High Current Rectification on Graphene-Boron Nitride Nanotube Heterojunctions.
Abstract not provided.
Engineering topics
Publications and source records attributed to Liu, Yang.
Abstract not provided.
Barocaloric effect in BaTiO{sub 3} single crystal is studied by a thermodynamic phenomenological model. It is demonstrated that a giant barocaloric effect can be achieved near room temperature with an adiabatic temperature change of more than 3 K and a temperature span about 50 K. As expected, the electrocaloric peak can be shifted towards room temperature by pressure. However, a slight reduction of the electrocaloric peak is found in contrast to relaxor ferroelectrics and LiNbO{sub 3}. We believe that our findings could open a potential route by combining the barocaloric effect and pressure-mediated electrocaloric effect in BaTiO{sub 3} single crystal for cooling devices.
We developed a coronal nonlinear force-free field (COR-NLFFF) forward-fitting code that fits an approximate nonlinear force-free field (NLFFF) solution to the observed geometry of automatically traced coronal loops. In contrast to photospheric NLFFF codes, which calculate a magnetic field solution from the constraints of the transverse photospheric field, this new code uses coronal constraints instead, and this way provides important information on systematic errors of each magnetic field calculation method, as well as on the non-force-freeness in the lower chromosphere. In this study we applied the COR-NLFFF code to NOAA Active Region 11158, during the time interval of 2011 February 12-17, which includes an X2.2 GOES-class flare plus 35 M- and C-class flares. We calculated the free magnetic energy with a 6 minute cadence over 5 days. We find good agreement between the two types of codes for the total nonpotential E{sub N} and potential energy E{sub P} but find up to a factor of 4 discrepancy in the free energy E {sub free} = E{sub N} – E{sub P} and up to a factor of 10 discrepancy in the decrease of the free energy ΔE {sub free} during flares. The coronal NLFFF code exhibits a larger time variability and yields a decrease of free energy during the flare that is sufficient to satisfy the flare energy budget, while the photospheric NLFFF code shows much less time variability and an order of magnitude less free-energy decrease during flares. The discrepancy may partly be due to the preprocessing of photospheric vector data but more likely is due to the non-force-freeness in the lower chromosphere. We conclude that the coronal field cannot be correctly calculated on the basis of photospheric data alone and requires additional information on coronal loop geometries.
The fractional quantum Hall effect (FQHE), observed in two-dimensional (2D) charged particles at high magnetic fields, is one of the most fascinating, macroscopic manifestations of a many-body state stabilized by the strong Coulomb interaction. It occurs when the filling factor (v) of the quantized Landau levels (LLs) is a fraction, which, with very few exceptions, has an odd denominator. In 2D systems with additional degrees of freedom it is possible to cause a crossing of the LLs at the Fermi level. At and near these crossings, the FQHE states are often weakened or destroyed. Here we report the observation of an unusual crossing of the two lowest-energy LLs in high-mobility GaAs 2D hole systems, which brings to life a new even-denominator FQHE v = 1/2.
Abstract not provided.
Room-temperature electrocaloric properties of Pt/BaTiO{sub 3}/SrRuO{sub 3} ferroelectric tunnel junctions (FTJs) are studied by using a multiscale thermodynamic model. It is found that there is a divergence in the adiabatic temperature change ΔT for the two opposite polarization orientations. This difference under a typical writing voltage of 3 V can reach over 1 K as the barrier thickness decreases. Thanks to the ultrahigh external stimulus, a giant electrocaloric effect (1.53 K/V) with ΔT being over 4.5 K can be achieved at room temperature, which demonstrates the perspective of FTJs as a promising solid-state refrigeration.
Inconel 617 is a candidate material for the intermediate heat exchanger in a very high temperature reactor for the next generation nuclear power plant. This application will require the material to withstand fatigue-ratcheting interaction at temperatures up to 950°C. Therefore nondestructive evaluation and structural health monitoring are important capabilities. Acoustic nonlinearity (which is quantified in terms of a material parameter, the acoustic nonlinearity parameter, β) has been proven to be sensitive to microstructural changes in material. This research develops a robust experimental procedure to track the evolution of damage precursors in laboratory tested Inconel 617 specimens using ultrasonic bulk waves. The results from the acoustic non-linear tests are compared with stereoscope surface damage results. Therefore, the relationship between acoustic nonlinearity and microstructural evaluation can be clearly demonstrated for the specimens tested.
Aircraft operating in some cold weather conditions face the risk of icing. Icing poses a threat to flight safety and its management is expensive. Removing light frost on a clear day from a medium-size business jet can cost $300, heavy wet snow removal can cost $3,000 and removal of accumulated frozen/freezing rain can cost close to $10,000. Understanding conditions that lead to severe icing events is important and challenging. When an aircraft or rotorcraft flies in a cold climate, some of the super cooled droplets impinging on exposed aircraft surfaces may flow along the surface prior to freezing and give various forms and shapes of ice. The runback behavior of a water film on an aircraft affects the morphology of ice accretion and the rate of formation. In this study, we report the recent progress to develop an Ultrasonic Pulse-Echo (UPE) technique to provide real-time thickness distribution measurements of surface water flows driven by boundary layer airflows for aircraft icing studies. A series of initial experimental investigations are conducted in an ice wind tunnel employing an array of ultrasonic transducers placed underneath the surface of a flat plate. The water runback behavior on the plate is evaluated by measuring the thickness profile variation of the water film along the surface by using the UPE technique under various wind speed and flow rate conditions.
