Engineering topics
Luo, Kun
Publications and source records attributed to Luo, Kun.
Twisted-layer boron nitride ceramic with high deformability and strength
Moiré superlattices formed by twisted stacking in van der Waals materials have emerged as a new platform for exploring the physics of strongly correlated materials and other emergent phenomena. However, there remains a lack of research on the mechanical properties of twisted-layer van der Waals materials, owing to a lack of suitable strategies for making three-dimensional bulk materials. Here we report the successful synthesis of a polycrystalline boron nitride bulk ceramic with high room-temperature deformability and strength. This ceramic, synthesized from an onion-like boron nitride nanoprecursor with conventional spark plasma sintering and hot-pressing sintering, consists of interlocked laminated nanoplates in which parallel laminae are stacked with varying twist angles. The compressive strain of this bulk ceramic can reach 14% before fracture, about one order of magnitude higher compared with traditional ceramics (less than 1% in general), whereas the compressive strength is about six times that of ordinary hexagonal boron nitride layered ceramics. The exceptional mechanical properties are due to a combination of the elevated intrinsic deformability of the twisted layering in the nanoplates and the three-dimensional interlocked architecture that restricts deformation from propagating across individual nanoplates. The advent of this twisted-layer boron nitride bulk ceramic opens a gate to the fabrication of highly deformable bulk ceramics.
Disentangling the mechanism of temperature and water vapor modulation on ozone under a warming climate
Temperature and water vapor have been considered as important factors affecting ozone concentrations, however, their synergistic effect on ozone, as well as its response to a warming climate remains unclear. Here, numerical experiments with different combinations of climate and emissions highlighted opposite changes of annual ozone over the contiguous U.S. under scenarios with high vs. low ozone precursor emissions in the future with warming. Comparing the occurrence of heat waves on higher vs. lower ozone days, we found significant suppression of the heat wave exacerbation of ozone by anthropogenic emissions reductions. Variations of ozone with temperature (T) and water vapor (Q) over the western U.S. and southeastern U.S. in the simulations are clearly revealed through the construction of an O 3 -T-Q diagram. Based on the diagram, we further identified a T-dominant regime at higher temperatures where ozone increases with temperature increase, and a Q-dominant regime at lower temperatures where ozone decreases with temperature increase due to the negative effect of water vapor. With larger anthropogenic emission reductions, ozone may increase at a lower rate with temperature in the T-dominant regime, or even decrease with temperature in the Q-dominant regime. Our results show that with large emission reductions, substantial ozone pollution due to warming and increasing heat waves may be counteracted by water vapor, partly turning the ‘climate penalty’ on ozone into ‘climate benefit’. Hence controlling anthropogenic emissions may be an increasingly important strategy in a warmer and wetter climate to improve air quality and public health.
The effects of turbulence on the flame structure and NO formation of ammonia turbulent premixed combustion at various equivalence ratios
Ammonia is carbon-free and is regarded as a potential fuel to address global warming issues. Here, in this work, three-dimensional direct numerical simulations (DNS) of ammonia/air turbulent premixed flames were performed to explore the influence of turbulence and equivalence ratio on the flame structure and NO formation characteristics. Two equivalence ratios were considered, i.e. Φ=0.9 and Φ=1.1. The general flame structures were presented and species distributions were examined. The NO mass fraction was found to be the highest in the product for the lean case and in the reaction zone for the rich case. The conditional mean values of species mass fractions and reaction rates were compared with those of the unstrained and strained laminar premixed flames to explore how well the laminar flame structures can approach those of the turbulent flame. The budget analysis of the species transport equations showed that turbulent diffusion plays an important role in species transport. The turbulent diffusivity D T was estimated using the gradient hypothesis based on the DNS data. Various laminar flame simulations with different diffusivities were carried out. It was shown that the conditional means of the DNS agree well with those of the laminar flames including D T in the transport property calculation. The global and local NO formation characteristics were investigated. It was found that the mean NO production conditioned on the progress variable is lower compared with the corresponding laminar flame in the rich case. However, the relative contributions from various NO pathways are rarely affected by turbulence. The NO mass fraction is higher in negative curvature regions compared with positive curvature regions of the flame surface for the rich case, which is due to the preferential diffusion of H 2 and other radicals and the enhanced NO pathways in negatively curved regions.
