Engineering Papers⌕ Search

Engineering topics

Linton, Kory

Publications and source records attributed to Linton, Kory.

76 records · Page 5

Radiation Induced Segregation at Grain Boundaries in Steels: NSUF 2018 Milestone Report

This document outlines the user supported post-irradiation characterization by Oak Ridge National Laboratory under the Nuclear Scientific User Facility Consolidated Innovative Nuclear Research project, “Correlative Atom Probe and Electron Microscopy Study of Radiation Induced Segregation at Low and High Angle Grain Boundaries in Steels.” Fiscal Year 2018 was the second of a two-year project aimed at using analytical electron microscopy combined with atom probe tomography (APT) to probe the nanometer length scale segregations in austenitic stainless steels after neutron irradiation. Particularly, analytical electron microscopy using the FEI F200X Talos was successfully completed in the first year, and the second year was focused on APT study. Scanning electron microscopy (SEM) coupled with an electron backscatter diffraction (EBSD) detector was performed on selected specimens to locate high and low angle grain boundaries for targeted specimen preparation using focused ion beam (FIB). FIB prepared lift outs were used for APT examination of the grain boundaries using a Cameca Instruments LEAP 4000X HR instrument. This report briefly summarizes the specimen preparation and APT results obtained at the Center for Advanced Energy Studies.

36 MATERIALS SCIENCE↗

Tensile Strength and Steam Oxidation Resistance of ODS FeCrAl Sheet and Tubes

ORNL is developing advanced low-Cr oxide dispersion strengthened (ODS) FeCrAlY alloys for accident tolerant fuel cladding, and this report describes the fabrication and characterization of a new ODS FeCrAlYZr (CrAZY) tube. This CrAZY tube was produced by successive steps of pilgering and annealing, in collaboration with a Japanese tube manufacturer. Very fine, elongated sub-grain structure in the as-received tube was consistent with the fine sub-grain structure observed for CrAZY foils fabricated by cold rolling at ORNL and led to very high tensile strength at room temperature. The elongated grain structure along the pilgering direction resulted in lower ductility in the hoop direction compared to the ductility along the tube. Similar anisotropic tensile behavior was also observed for the CrAZY foil with very limited ductility perpendicular to the rolling direction. The foil and tube were heat treated in the 850- 1100ºC range to reduce the residual stress. Recrystallization was observed at temperature as low as 900ºC, with an increasing number of recrystallized grains with increasing temperature. Exposure for 1h at 900ºC resulted in a significant improvement of the foil and tube, with a moderate decrease of strength. Atom probe tomographic analysis revealed the presence of many nano oxide precipitates but also areas with fewer precipitates due to the relatively high extrusion temperature (1100ºC). Finally, the CrAZY tube showed good oxidation resistance in steam at temperature up to 1400ºC.

36 MATERIALS SCIENCE↗

Transient Mechanical Test Development for Accident Tolerant Cladding Candidates to Simulate PCMI-like Conditions

This study investigates the transient mechanical response of accident tolerant fuel (ATF) cladding candidates to provide information on potential PCMI-induced deformation and failure of candidate cladding materials. The mechanical testing is applied t to Gen-I FeCrAl and triaxially-braided SiC fiber SiC matrix composite materials under loading conditions like the PCMI during a postulated design basis reactivity insertion accident. To achieve the specific loading conditions, a modified burst test instrument with accurate mechanical pulse control has been designed and constructed. The mechanical response of FeCrAl, SiC-SiC composite tubes were compared with the pre-hydrided zirconium alloy cladding. The specimens subjected to mechanical pulses were investigated in a strain-controlled manner deformation.

Cinbiz, Nedim↗