Engineering Papers⌕ Search

Engineering topics

Lin, Shawn-Yu

Publications and source records attributed to Lin, Shawn-Yu.

Ultra-low reflectance broadband omni-directional anti-reflection coating

An anti-reflection coating has an average total reflectance of less than 10%, for example less than 5.9% such as from 4.9% to 5.9%, over a spectrum of wavelengths of 400-1100 nm and a range of angles of incidence of 0-90 degrees with respect to a surface normal of the anti-reflection coating. An anti-reflection coating has a total reflectance of less than 10%, for example less than 6% such as less than 4%, over an entire spectrum of wavelengths of 400-1600 nm and an entire range of angles of incidence of 0-70 degrees with respect to a surface normal of the anti-reflection coating.

Chhajed, Sameer↗

Experimental demonstration of broadband solar absorption beyond the lambertian limit in certain thin silicon photonic crystals

The tantalizing possibility of 31% solar-to-electric power conversion efficiency in thin film crystalline silicon solar cell architectures relies essentially on solar absorption well beyond the Lambertian light trapping limit (Bhattacharya and John in Nat Sci Rep 9:12482, 2019). Up to now, no solar cell architecture has exhibited above-Lambertian solar absorption, integrated over the broad solar spectrum. In this work, we experimentally demonstrate two types of photonic crystal (PhC) solar cells architectures that exceed Lambertian light absorption, integrated over the entire 300–1,200 nm wavelength band. These measurements confirm theoretically predicted wave-interference-based optical resonances associated with long lifetime, slow-light modes and parallel-to-interface refraction. These phenomena are beyond the realm of ray optics. Using two types of 10-μm thick PhC’s, first an Inverted Pyramid PhC with lattice constant a= 2,500 nm and second a Teepee PhC with a = 1,200 nm, we observe solar absorption well beyond the Lambertian limit over λ = 950–1,200 nm. Our absorption measurements correspond to the maximum-achievable-photocurrent-density (MAPD), under AM1.5G illumination at 4-degree incident angle, 41.29 and 41.52 mA/cm2 for the Inverted Pyramid and Teepee PhC, respectively, in agreement with wave-optics, numerical simulations. Both of these values exceed the MAPD (= 39.63 mA/cm2) corresponding to the Lambertian limit for a 10-μm thick silicon for solar absorption over the 300–1,200 nm band.

36 MATERIALS SCIENCE↗

An In-situ and Direct Confirmation of Super-Planckian Thermal Radiation Emitted From a Metallic Photonic-Crystal at Optical Wavelengths

Planck’s law predicts the distribution of radiation energy, color and intensity, emitted from a hot object at thermal equilibrium. The Law also sets the upper limit of radiation intensity, the blackbody limit. Recent experiments reveal that micro-structured tungsten can exhibit significant deviation from the blackbody spectrum. However, whether thermal radiation with weak non-equilibrium pumping can exceed the blackbody limit in the far field remains un-answered experimentally. Here, we compare thermal radiation from a micro-cavity/tungsten photonic crystal (W-PC) and a blackbody, which are both measured from the same sample and also in-situ. We show that thermal radiation can exceed the blackbody limit by >8 times at λ=1.7 μm resonant wavelength in the far-field. Our observation is consistent with a recent calculation by Wang and John performed for a 2D W-PC filament. This finding is attributed to non-equilibrium excitation of localized surface plasmon resonances coupled to nonlinear oscillators and the propagation of the electromagnetic waves through non-linear Bloch waves of the W-PC structure. This discovery could help create super-intense narrow band thermal light sources and even an infrared emitter with a laser-like input-output characteristic.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

A low cost and large-scale synthesis of 3D photonic crystal with SP2 lattice symmetry

In this work, a novel lithographic method is proposed to prepare three-dimensional (3D) photonic crystal (PC) that is different from conventional top-down and bottom-up approaches. The method combines a 2D optical mask and off-the-axis double optical exposures to create a desirable 3D PC structure. Since the method uses only two optical exposures of a photo-resist layer, it is inherently a low-cost, high throughput and wafer-scale lithographic method. The method is implemented to make a slanted post 3D PC having the SP2 lattice symmetry. Three types of SP2 3D PC structures were successfully fabricated with a minimum feature size of d=1.5 μm over a large scale of 8x10 mm 2 , without any observable fabrication defects. The SP2 PCs are: (i) SU8 posts in air background, (ii) air pores in CdS background and (iii) Pt coated on SU8 SP2 templates. A spectroscopic study of the SP2 PCs shows select spectral regions of high reflectance, indicating the existence of a photonic stop band. This low-cost and large-scale method could enable broader technological impacts of 3D PC materials in areas such as thermo-photovoltaics and above room-temperature Bose-Einstein Condensation. Furthermore, this off-axis method could lead to the creation of an entirely new class of slanted-rod based photonic crystals, such as topological photonic crystal in 3D.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Tailoring Electron-Photon Interaction in Active 3D Photonic-Crystal Architectures

