Engineering Papers⌕ Search

Engineering topics

Light, Jeffrey S.

Publications and source records attributed to Light, Jeffrey S..

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Wing download reduction using vortex trapping plates

A download reduction technique using spanwise plates on the upper and lower wing surfaces has been examined. Experimental and analytical techniques were used to determine the download reduction obtained using this technique. Simple two-dimensional wind tunnel testing confirmed the validity of the technique for reducing two-dimensional airfoil drag. Computations using a two-dimensional Navier-Stokes analysis provided insight into the mechanism causing the drag reduction. Finally, the download reduction technique was tested using a rotor and wing to determine the benefits for a semispan configuration representative of a tilt rotor aircraft.

Light, Jeffrey S.↗
NASA NTRS1994

Study of noise on a small-scale hovering tilt rotor

A study of the noise from a small-scale, semi-span test of a hovering tilt rotor is presented. The effect on noise of the tilt rotor fountain and of several tilt rotor configuration changes is examined. Measurments were made of an isolated rotor; rotor and wing; rotor and image plane; and rotor, wing and image plane. This last configuration models a tilt rotor. With a tilt rotor, the wing turns some of the rotor downwash inboard. When the flows meet, some of the flow is forced upward creating a fountain. Some of the fountain is ingested into the rotor disc. Rotor fountain interactions produce very unsteady impulsive noise to the rear of the aircraft. Configuration changes to investigate download reduction included increasing the rotor/wing separation, deflecting the flap, adding the nacelle, adding vortex trapping plates and blowing on the upper surface. These configuration changes produced little or no effect on the noise, although they changed the net download. Increasing the wing span, however, reduced the annoying content of this impulse noise about 2dB.

Mosher, Marianne↗
NASA NTRS1992

Shadowgraph flow visualization of isolated tiltrotor and rotor/wing wakes

Shadowgraph flow visualization images were acquired from a 0.184-scale tiltrotor and wing in hover. Measurements and details of the vortex core structure were examined as a function of thrust condition and wake age. Experimental data for the isolated rotor wake geometry and rotor wake interactions with a semi-span wing and image plane were acquired. Quantitative measurements and comparisons of wake geometry and distortion were made for three configurations: the isolated rotor, rotor/wing, and rotor/wing/image plane. Comparisons between tiltrotor and helicopter rotor wake geometry measurements were made. Experimental wake geometry data were also compared with two wake models. Suggestions for improvements to existing prescribed-wake and free-wake models are proposed.

Swanson, Alexandra A.↗
NASA NTRS1990

Application of the wide-field shadowgraph technique to helicopters in forward flight

A test was conducted to examine the feasibility of using the wide-field shadowgraph method for visualizing the wake of a small-scale helicopter rotor in forward flight. A wide range of test conditions were examined, including thrust and forward speed variations. Shadowgraphs from the side and top of the rotor were obtained. The visibility of the tip vortices using the shadowgraph method was documented for advance ratios up to 0.175. It was demonstrated that shadowgraphs of the rotor wake in forward flight can be used to obtain qualitative and quantitative information about wake geometry, wake/body interactions, and blade/vortex interactions. Video cameras were used for the first time to record the shadowgraphs. These provided several advantages compared to still cameras and greatly enhanced the capabilities of the shadowgraph method.

Light, Jeffrey S.↗
NASA NTRS1989

Application of the wide-field shadowgraph technique to rotor wake visualization

The wide field shadowgraph technique is reviewed along with its application to the visualization of rotor wakes. In particular, current experimental methods and data reduction requirements are discussed. Sample shadowgraphs are presented. These include shadowgraphs of model-scale helicopter main rotors and tilt rotors, and full scale tail rotors, both in hover and in forward flight.

Norman, Thomas R.↗
NASA NTRS1989

Tip vortex geometry of a hovering helicopter rotor in ground effect

The wide-field shadowgraph method has been used to photograph the tip vortices of a hovering helicopter rotor in ground effect. The shadowgraphs were used to obtain quantitative measurements of the rotor tip vortex geometry both in and out of ground effect. Many important phenomena are visible in the rotor wake using this method. These include the variation in descent and contraction rates of the tip vortices in ground effect, and the interaction between tip vortices in the far wake. The tip vortex geometry from the shadowgraphs is compared with the tip vortex geometry predicted using a free wake hover performance analysis. The free wake analysis accurately predicts the tip vortex geometry both in and out of ground effect. Performance data from the test is compared with the performance predicted using several methods, including the free wake analysis. All methods provided reasonable predictions for the helicopter performance in ground effect.

