Engineering Papers⌕ Search

Engineering topics

Liu, J L

Publications and source records attributed to Liu, J L.

Homobuffer thickness effect on the background electron carrier concentration of epitaxial ZnO thin films

Epitaxial ZnO thin films were grown on r-plane sapphire substrates using plasma-assisted molecular-beam epitaxy. ZnO homobuffer layers grown at a lower temperature were introduced to improve the crystallinity of the top ZnO thin films. Thicker homobuffer layers lead to better crystallinity of the subsequent epitaxial ZnO thin films due to the strain relaxation effect. Residual background electron carrier concentration in these undoped ZnO thin films first decreases, then increases as the buffer layer thickness increases from {approx}1 to 30 nm, with a minimum electron concentration of {approx}1x10{sup 17} cm{sup -3} occurring in ZnO homobuffer of {approx}5 nm. These results demonstrate that the optimized ZnO homobuffer thickness to achieve both good ZnO crystallinity and low residual electron concentration is determined by the relative electron carrier concentration ratios and mobility ratios between the buffer and epi-ZnO layers.

36 MATERIALS SCIENCE↗

Blue electroluminescence from ZnO based heterojunction diodes with CdZnO active layers

p-ZnO/i-CdZnO/n-ZnO was grown on n-type Si substrates by plasma-assisted molecular-beam epitaxy. Rectifying I-V curves show typical diode characteristics. Blue electroluminescence emissions at around 459 nm were observed when the diodes were forward-biased at room temperature. The emission intensity increases with the increase of the injection current. Temperature dependent electroluminescence measurements suggest that the peak positions of blue emissions represent the band gap of the CdZnO active layer, which changes with the temperature.

36 MATERIALS SCIENCE↗

Elliptic flow and incomplete equilibration

The dependence of eccentricity scaled elliptic flow on the partonic cross section in Au+Au collisions at relativistic heavy ion collider (RHIC) energy {radical}(s{sub NN})=200 GeV with impact parameter b=8 fm is analyzed using a multiphase transport (AMPT) model. It is shown that the dependence of eccentricity scaled elliptic flow on the partonic cross section could be described well by a formula suggested by Bhalerao et al. The eccentricity scaled elliptic flow of the parton is 19%{approx}27% lower than its 'hydrodynamic limit.' The hadronization of the parton through coalescence and hadronic dynamics (decay, collision) could influence the obtained deviation of eccentricity scaled elliptic flow of the hadron from its 'hydrodynamic limit.' The hadronic final state interactions and hadronization reduce the extracted 'hydrodynamic limit' by 20% and also reduce the deviation from the 'hydrodynamic limit' by 26%.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Surface emission and elliptic flow

The partonic elliptic flow in Au+Au collisions at energies currently available at the BNL Relativistic Heavy Ion Collider (RHIC) ({radical}(s{sub NN})=200 GeV) is analyzed using a multiphase transport (AMPT) model. It is shown that the partons freezing out at the early stage are mainly emitted from the surface of the collision system. The integral elliptic flow of these partons is shown to decrease with time and to be consistent with the surface emission picture. The curve of the differential elliptic flow of partons freezing out at the early stage is flat relative to that of partons freezing out at the late stage. Both integral and differential elliptic flows of partons in the surface emission picture approach saturation for large cross sections.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Ultraviolet emission from Sb-doped p-type ZnO based heterojunction light-emitting diodes

Heterojunction light emitting diodes (LEDs) were fabricated by making Au/Ni top Ohmic contacts on Sb-doped p-type ZnO film with low specific contact resistivity and Al/Ti back Ohmic contacts on n-type Si substrate. Near-band edge and deep-level emissions were observed from the LED devices at both low temperatures and room temperature, which is due to band-to-band and band-to-deep level radiative recombinations in ZnO, respectively. The electroluminescence emissions precisely match those of photoluminescence spectra from Sb-doped p-type ZnO, indicating that the ZnO layer acts as the active region for the radiative recombinations of electrons and holes in the diode operation.

36 MATERIALS SCIENCE↗