Engineering topics

Lockwood, A.

Publications and source records attributed to Lockwood, A..

5 records

NASA NTRS1987

Effect of the microstructure on the thermoelectric properties of polycrystalline lanthanum chalcogenides

Small amounts of second phase materials can have important effects on the thermoelectric properties of polycrystalline gamma-La(3-x)X4 (X-S, Te; X in the range of 0 to 1/3). Microscopic examination by SEM of hot pressed La(3-x)Te4 samples has revealed from 1-5 vol. pct of La2O2Te, an amount which is not detected by X-ray powder diffraction measurements. This amount of La2O2Te resulting from oxygen contamination can reduce the concentration of electrons by as much as 10 to 75 percent below the electron concentration calculated for single phase La(3-x)Te4 in the composition range of greatest interest. Small amounts of second phase materials can also lower the lattice thermal conductivity by scattering low frequency phonons. These results indicate that microstructural effects should be considered when electrical and thermal properties of polycrystalline materials are analyzed.

Lockwood, A.↗

NASA NTRS1985

Thermoelectric properties of lanthanum sulfide

The Seebeck coefficient, electrical resistivity, thermal conductivity, and Hall effect have been studied in gamma-phase La(3-x)S4(LaS/y/) for compositions with x in the range from 0.04 to 0.3 (y in the range from 1.35 to 1.48) in order to ascertain its suitability for high-temperature (300 to 1400 K) thermoelectric energy conversion. In this temperature and composition range the material behaves as an extrinsic semiconductor whose degenerate carrier concentration is controlled by the stoichiometric ratio of La to S. A maximum figure-of-merit (Z) of approximately 0.0005 per K at a composition x = 0.3, y = 1.48 (LaS/1.48/) was obtained.

Wood, C.↗

NASA NTRS1984

High temperature Hall-effect apparatus

A high-temperature Hall-effect apparatus is described which allows measurements up to temperatures greater than 1200 K using the van der Pauw method. The apparatus was designed for measurements on refractory materials having high charge carrier concentrations and generally low mobilities. Pressure contacts are applied to the samples. Consequently, special contacting methods, peculiar to a specific sample material, are not required. The apparatus has been semiautomated to facilitate measurements. Results are presented on n- and p-type silicon.

Wood, C.↗

NASA NTRS1981

Advanced high temperature thermoelectrics for space power

Preliminary results from a spacecraft system study show that an optimum hot junction temperature is in the range of 1500 K for advanced nuclear reactor technology combined with thermoelectric conversion. Advanced silicon germanium thermoelectric conversion is feasible if hot junction temperatures can be raised roughly 100 C or if gallium phosphide can be used to improve the figure of merit, but the performance is marginal. Two new classes of refractory materials, rare earth sulfides and boron-carbon alloys, are being investigated to improve the specific weight of the generator system. Preliminary data on the sulfides have shown very high figures of merit over short temperature ranges. Both n- and p-type doping have been obtained. Pure boron-carbide may extrapolate to high figure of merit at temperatures well above 1500 K but not lower temperature; n-type conduction has been reported by others, but not yet observed in the JPL program. Inadvertant impurity doping may explain the divergence of results reported.

Lockwood, A.↗

NASA NTRS1980

Advanced thermoelectric material development at JPL

A large number of planetary missions under consideration for the next two decades will be using radioisotope thermoelectric generators to provide the necessary spacecraft electrical power. Performance, reliability, lifetime and cost of these RTGs are expected to be more demanding and will require the development of advanced thermoelectric materials. An advanced thermoelectric materials development program is being conducted by JPL and is the subject of this paper. Under this program, alloys of rare earth chalcogenides have been synthesized and their thermoelectric properties evaluated. The selection of specific compounds on which the program is currently concentrating is influenced by criteria such as low thermal conductivity, reasonably high operating temperatures (not less than 1000 C) and stability of the compounds. The paper discusses the rationale, approach and current status of the program. In addition, the thermoelectric and thermophysical property measurement used to evaluate the materials are described. The preliminary results and analysis of these experimental data are also given.

Stapfer, G.↗