A photonic-crystal is an artificially engineered periodic structure. It is often referred to as an “optical semiconductor” due to its unparallel capability to mold the flow-of-light on-chip, not only in plane (the x-y plane) but also along the third direction. Examples of the unique 3D control-of-light include diffraction less light-guiding, slow light, super prism, negative refraction and high-Q cavity. A new research frontier exists in which the concept of complete control-of-light is utilized to facilitate and maximize electron-photon interaction. The close proximity and strong interaction between a photonic-crystal and an electronic medium can lead to new optoelectronic properties not easily attainable by other means. In this program, we will study this new class of active photonic-crystal and to achieve improved device performances and basic discoveries. Under this program, the PI has made significant progress in the following areas: (i) We have maximized light trapping and absorption by a 3D simple-cubic photonic-crystal; By advancing the concept of simple-cubic symmetry design, we have successfully designed a super thin-film architecture for high efficiency, crystalline silicon solar cells; Most recently, we have provided a theoretical roadmap for thin-film silicon solar cells with 30% power conversion efficiency. (ii) In the modification of thermal radiation area, we have observed quasi- optical coherence in thermal radiation from a 3D metallic photonic-crystal; Furthermore, we have made a direct confirmation of super-Planckian radiation a tungsten photonic-crystal; (iii) We have made simultaneous observation of a large light diffraction-efficiency, 82%, and efficiency enhancement by a volume hologram material (PQ-PMMA) for solar concentration application. (iv) we have also successfully fabricated a 3D metal-oxide photonic crystal. We demonstrated that this TiO 2 photonic crystal can achieve an effectively infinite optical path-length created using a simple-cubic photonic crystal for extreme light trapping.

36 MATERIALS SCIENCE↗

Effectively infinite optical path-length created using a simple cubic photonic crystal for extreme light trapping

A 900 nm thick TiO 2 simple cubic photonic crystal with lattice constant 450 nm was fabricated and used to experimentally validate a newly-discovered mechanism for extreme light-bending. Absorption enhancement was observed extending 1–2 orders of magnitude over that of a reference TiO 2 film. Several enhancement peaks in the region from 600–950 nm were identified, which far exceed both the ergodic fundamental limit and the limit based on surface-gratings, with some peaks exceeding 100 times enhancement. These results are attributed to radically sharp refraction where the optical path length approaches infinity due to the Poynting vector lying nearly parallel to the photonic crystal interface. The observed phenomena follow directly from the simple cubic symmetry of the photonic crystal, and can be achieved by integrating the light-trapping architecture into the absorbing volume. These results are not dependent on the material used, and can be applied to any future light trapping applications such as phosphor-converted white light generation, water-splitting, or thin-film solar cells, where increased response in areas of weak absorption is desired.

36 MATERIALS SCIENCE↗

Integrated three-dimensional photonic nanostructures for achieving near-unity solar absorption and superhydrophobicity

In this paper, we proposed and realized 3D photonic nanostructures consisting of ultra-thin graded index antireflective coatings (ARCs) and woodpile photonic crystals. The use of the integrated ARC and photonic crystal structure can achieve broadband, broad-angle near unity solar absorption. The amorphous silicon based photonic nanostructure experimentally shows an average absorption of ∼95% for λ = 400–620 nm over a wide angular acceptance of θ = 0°–60°. Theoretical studies show that a Gallium Arsenide (GaAs) based structure can achieve an average absorption of >95% for λ = 400–870 nm. Furthermore, the use of the slanted SiO{sub 2} nanorod ARC surface layer by glancing angle deposition exhibits Cassie-Baxter state wetting, and superhydrophobic surface is obtained with highest water contact angle θ{sub CB} ∼ 153°. These properties are fundamentally important for achieving maximum solar absorption and surface self-cleaning in thin film solar cell applications.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Resonant scattering of surface plasmon polaritons by dressed quantum dots

The resonant scattering of surface plasmon-polariton waves (SPP) by embedded semiconductor quantum dots above the dielectric/metal interface is explored in the strong-coupling regime. In contrast to non-resonant scattering by a localized dielectric surface defect, a strong resonant peak in the spectrum of the scattered field is predicted that is accompanied by two side valleys. The peak height depends nonlinearly on the amplitude of SPP waves, reflecting the feedback dynamics from a photon-dressed electron-hole plasma inside the quantum dots. This unique behavior in the scattered field peak strength is correlated with the occurrence of a resonant dip in the absorption spectrum of SPP waves due to the interband photon-dressing effect. Our result on the scattering of SPP waves may be experimentally observable and applied to spatially selective illumination and imaging of individual molecules.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Review on recent progress of three-dimensional optical photonic crystal

Over the past two decades, the field of photonic-crystals has become one of the most influential realms of contemporary optics. In this paper, we will review two recent experimental progresses in three-dimensional photonic-crystal operating in optical wavelengths. The first is the observation of anomalous light-refraction, an acutely negative refraction, in a 3D photonic-crystal for light trapping, guiding and near-unity absorption. The second is the observation of quasi-coherent thermal emission from an all-metallic 3D photonic-crystal at elevated temperatures.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Nanoengineering for solid-state lighting.

This report summarizes results from a 3-year Laboratory Directed Research and Development project performed in collaboration with researchers at Rensselaer Polytechnic Institute. Our collaborative effort was supported by Sandia's National Institute for Nanoengineering and focused on the study and application of nanoscience and nanoengineering concepts to improve the efficiency of semiconductor light-emitting diodes for solid-state lighting applications. The project explored LED efficiency advances with two primary thrusts: (1) the study of nanoscale InGaN materials properties, particularly nanoscale crystalline defects, and their impact on internal quantum efficiency, and (2) nanoscale engineering of dielectric and metal materials and integration with LED heterostructures for enhanced light extraction efficiency.

36 MATERIALS SCIENCE↗