Engineering Papers⌕ Search

Engineering topics

Livingston, J. M.

Publications and source records attributed to Livingston, J. M..

69 records · Page 4

Aerosol spectral optical depths - Jet fuel and forest fire smokes

The Ames autotracking airborne sun photometer was used to investigate the spectral depth between 380 and 1020 nm of smokes from a jet fuel pool fire and a forest fire in May and August 1988, respectively. Results show that the forest fire smoke exhibited a stronger wavelength dependence of optical depths than did the jet fuel fire smoke at optical depths less than unity. At optical depths greater than or equal to 1, both smokes showed neutral wavelength dependence, similar to that of an optically thin stratus deck. These results verify findings of earlier investigations and have implications both on the climatic impact of large-scale smokes and on the wavelength-dependent transmission of electromagnetic signals.

Pueschel, R. F.↗

Optical depth measurements and atmospheric correction of remotely sensed data for FIFE

Data derived from an airborne tracking-sun photometer are used to provide quantitative corrections for atmospheric effects in remotely sensed data. The atmospheric correction involves the validation of radiometric and atmospheric measurements and the application of single scattering approximation which permits the separation of Rayleigh scattering from aerosol scattering. Sun-photometer data are used to generate plots of spectral optical depths, aerosol size distributions, aerosol phase functions, and aerosol single-scattering albedos. The atmospheric correction model and the atmospheric optical properties are incorporated into a program which is applied to two flightlines of data. Atmospheric corrections tested on remotely sensed data permitted the removal of limb brightening, although the results require verification by means of ground measurements.

Wrigley, R. C.↗

Type I polar stratospheric cloud particles - Concentration, shape, size, light extinction

Results from the flight on January 24, 1989 of the Airborne Arctic Stratospheric Experiment during which the ER-2 aircraft transitioned from unsaturated to ice saturated air at 20 km altitude are presented. Aerosol particles were sampled by wire impactors and examined for number density as a function of particle size by taking photomicrographs in a scanning electron microscope and visually sizing and counting the particles. Differences in the chemical, physical and optical properties of stratospheric aerosol between ice-saturated and nonsaturated air are described.

Pueschel, R. F.↗

Comparison of in situ aerosol measurements with SAGE 2 and SAM 2 aerosol measurements during the airborne Antarctic ozone experiment

Models indicate that stratospheric aerosols play a major role in the destruction of ozone during the Austral winter. Although many in situ measurements of stratospheric aerosols were made during the Airborne Antarctic Ozone Experiment, changes of aerosol concentration and size distributions across the polar vortex are important to understanding changes of chemical species taking place during this time. Therefore comparing the in situ measurements with measurements made by satellites scanning wider areas will give a clearer picture of the possible role played by aerosols during this period. The wire impactor size distributions are compared to those from the aerosol spectrometers and a best fit size distribution determined. Aerosol extinctions are calculated from the in situ measurements and compared to the extinctions measured by the satellites. Five comparisons are made with SAGE 2 and four with SAM 2. Extinctions agree as close as a factor of two.

Ferry, G. V.↗

Cloud and aerosol optical depths

An airborne Sun photometer was used to measure optical depths in clear atmospheres between the appearances of broken stratus clouds, and the optical depths in the vicinity of smokes. Results show that (human) activities can alter the chemical and optical properties of background atmospheres to affect their spectral optical depths. Effects of water vapor adsorption on aerosol optical depths are apparent, based on data of the water vapor absorption band centered around 940 nm. Smoke optical depths show increases above the background atmosphere by up to two orders of magnitude. When the total optical depths measured through clouds were corrected for molecular scattering and gaseous absorption by subtracting the total optical depths measured through the background atmosphere, the resultant values are lower than those of the background aerosol at short wavelengths. The spectral dependence of these cloud optical depths is neutral, however, in contrast to that of the background aerosol or the molecular atmosphere.