This paper reports the interfacial oxygen migration effect and its induced magnetic anisotropy evolution in Pt/Co/MgO/Pt films. During depositing the MgO layer, oxygen atoms from the MgO combine with the neighboring Co atoms, leading to the formation of CoO at the Co/MgO interface. Meanwhile, the films show in-plane magnetic anisotropy (IMA). After annealing, most of the oxygen atoms in CoO migrate back to the MgO layer, resulting in obvious improvement of Co/MgO interface and the enhancement of effective Co-O orbital hybridization. These favor the evolution of magnetic anisotropy from IMA to perpendicular magnetic anisotropy (PMA). The oxygen migration effect is achieved by the redox reaction at the Co/MgO interface. On the contrary, the transfer from IMA to PMA cannot be observed in Pt/Co/Pt films due to the lack of interfacial oxygen migration.
Abstract not provided.
Explore the source record for details and available documents.
The Fe{sub x}Pt{sub 100−x} nanoparticles (NPs) with different nominal atomic rations (30≤x≤80) were synthesized at 700 °C by the sol–gel method. The structure, morphology and magnetic properties of the samples were investigated. When the Fe content in the Fe–Pt alloy NPs was 30 at%, FePt{sub 3} NPs were successfully synthesized. With the increase in Fe content up to 50 at%, it was found that the superlattice reflections (0 0 1) and (1 1 0) appeared, which indicated the formation of the L1{sub 0}-FePt phase. Meanwhile, the FePt{sub 3} fraction was reduced. When the Fe content increased to 60 at%, single-phase L1{sub 0}-FePt NPs were synthesized. The coercivity (Hc), saturation magnetization (Ms) and chemical order parameter S for Fe{sub 60}Pt{sub 40} NPs were as high as 10,200 Oe, 17.567 emu/g and 0.928, respectively. With the further increase of the Fe content to 80 at%, only Fe{sub 3}Pt phase existed and the Hc of the Fe{sub 3}Pt NPs decreased drastically to 360 Oe. - Graphical abstract: Fe{sub 3}Pt, FePt and FePt{sub 3} nanoparticles was obtained by sol–gel method. The effect of iron and platinum content on structural and magnetic properties of the FePt nanoparticles was investigated. Display Omitted - Highlights: • L1{sub 2}-FePt{sub 3}, L1{sub 0}-FePt and L1{sub 2}-Fe{sub 3}Pt NPs were synthesized by sol–gel method. • The chemical order parameter S affects the magnetic properties of the Fe–Pt alloy. • Structural and magnetic properties of the Fe–Pt alloy NPs were studied. • The synthetic route in this study will open up the possibilities of practical use.
Inhibition of DNA repair is a recognized mechanism for arsenic enhancement of ultraviolet radiation-induced DNA damage and carcinogenesis. Poly(ADP-ribose) polymerase-1 (PARP-1), a zinc finger DNA repair protein, has been identified as a sensitive molecular target for arsenic. The zinc finger domains of PARP-1 protein function as a critical structure in DNA recognition and binding. Since cellular poly(ADP-ribosyl)ation capacity has been positively correlated with zinc status in cells, we hypothesize that arsenite binding-induced zinc loss from PARP-1 is equivalent to zinc deficiency in reducing PARP-1 activity, leading to inhibition of DNA repair. To test this hypothesis, we compared the effects of arsenite exposure with zinc deficiency, created by using the membrane-permeable zinc chelator TPEN, on 8-OHdG formation, PARP-1 activity and zinc binding to PARP-1 in HaCat cells. Our results show that arsenite exposure and zinc deficiency had similar effects on PARP-1 protein, whereas supplemental zinc reversed these effects. To investigate the molecular mechanism of zinc loss induced by arsenite, ICP-AES, near UV spectroscopy, fluorescence, and circular dichroism spectroscopy were utilized to examine arsenite binding and occupation of a peptide representing the first zinc finger of PARP-1. We found that arsenite binding as well as zinc loss altered the conformation of zinc finger structure which functionally leads to PARP-1 inhibition. These findings suggest that arsenite binding to PARP-1 protein created similar adverse biological effects as zinc deficiency, which establishes the molecular mechanism for zinc supplementation as a potentially effective treatment to reverse the detrimental outcomes of arsenic exposure. - Highlights: • Arsenite binding is equivalent to zinc deficiency in reducing PARP-1 function. • Zinc reverses arsenic inhibition of PARP-1 activity and enhancement of DNA damage. • Arsenite binding and zinc loss alter the conformation of zinc finger structure.
(K{sub 0.5}Na{sub 0.5}){sub 1-x}Li{sub x}Nb{sub 0.84}Ta{sub 0.1}Sb{sub 0.06}O{sub 3} (KNLNTS) lead free ceramics with different Li concentration were fabricated by conventional solid-state reaction method. By increasing Li ions in KNLNTS, the grains grow up and the crystal structure changes from orthorhombic to tetragonal. When 0.03 ≤ x ≤ 0.05, the ceramics structure lays in PPT region. Polarization versus electric field (P-E) hysteresis loops at room temperature show good ferroelectric properties and the remnant polarization decreases by increasing Li content while coercive electric keeps almost unchanged. In PPT region, taking x = 0.04 as an example, the sample shows excellent dielectric properties: the dielectric constant is 1159 and loss tangent is 0.04, while the piezoelectric constant d{sub 33} is 245 pC/N and kp is 0.44 at room temperature, it is promising for (K{sub 0.5}Na{sub 0.5}){sub 1-x}Li{sub x}Nb{sub 0.84}Ta{sub 0.1}Sb{sub 0.06}O{sub 3} with 4 at. % Li to substitute PZT.
Explore the source record for details and available documents.