Engineering topics

Logvenov, Gennady

Publications and source records attributed to Logvenov, Gennady.

6 records

DOE OSTI2023

Atomic-layer engineering of nickelates (in search of novel superconductors)

Karl Alex Mueller's intuition was that the nature of mobile charge carriers in manganates and nickelates should be like those in cuprates, which he believed were Jahn-Teller polarons, so he expected them to also host high-temperature superconductivity (HTS). Following his suggestions and persuasion, in the past, we performed several experiments that included atomic-layer-by-layer synthesis of novel, metastable manganates and nickelates. Despite our efforts and several USO sightings, here we failed to find any reproducible superconductivity and dropped the project fifteen years ago. Our results are presented here, for the first time - timely, since HTS was very recently discovered in nickelates (under pressure). So, whether his opinions were on the mark or not, Alex did guess it right - again.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2022

Imaging mesoscopic antiferromagnetic spin textures in the dilute limit from single-geometry resonant coherent x-ray diffraction

The detection and manipulation of antiferromagnetic domains and topological antiferromagnetic textures are of central interest to solid-state physics. A fundamental step is identifying tools to probe the mesoscopic texture of an antiferromagnetic order parameter. In this work, we demonstrate that Bragg coherent diffractive imaging can be extended to study the mesoscopic texture of an antiferromagnetic order parameter using resonant magnetic x-ray scattering. We study the onset of the antiferromagnet transition in PrNiO 3 , focusing on a temperature regime in which the antiferromagnetic domains are dilute in the beam spot and the coherent diffraction pattern modulating the antiferromagnetic peak is greatly simplified. We demonstrate that it is possible to extract the arrangements and sizes of these domains from single diffraction patterns and show that the approach could be extended to a time-structured light source to study the motion of dilute domains or the motion of topological defects in an antiferromagnetic spin texture.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Visualizing the unusual spectral weight transfer in DyBa2Cu3O7–δ thin film

Abstract We report a Spectroscopic Imaging Scanning Tunneling Microscopy (SI-STM) study of a DyBa 2 Cu 3 O 7-δ (DBCO) thin film ( T c ~ 79 K) synthesized by the molecular beam epitaxy (MBE). We observed an unusual transfer of spectral weight in the local density of states (LDOS) spectra occurring only within the superconducting gap. By a systematic control of the tip-sample distance and the junction resistance, we demonstrate that the spectral weight transfer can be switched at a nano-meter length scale. These results suggest that an interaction between the STM tip and the sample alters the electronic configurations in the film. This probably originates from a combination of an intrinsic band bending at the interface between the surface and the bulk, and a tip-induced band bending. These results may open a new avenue for band engineering and applications of thin films of high- T c cuprates.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2020

Homogeneous superconducting gap in Dy Ba 2 Cu 3 O 7 - δ synthesized by oxide molecular beam epitaxy

Much of what is known about high-temperature cuprate superconductors stems from studies based on two surface analytical tools, angle-resolved photoemission spectroscopy (ARPES) and spectroscopic imaging scanning tunneling microscopy (SI-STM). A question of general interest is whether and when the surface properties probed by ARPES and SI-STM are representative of the intrinsic properties of bulk materials. We find this question is prominent in thin films of a rarely studied cuprate Dy Ba 2 Cu 3 O 7 - δ DBCO). We synthesize DBCO films by oxide molecular beam epitaxy and study them by in situ ARPES and SI-STM. Both ARPES and SI-STM show that the surface DBCO layer is different from the bulk of the film—it is heavily underdoped, while the doping level in the bulk is close to optimal doping evidenced by bulk-sensitive mutual inductance measurements. ARPES shows the typical electronic structure of a heavily underdoped CU O 2 plane and two sets of one-dimensional bands originating from the CuO chains with one of them gapped. SI-STM reveals two different energy scales in the local density of states, with one (at ~ 18 meV ) corresponding to the superconductivity and the other one (at ~ 90 meV ) to the pseudogap. Finally, while the pseudogap shows large variations over the length scale of a few nanometers, the superconducting gap is very homogeneous. This indicates that the pseudogap and superconductivity are of different origins.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2019

Local metallic and structural properties of the strongly correlated metal $\mathrm{LaNiO_3}$ using $\mathrm{^8Li β-NMR}$

We report β-detected NMR of ion-implanted $\mathrm{^8Li}$ in a single crystal and thin film of the strongly correlated metal $\mathrm{LaNiO_3}$. Spin-lattice relaxation measurements reveal two distinct local environments, both metallic as evident from $T$-linear Korringa $\mathrm{1/T_1}$ below $\mathrm{200K}$ with slopes comparable to other metals. A small approximately temperature-independent Knight shift of $\mathrm{~74 ppm}$ is observed, yielding a normalized Korringa product characteristic of substantial antiferromagnetic correlations.We find no evidence for a magnetic transition from 4 to $\mathrm{310 K}$. The similarity of these features in the two very different samples indicates that they are intrinsic and unrelated to dilute oxygen vacancies. We attribute the two environments to two distinct but similar crystallographic $\mathrm{^8Li}$ sites and not to any form of phase inhomogeneity, but this is inconsistent with the conventional rhombohedral structure of $\mathrm{LaNiO_3}$, and also cannot be simply explained by the common alternative orthorhombic or monoclinic distortions.

36 MATERIALS SCIENCE↗

DOE OSTI2012

High temperature interfacial superconductivity

High-temperature superconductivity confined to nanometer-scale interfaces has been a long standing goal because of potential applications in electronic devices. The spontaneous formation of a superconducting interface in bilayers consisting of an insulator (La.sub.2CuO.sub.4) and a metal (La.sub.1-xSr.sub.xCuO.sub.4), neither of which is superconducting per se, is described. Depending upon the layering sequence of the bilayers, T.sub.c may be either .about.15 K or .about.30 K. This highly robust phenomenon is confined to within 2-3 nm around the interface. After exposing the bilayer to ozone, T.sub.c exceeds 50 K and this enhanced superconductivity is also shown to originate from a 1 to 2 unit cell thick interfacial layer. The results demonstrate that engineering artificial heterostructures provides a novel, unconventional way to fabricate stable, quasi two-dimensional high T.sub.c phases and to significantly enhance superconducting properties in other superconductors. The superconducting interface may be implemented, for example, in SIS tunnel junctions or a SuFET.

36 MATERIALS SCIENCE↗