Light, Jeffrey S.↗
NASA NTRS1988

Comparisons of predicted and measured rotor performance in hover using a new free wake analysis

A new free-wake analysis has been developed to predict the performance of rotors in hover and axial flight. The analysis finds the rotor wake geometry using a novel influence coefficient/relaxation scheme. In this paper, the features of the analysis are reviewed, and the accuracy of the analysis is assessed for a wide range of rotor configurations in hover and vertical climb. The effects of variations in the analysis parameters are addressed, and recommendations for future development are presented. Generally good results were obtained for the predicted performance of a wide range of rotor geometries and operating conditions without any special 'tuning' of the analysis. The analysis also provides predictions of rotor performance in vertical climb that are substantially more accurate than momentum theory.

Felker, Fort F.↗
NASA NTRS1987

Reduction of tilt rotor download using circulation control

The effect of boundary layer control blowing on the download of a wing in the wake of a hovering rotor was measured in a small scale experiment. The objective was to evaluate the potential of boundary layer control blowing for reducing tilt rotor download. Variations were made in rotor thrust coefficient, blowing pressure ratio, and blowing slot height. The effect of these parameter variations on the wing download and wing surface pressures is presented. The boundary layer control blowing caused reductions in the wing download of 25 to 55 percent.

Felker, Fort F.↗
NASA NTRS1987

Analysis of induced velocities in the wake of a hovering helicopter rotor

A simple analytical method has been developed to predict the induced velocities at the tip vortex in the wake of a hovering helicopter rotor. The wake model in the analysis includes the blade bound vortex as well as a tip vortex and vortex sheet trailed from each blade. Standard, prescribed wake models were used to describe the geometry of the tip vortex and the vortex sheet. Curved vortex elements were used to model the tip vortices and the vortex sheets. The analysis was used to study the contribution from each wake component to the axial-induced velocity of the tip vortex. Results show a highly variable induced velocity at the tip vortex both before and after the first blade passage. However, the prescribed tip vortex models require a constant axial velocity of the tip vortex. This inconsistency between the prescribed axial velocity of the tip vortex and the velocity that the wake geometry induces on the tip vortex points to a limitation of the current prescribed tip vortex geometry models.

Light, Jeffrey S.↗
NASA NTRS1987

An assessment of upper surface blowing for the reduction of tilt rotor download

A study evaluating the use of upper-surface blowing to reduce the wing download on a V-22 tilt rotor aircraft has been completed. The study assesses the penalties associated with the upper-surface blowing system (compressor weight, compressor power, etc.), and the reduction in wing download, for a wide range of blowing slot heights and blowing pressure ratios. Three wing configurations were investigated: blowing at both leading and trailing edges with no change in wing planform relative to the V-22 tilt rotor aircraft, blowing at both leading and trailing edges with a 25% reduction in wing chord, and blowing at the leading edge only with the flap deflected 75 deg. Predicted download is presented for all of these configurations, and is compared with the download of the baseline V-22 tilt rotor aircraft configuration. The optimum configuration had 15% less net download than the baseline V-22 configuration.

Faye, Robert E.↗
NASA NTRS1986

Aerodynamic interactions between a rotor and wing in hover

An experimental investigation of rotor/wing aerodynamic interactions in hover is described. The investigation consisted of both a large-scale and a small-scale test. A 0.658-scale V-22 rotor and wing was used in the large-scale test. Wing download, wing surface pressure, rotor performance, and rotor downwash data from the large-scale test are presented. A small-scale experiment was conducted to determine how changes in the rotor/wing geometry affected the aerodynamic interactions. These geometry variations included the distance between the rotor and wing, wing incidence angle, wing flap angle, rotor rotation direction, and configurations both with the rotor axis at the tip of the wing (tilt rotor configuration) and with the rotor axis at the center of the wing (compound helicopter configuration).

Felker, Fort F.↗