Engineering topics

Liu, Xiang

Publications and source records attributed to Liu, Xiang.

46 records · Page 3

DOE OSTI2021

Unlocking the self-supported thermal runaway of high-energy lithium-ion batteries

Layered Ni-rich LiNi x Mn y Co 1-x-y O 2 (NMC) materials are the most promising cathode materials for Li-ion batteries due to their favorable energy densities. However, the low thermal stability typically caused by detrimental oxygen release leads to significant safety concerns. Determining the pathways of oxygen evolution reaction is essential, as the ideal safety countermeasure is to break the reaction chain of thermal runaway. In this study, we demonstrate that two endogenous pathways of oxygen involved in strong exothermic reactions lead the NMC811|graphite pouch cell to an uncontrollable state, and we quantify the individual contribution of the pathways to thermal runaway. Approximately 41% of thermal-induced oxygen reacts aggressively with ethylene carbonate (EC) at the cathode/electrolyte interface with 16% heat generation, accelerating the self-heating rate and thereby further triggering thermal runaway. The residual oxygen that survives the reaction with carbonate spreads to the lithiated anode with major heat generation (65%), bringing the battery to the maximum destructive temperature during thermal runaway. By confirming the significant roles of EC and anode, a deeper understanding on battery fire was achieved. Finally, the revealed mechanism can help guide studies on stopping the two reaction pathways, allowing for the safer use of high-energy lithium-ion batteries in the future.

25 ENERGY STORAGE↗

DOE OSTI2021

Solid-State Synthesis of Highly Dispersed Nitrogen-Coordinated Single Iron Atom Electrocatalysts for Proton Exchange Membrane Fuel Cells

Fe–N–C with atomically dispersed Fe single atoms is the most promising candidate to replace platinum for the oxygen reduction reaction (ORR) in fuel cells. However, the conventional synthesis procedures require quantities solvents and metal precursors, sluggish adsorption process, and tedious washing, resulting in limited metal doping and uneconomical for large-scale production. Here, for the first time, Fe 2 O 3 is adopted as the Fe precursor to derive abundant single Fe atoms dispersed on carbon surfaces. The Fe–N–C catalyst synthesized by this simple method shows an excellent ORR activity with half-wave potentials of 0.82 and 0.90 V in acidic and alkaline solutions, respectively. A single fuel cell with an optimized Fe–N–C cathode shows a high peak power density of 0.84 W cm –2 . The solid-state transformation synthesis method developed in this study may shed light on mass production of single-atom-based catalysts.

25 ENERGY STORAGE↗

DOE OSTI2021

Broadband Multi-wavelength Properties of M87 during the 2017 Event Horizon Telescope Campaign

In 2017, the Event Horizon Telescope (EHT) Collaboration succeeded in capturing the first direct image of the center of the M87 galaxy. The asymmetric ring morphology and size are consistent with theoretical expectations for a weakly accreting supermassive black hole of mass ∼6.5 × 109 M ⊙. The EHTC also partnered with several international facilities in space and on the ground, to arrange an extensive, quasi-simultaneous multi-wavelength campaign. This Letter presents the results and analysis of this campaign, as well as the multi-wavelength data as a legacy data repository. We captured M87 in a historically low state, and the core flux dominates over HST-1 at high energies, making it possible to combine core flux constraints with the more spatially precise very long baseline interferometry data. We present the most complete simultaneous multi-wavelength spectrum of the active nucleus to date, and discuss the complexity and caveats of combining data from different spatial scales into one broadband spectrum. We apply two heuristic, isotropic leptonic single-zone models to provide insight into the basic source properties, but conclude that a structured jet is necessary to explain M87’s spectrum. We can exclude that the simultaneous γ-ray emission is produced via inverse Compton emission in the same region producing the EHT mm-band emission, and further conclude that the γ-rays can only be produced in the inner jets (inward of HST-1) if there are strongly particle-dominated regions. Direct synchrotron emission from accelerated protons and secondaries cannot yet be excluded.

