Engineering topics
Publications and source records attributed to Lobb, V. B..
Surface measured with accuracy better than 10 to the negative fifth power times diameter. Report describes use of advanced close-range photogrammetry to determine deviations of 34-m-diameter antenna main reflector and subreflector from nominal paraboloidal shapes. Measurements enable removal of linear offsets and angular misalignments of subreflector, with consequent increase of 4 percent in aperture efficiency.
Two models are provided of the Deep Space Network (DSN) 70 m antenna performance at Ka-band (32 GHz) and, for comparison purposes, one at X-band (8.4 GHz). The baseline 70 m model represents expected X-band and Ka-band performance at the end of the currently ongoing 64 m to 70 m mechanical upgrade. The improved 70 m model represents two sets of Ka-band performance estimates (the X-band performance will not change) based on two separately developed improvement schemes: the first scheme, a mechanical approach, reduces tolerances of the panels and their settings, the reflector structure and subreflector, and the pointing and tracking system. The second, an electronic/mechanical approach, uses an array feed scheme to compensate fo lack of antenna stiffness, and improves panel settings using microwave holographic measuring techniques. Results are preliminary, due to remaining technical and cost uncertainties. However, there do not appear to be any serious difficulties in upgrading the baseline DSN 70 m antenna network to operate efficiently in an improved configuration at 32 GHz (Ka-band). This upgrade can be achieved by a conventional mechanical upgrade or by a mechanical/electronic combination. An electronically compensated array feed system is technically feasible, although it needs to be modeled and demonstrated. Similarly, the mechanical upgrade requires the development and demonstration of panel actuators, sensors, and an optical surveying system.
Two riveted antenna panels on rings number 3 and 9 were removed from the 34m antenna at DSS-15, fixed in the leveled position and the surface was photographed indoors. The results from this pilot photogrammetric demonstration and diagnostics of panel surface contours, are presented. The photogrammetric network for each panel incorporated eight photographs, two from each of four camera stations and observed over 200 targets. The accuracy (1 sigma) of the XYZ coordinates for the error ellipsoids was + or - 0.013 mm (0.0005 inch). This level of precision relative to the object size corresponds roughly to 1 part in 250,000 which is superior to conventional dial sweep-arm template techniques by at least a factor of 4.
The 26-meter S-X conversion project provides for the conversion of an existing 26-meter S-band subnet to a 34-meter S- and X-band subnet. The subnet chosen for conversion consists of the following stations: DSS 12 near Barstow, DSS 44 in Australia, and DSS 62 in Spain. The main subsystems effected by this project are the antenna mechanical, antenna microwave, and receiver-exciter. In addition to these, there are many project-related electronic equipments that have been added to the existing station equipment. The major subsystems are essentially through the design stage with the antenna mechanical subsystem completed through detail design with procurement in process.
System for testing bolts with various platings, lubricants, nuts, and tightening procedures tests 200 fasteners, and processes and summarizes the results, within one month. System measures input torque, nut rotation, bolt clamping force, bolt shank twist, and bolt elongation, data is printed in report form. Test apparatus is described.