Pueschel, R. F.↗

Effects of El Chichon volcanic effluents on stratospheric aerosol dynamics

The effects of El Chichon's April 1982 eruption on stratospheric aerosol dynamics are presently discussed in terms of log-normal size distributions over 15-20 km sample altitudes between 30 and 45 deg N over the contiguous U.S. After collection, samples were studied by SEM, and log-normal size distributions were fitted to the data-points obtained. It is found that stratospheric aerosol behavior is explainable by the laws of aerosol mechanics more easily than has been the case for tropospheric aerosol, for which the source-sink relationship is much more complex.

Pueschel, R. F.↗

Measurements with an airborne, autotracking, external-head sunphotometer

Design and performance features and sample results from use of a NASA airborne tracking sunphotometer (ATS) are described. The ATS was devised to obtain continuous vertical profiles of the optical depth and transmissivity, first from a CV-990 aircraft and then from a modified DC-8 aircraft. Sample results are presented from a 1985 flight as part of the SAGE-II calibration mission, which featured detectors frequencies of 380, 450, 600, 860, 940, and 1020 microns and covered flight altitudes from ground to 10 km.

Russell, P. B.↗

Retrieval of aerosol size distribution moments from multiwavelength particulate extinction data

An iterative method for deriving the particle size distribution from multiwavelength satellite remote sensing data is presented and its use illustrated with an application to SAGE II data. The compression size distribution method (CSD) features interpolation and look-up features for relating the coefficients of a least-squares fit as a function of wavelength to parameters of the compression function that have been obtained by Mie calculations. Results are reported of comparisons between particulate radii predicted for the El Chichon volcano aerosol based on SAGE II data and 14 radii measured with NASA flights through the aerosol with aircraft carrying wire impactors.

Livingston, J. M.↗

Slant-lidar aerosol extinction measurements and their relation to measured and calculated albedo changes

Lidar and albedo data for a single day on which aerosols increased the surface plus atmospheric albedo above values measured on two surrounding very clean days are presented. The slant-lidar extinction measurement technique used is described along with the equipment and operating procedures. The derivation of optical depths, backscatter-to-extinction ratios, and extinction profiles is addressed, and the use of the lidar-derived optical depths in calculating expected albedo change is considered. Measured and calculated albedo changes are compared, and the results are found to agree within experimental uncertainties.

Russell, P. B.↗

Orbiting lidar simulations. I - Aerosol and cloud measurements by an independent-wavelength technique

Aerosol and cloud measurements have been simulated for a Space Shuttle lidar. Expected errors - in signal, transmission, density, and calibration - are calculated algebraically and checked by simulating measurements and retrievals using random-number generators. By day, vertical structure is retrieved for tenuous clouds, Saharan aerosols, and boundary layer aerosols (at 0.53 and 1.06 micron) as well as strong volcanic stratospheric aerosols (at 0.53 micron). By night, all these constituents are retrieved plus upper tropospheric and stratospheric aerosols (at 1.06 micron), mesospheric aerosols (at 0.53 micron), and noctilucent clouds (at 1.06 and 0.53 micron). The vertical resolution was 0.1-0.5 km in the troposphere, 0.5-2.0 km above, except 0.25-1.0 km in the mesospheric cloud and aerosol layers; horizontal resolution was 100-2000 km.