79 ASTRONOMY AND ASTROPHYSICS↗

DOE OSTI2021

Kinetic Limitations in Single‐Crystal High‐Nickel Cathodes

Abstract High‐nickel cathodes attract immense interest for use in lithium‐ion batteries to boost Li‐storage capacity while reducing cost. For overcoming the intergranular‐cracking issue in polycrystals, single‐crystals are considered an appealing alternative, but aggravating concerns on compromising the ionic transport and kinetic properties. We report here a quantitative assessment of redox reaction in single‐crystal LiNi 0.8 Mn 0.1 Co 0.1 O 2 using operando hard X‐ray microscopy/spectroscopy, revealing a strong dependence of redox kinetics on the state of charge (SOC). Specifically, the redox is sluggish at low SOC but increases rapidly as SOC increases, both in bulk electrodes and individual particles. The observation is corroborated by transport measurements and finite‐element simulation, indicating that the sluggish kinetics in single‐crystals is governed by ionic transport at low SOC and may be alleviated through synergistic interaction with polycrystals integrated into a same electrode.

Ge, Mingyuan↗

DOE OSTI2021

Thermal runaway mechanism of lithium-ion battery with LiNi 0.8 Mn 0.1 Co 0.1 O 2 cathode materials

Battery safety is critical to the application of lithium-ion batteries, especially for high energy density battery applied in electric vehicles. In this paper, the thermal runaway mechanism of LiNi 0.8 Co 0.1 Mn 0.1 O 2 based lithium-ion battery is illustrated. And the reaction between cathode and flammable electrolyte is proved as the trigger of the thermal runaway accident. In detail, with differential scanning calorimeter tests for battery components, the material combination contributing to thermal runaway was decoupled. Characterization with synchrotron X-ray diffraction and transmission electron microscopy with in-situ heating proved that the vigorous exothermic reaction is initiated by the liberated oxygen species. The pulse of highly active oxygen species reacted quickly with the electrolyte, accompanied with tremendous heat release, which accelerated the phase transformation of charged cathode. Also, the mechanism is verified by a confirmatory experiment when the highly active oxygen species were trapped by anion receptor, the phase transformation of the charged cathode was inhibited. Clarifying the thermal runaway mechanism of LiNi 0.8 Co 0.1 Mn 0.1 based lithium-ion battery may light the way to battery chemistries of both high energy density and high safety.

25 ENERGY STORAGE↗

DOE OSTI2021

Stress- and interface-compatible red phosphorus anode for high-energy and durable sodium-ion batteries

Sodium-ion battery is a promising candidate for energy storage application, but the absence of high-capacity and low-cost anode materials significantly limit their practical specific energy and cost. Red phosphorus (RP) possesses a high theoretical specific capacity but suffers from large volume change, low electronic conductivity and unstable solid-electrolyte interphase (SEI). Herein, a hierarchical micro/nanostructured antimony-doped RP/carbon anode was developed, which demonstrate extraordinary electrochemical performance with high initial Coulombic efficiency of ~90%, high areal (~1.7 mAh cm-2) capacity together with good cycle stability and rate capability. Combined experimental and computational studies consistently revealed that such a unique structural design can dramatically accommodate the mechanical stress and moreover effectively restrain the undesired decomposition of electrolyte solvents regardless of electrolytes formulation, resulting in superior structural integrity and thin/robust SEI formation during cycling. The present finding has offered an alternative strategy for stress management and interface engineering on high-capacity alloying-based anode materials.

Liu, Xiang↗

DOE OSTI2021

Development of cathode-electrolyte-interphase for safer lithium batteries

Accompanied by the adoption of aggressive cathodes to continuously improve batteries energy density, enhancing their safety is becoming increasingly urgent for the electric vehicle development. In-situ controllable formation of robust cathode-electrolyte interphase (CEI) with high inorganic content seems to be the most promising strategy to address the thermal runaway concerns. Moreover, the in-situ formation strategy via suitable electrolyte replacement or electrolyte additives is extremely simple yet effective, especially for industrial manufacture of batteries. Here, this paper briefly reviews recent advanced CEIs formed by conventional carbonate-based electrolytes, fluorinated electrolytes, concentrated electrolytes, and solid state electrolytes. The focus on the thermal stability of the cathodes after CEI modification, and at the same time conduct safety tests at the material, cell, and module levels for comprehensive evaluation are encouraged. The review will provide inspiration for future developments in battery safety and push forward the practical applications of newly developed high-energy density batteries.

