18 Under High Pressure

In situ high-pressure angle-dispersive synchrotron X-ray diffraction and high-pressure mid-infrared (IR) spectrum measurements of C{sub 60}H{sub 18} were carried out up to 32 and 10.2 GPa, respectively. Our diffraction data indicated that the fcc structure of C{sub 60}H{sub 18} was stable up to 32 GPa. The bulk modulus B{sub 0} was determined to be 21 {+-} 1.16 GPa, about 40% higher than that of C{sub 60}. The C-H vibrations still existed up to 10.2 GPa, and the vibrational frequencies decreased with increasing pressure. IR-active vibrational frequencies and their corresponding eigenvectors of C{sub 60}H{sub 18} were simulated by DMOL{sup 3}. The effects of the hydrogen atoms attached to the fullerene molecular cage on the stability of the structure under high pressure are discussed.

08 HYDROGEN↗

High-flux Thin-film Nanofibrous Composite Ultrafiltration Membranes Containing Cellulose Barrier Layer

A novel class of thin-film nanofibrous composite (TFNC) membrane consisting of a cellulose barrier layer, a nanofibrous mid-layer scaffold, and a melt-blown non-woven substrate was successfully fabricated and tested as an ultrafiltration (UF) filter to separate an emulsified oil and water mixture, a model bilge water for on-board ship bilge water purification. Two ionic liquids: 1-butyl-3-methylimidazolium chloride and 1-ethyl-3-methylimidazolium acetate, were chosen as the solvent to dissolve cellulose under mild conditions. The regenerated cellulose barrier layer exhibited less crystallinity (determined by wide-angle X-ray diffraction, WAXD) than the original cotton linter pulps, but good thermal stability (determined by thermal gravimetric analysis, TGA). The morphology, water permeation, and mechanical stability of the chosen TFNCmembranes were thoroughly investigated. The results indicated that the polyacrylonitrile (PAN) nanofibrous scaffold was partially imbedded in the cellulose barrier layer, which enhanced the mechanical strength of the top barrier layer. The permeation flux of the cellulose-based TFNCmembrane was significantly higher (e.g. 10x) than comparable commercial UFmembranes (PAN10 and PAN400, Sepro) with similar rejection ratios for separation of oil/water emulsions. The molecular weight cut-off (MWCO) of TFNC membranes with cellulose barrier layer was evaluated using dextran feed solutions. The rejection was found to be higher than 90% with a dextran molecular weight of 2000 KDa, implying that the nominal pore size of the membrane was less than 50 nm. High permeation flux was also observed in the filtration of an emulsified oil/water mixture as well as of a sodium alginate aqueous solution, while high rejection ratio (above 99.5%) was maintained after prolonged operation. A variation of the barrier layer thickness could dramatically affect the permeation flux and the rejection ratio of the TFNCmembranes, while different sources of cellulose, ionic liquids, and non-woven supports did not. As ionic liquids can be recycled and reused without obvious decomposition, the chosen method also demonstrates a benign pathway to fabricate the cellulose barrier layer for other types of membranes.

36 MATERIALS SCIENCE↗

Low-Level Radio Frequency System Development for the National Synchrotron Light Source II

The National Synchrotron Light Source-II (NSLS-II) is a new ultra-bright 3GeV 3rd generation synchrotron radiation light source. The performance goals require operation with a beam current of 500mA and a bunch current of at least 0.5mA. The position and timing specifications of the ultra-bright photon beam imposes a set of stringent requirements on the performance of radio frequency (RF) control. In addition, commissioning and staged installation of damping wigglers and insertion devices requires the flexibility of handling varying beam conditions. To meet these requirements, a digital implementation of the LLRF is chosen, and digital serial links are planned for the system integration. The first prototype of the controller front-end hardware has been built, and is currently being tested.

43 PARTICLE ACCELERATORS↗

Study of the response of ATLAS electromagnetic liquid argon calorimeters to muons

The response of the ATLAS electromagnetic calorimeter to muons has been studied in this paper. Results on signal over noise ratio, assessment of the detector response uniformity, and position resolution are presented. The possibility to study fine details of the structure of the detector through its response to muons is illustrated on a specific example. Finally, the performance obtained on muons in test-beam is used to estimate the detector uniformity and time alignment precision that will be reachable after the commissioning of the ATLAS detector with cosmic rays.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