DNS Of the ignition process of n-heptane/air premixed combustion with low-temperature chemistry in turbulent boundary layer
In the present work, three-dimensional direct numerical simulation (DNS) of n-heptane/air premixed combustion in turbulent boundary layer was performed to explore the near-wall ignition process with low -temperature chemistry. A reduced chemical mechanism with 58 species and 387 elementary reactions for n-heptane combustion was used in the DNS. The general characteristics of the ignition process near the wall were examined. Here, it was found that low-temperature ignition (LTI) dominates the upstream region, and high -temperature ignition (HTI) appears in the downstream region. The ignition process and the low-temperature chemistry pathways of the DNS are compared with those of a corresponding laminar case. It was found that the ignition process was affected by turbulence, which results in thickened reaction zones. However, the carbon flow analysis of low-temperature chemistry showed that turbulence rarely affects the low-temperature chemistry pathway. The combustion modes of various regions were scrutinized based on the budget terms of species transport equations and the chemical explosion mode analysis (CEMA). It was shown that the reaction term of RO 2 is significant during the LTI process of the upstream region, and the reaction terms of CH 2 O and CO 2 are evident in the downstream region, indicating the occurrence of HTI. It was also shown that auto-ignition is dominant in the upstream region. With increasing streamwise distance, the contribution of flame propagation increases, which takes over that of auto-ignition in the near-wall region.
Heat-treated glassy carbon under pressure exhibiting superior hardness, strength and elasticity
Glassy carbon (GC) is a type of non-graphitizing disordered carbon material at ambient pressure and high temperatures, which has been widely used due to its excellent mechanical properties. Here we report the changes in the microstructure and mechanical properties of GC treated at high pressures (up to 5 GPa) and high temperatures. The formation of intermediate sp 2 –sp 3 phases is identified at moderate treatment temperatures before the complete graphitization of GC, by analyzing synchrotron X-ray diffraction, Raman spectra, and transmission electron microscopy images. The intermediate metastable carbon materials exhibit superior mechanical properties with hardness reaching up to 10 GPa and compressive strength reaching as high as 2.5 GPa, nearly doubling those of raw GC, and improving elasticity and thermal stability. The synthesis pressure used in this study can be achieved in the industry on a commercial scale, enabling the scalable synthesis of this type of strong, hard, and elastic carbon materials.
Turbulence/flame/wall interactions in non-premixed inclined slot-jet flames impinging at a wall using direct numerical simulation
In this paper, three-dimensional turbulent non-premixed oblique slot-jet flames impinging at a wall were investigated using direct numerical simulation (DNS). Two cases are considered with the Damköhler number (Da) of case A being twice that of case B. A 17 species and 73-step mechanism for methane combustion was employed in the simulations. It was found that flame extinction in case B is more prominent compared to case A. Reignition in the lower branch of combustion for case A occurs when the scalar dissipation rate relaxes, while no reignition occurs in the lower branch for case B due to excessive scalar dissipation rate. A method was proposed to identify the flame quenching edges of turbulent non-premixed flames in wall-bounded flows based on the intersections of mixture fraction and OH mass fraction iso-surfaces. The flame/wall interactions were examined in terms of the quenching distance and the wall heat flux along the quenching edges. There is essentially no flame/wall interaction in case B due to the extinction caused by excessive turbulent mixing. In contrast, significant interactions between flames and the wall are observed in case A. The quenching distance is found to be negatively correlated with wall heat flux as previously reported in turbulent premixed flames. The influence of chemical reactions and wall on flow topologies was identified. The FS/U and FC/U topologies are found near flame edges, and the NNN/U topology appears when reignition occurs. The vortex-dominant topologies, FC/U and FS/S, play an increasingly important role as the jet turbulence develops.
The impact of the atmospheric turbulence-development tendency on new particle formation: a common finding on three continents
Abstract A new mechanism of new particle formation (NPF) is investigated using comprehensive measurements of aerosol physicochemical quantities and meteorological variables made in three continents, including Beijing, China; the Southern Great Plains site in the USA; and SMEAR II Station in Hyytiälä, Finland. Despite the considerably different emissions of chemical species among the sites, a common relationship was found between the characteristics of NPF and the stability intensity. The stability parameter (ζ = Z/L, where Z is the height above ground and L is the Monin–Obukhov length) is found to play an important role; it drops significantly before NPF as the atmosphere becomes more unstable, which may serve as an indicator of nucleation bursts. As the atmosphere becomes unstable, the NPF duration is closely related to the tendency for turbulence development, which influences the evolution of the condensation sink. Presumably, the unstable atmosphere may dilute pre-existing particles, effectively reducing the condensation sink, especially at coarse mode to foster nucleation. This new mechanism is confirmed by model simulations using a molecular dynamic model that mimics the impact of turbulence development on nucleation by inducing and intensifying homogeneous nucleation events.
Direct numerical simulation of turbulent boundary layer premixed combustion under auto-ignitive conditions.
Abstract not provided.
Turbulence/flame/wall interactions in non-premixed inclined slot-jet flames impinging at a wall using direct numerical simulation.
Abstract not provided.
Direct numerical simulations of turbulent stratified premixed jet combustion under MILD and conventional conditions.
Abstract not provided.
Turbulence evaporation and combustion interactions in n-heptane sprays under high pressure conditions using DNS.
Abstract not provided.