25 ENERGY STORAGE↗

NASA NTRS2000

Active and Passive Microwave Determination of the Circulation and Characteristics of Weddell and Ross Sea Ice

A combination of satellite microwave data sets are used in conjunction with ECMWF (Medium Range Weather Forecasts) and NCEP (National Center for Environment Prediction) meteorological analysis fields to investigate seasonal variability in the circulation and sea-ice dynamics of the Weddell and Ross Seas. Results of sea-ice tracking using SSM/I (Special Sensor Microwave Imager), Scatterometer and SAR images are combined with in-situ data derived from Argos buoys and GPS drifters to validate observed drift patterns. Seasonal 3-month climatologies of ice motion and drift speed variance illustrate the response of the sea-ice system to seasonal forcing. A melt-detection algorithm is used to track the onset of seasonal melt, and to determine the extent and duration of atmospherically-led surface melting during austral summer. Results show that wind-driven drift regulates the seasonal distribution and characteristics of sea-ice and the intensity of the cyclonic Gyre circulation in these two regions.

Drinkwater, Mark R.↗

NASA NTRS2000

Satellite-Derived Dynamics of Southern Ocean Sea Ice

Antarctic ERS-2, RADARSAT Synthetic Aperture Radar and ERS-1/2 Scatterometer images were analyzed with SMMI radiometer image time-series data to investigate seasonal variability in satellite-tracked sea-ice dynamics in the Southern Ocean during 1992. Supporting field data were acquired during 'in-situ' experiments including the winter 1992 Ice Station Weddell and Winter Weddell Gyre studies. A variety of surface measurements were made during these experiments including Argos-buoy deployment and GPS drift measurements. These are used in conjunction with International Program for Antarctic Buoys drift trajectories for ice-motion tracking validation. Comparisons between gridded Special Sensor Microwave Imager (SSMI) ice-motion vectors and European Center for Medium Range Weather Forecasts/National Centers for Environmental Prediction (ECMWF/NCEP) analyses indicate that large-scale drift is forced predominantly by the long-term mean, large-scale synoptic pressure field. Only sub-daily SAR sea-ice tracking can capture high-frequency fluctuations, driven by polar lows or tidal forcing. In these cases, sea-ice drift can respond rapidly to changes in forcing on semi-diurnal time scales depending on the location with respect to the coastline. Seasonality of ice drift, particularly in the Weddell and Ross Seas, is linked to ice extent and compactness, and internal ice stresses transmitted through the pack ice from the coast. Three-monthly seasonal climatologies are presented of austral winter of ice drift in the Southern Ocean. The large Weddell and Ross Sea gyres are clearly resolved along with key seasonal and spatial attributes of their cyclonic circulation. Regional time series of ice dynamics parameters are used to illustrate correlations with meteorological forcing. Persistent divergence such as that occurring in the Ronne-Filchner polynya system results in large fractions of new ice. Similarly, convergence zones produce large fractions of deformed ice and characterize the dynamics of regions where perennial ice is observed. High shear strains also help delineate the axis of the Antarctic divergence in many places in the ice cover. In these regions, the separation between the coastal 'east wind drift'and ACC-dominated drift regimes is characterized by zonally extended regions of intense shear.

Drinkwater, Mark R.↗

NASA NTRS1997

ERS satellite microwave radar observations of Antarctic sea-ice dynamics

ERS-1 and ERS-2 scatterometer and synthetic aperture radar (SAR) data are used to monitor and track large and small scale sea ice dynamics in the Southern Ocean, and in particular in the Weddell Sea, Antarctica. Sea ice formation in the Weddell Sea regulates vertical and horizontal thermohaline circulation and influences bottom water production rates. Significant seasonal to interannual variability is observed in the sea ice drift dynamics. Coupled model simulations reproduce this variability and indicate that there is significant interannual variability in Weddelll Sea ice formation, drifts and extent on the El Nino southern oscillation (ENSO) timescale, with a period of approximately eight years. Changes in ice dynamics on these timescales regulate the amount of sea ice divergence and polynya formation. Anomalies in the timing and duration of the opening of the Ronne ice shelf polynya system are closely related to the variability in outflow of Weddell Sea bottom water measured at Joinville Island.

Drinkwater, Mark R.↗