Russell, P. B.↗

Improved simulation of aerosol, cloud, and density measurements by shuttle lidar

Data retrievals are simulated for a Nd:YAG lidar suitable for early flight on the space shuttle. Maximum assumed vertical and horizontal resolutions are 0.1 and 100 km, respectively, in the boundary layer, increasing to 2 and 2000 km in the mesosphere. Aerosol and cloud retrievals are simulated using 1.06 and 0.53 microns wavelengths independently. Error sources include signal measurement, conventional density information, atmospheric transmission, and lidar calibration. By day, tenuous clouds and Saharan and boundary layer aerosols are retrieved at both wavelengths. By night, these constituents are retrieved, plus upper tropospheric, stratospheric, and mesospheric aerosols and noctilucent clouds. Density, temperature, and improved aerosol and cloud retrievals are simulated by combining signals at 0.35, 1.06, and 0.53 microns. Particlate contamination limits the technique to the cloud free upper troposphere and above. Error bars automatically show effect of this contamination, as well as errors in absolute density nonmalization, reference temperature or pressure, and the sources listed above. For nonvolcanic conditions, relative density profiles have rms errors of 0.54 to 2% in the upper troposphere and stratosphere. Temperature profiles have rms errors of 1.2 to 2.5 K and can define the tropopause to 0.5 km and higher wave structures to 1 or 2 km.

Russell, P. B.↗

Satellite and correlative measurements of the stratospheric aerosol. I An optical model for data conversions

A description is presented of an empirically based model of stratospheric aerosol optical properties (size distributions and refractive indices) and their variations. The need for such a model arose in the data validation and archival programs for two satellite sensors, SAM II and SAGE. These programs require the ability to convert measurements of a given aerosol macroproperty (e.g., volume extinction coefficient, volume backscatter coefficient, particle number or mass per unit volume) to best estimates of other aerosol macroproperties, and to assess quantitatively the uncertainties in the conversion process. The described model provides the information on size distributions, refractive indices and their variations necessary for these tasks, and also defines a procedure for combining the model information with empirical data in a way that facilitates automatic data processing. Although the model was developed for use in the satellite validation and archival programs, it also has proven useful in other studies of stratospheric aerosol.

Russell, P. B.↗

Satellite and correlative measurements of the stratospheric aerosol. II Comparison of measurements made by SAM II, dustsondes and airborne lidar

Results are shown from the first set of measurements conducted to validate extinction data from the Stratospheric Aerosol Measurement II (SAM II). Dustsonde-measured number density profiles and lidar-measured backscattering profiles for two days are converted to extinction profiles, and are shown to agree within their respective uncertainties at all heights above the tropopause. Near the tropopause, agreement depends on use of model size distributions with larger particles, having radii greater than 0.6 microns. The presence of such large particles is supported by measurements made elsewhere, is suggested by the in situ size distribution measurements reported, and is likely to have an important bearing on the radiative impact of the total stratospheric aerosol. It is concluded that the SAM II extinction data and uncertainty estimates are supported.

Russell, P. B.↗

Electric fields produced by Florida thunderstorms

Twenty-five field mill sites provided data on the electric fields produced during both the intense and the final, less active periods of summer air mass thunderstorms in east central Florida. During the periods of intense lightning activity, time- and area-averaged fields were usually -0.8 to -2.1 kV/m, while for the less active periods, the field values were typically in the range of -2.3 to -4.3 kV/m. Furthermore, during the active storm periods, which represented about 27% of the total storm durations, about 71% of all lightning discharges occurred. Also, fewer lightning discharges in the final storm period than in the active period reached the ground.

Livingston, J. M.↗

Computerized optimal control system design for reusable and expendable boost vehicles.

An optimization technique has been developed which combines the practical features of hybrid simulation of the dynamic system under study with the systematic approach of modern control theory where a mathematically formulated design criterion is optimized by functional minimization. Standard hybrid computer optimization methods using high-speed repetitive simulations and gradient minimization schemes have been extended to obtain time-varying optimal gain schedules and reduce the sensitivity of the optimized system to parameter and disturbance uncertainties. In this approach the performance index is expressed in meaningful engineering terms that reflect the interactions among all major disciplines, structures, control/actuation system design, aerodynamics and performance. The basic optimization technique is developed and its application to current aerospace control problems including the space shuttle is presented in detail. In the discussion of the application, the controllers resulting from the technique are compared with controllers developed by conventional methods. The paper concludes with a review of the advantages and disadvantages of the technique and plans for future applications.

Connor, C. L.↗