Engineering topics
Publications and source records attributed to Li, Wenzhen.
Single-atom metal embedded in nitrogen-doped carbon show high HER performance, with Co-NAC reaching 200 mA cm −2 at 310 mV overpotential.
Abstract Here, low‐energy poly(ethylene terephthalate) (PET) chemical recycling in water: PET copolymers with diethyl 2,5‐dihydroxyterephthalate (DHTE) undergo selective hydrolysis at DHTE sites, autocatalyzed by neighboring group participation, is demonstrated. Liberated oligomeric subchains further hydrolyze until only small molecules remain. Poly(ethylene terephthalate‐ stat ‐2,5‐dihydroxyterephthalate) copolymers were synthesized via melt polycondensation and then hydrolyzed in 150–200 °C water with 0–1 wt% ZnCl 2 , or alternatively in simulated sea water. Degradation progress follows pseudo‐first order kinetics. With increasing DHTE loading, the rate constant increases monotonically while the thermal activation barrier decreases. The depolymerization products are ethylene glycol, terephthalic acid, 2,5‐dihydroxyterephthalic acid, and bis(2‐hydroxyethyl) terephthalate dimer, which could be used to regenerate virgin polymer. Composition‐optimized copolymers show a decrease of nearly 50% in the Arrhenius activation energy, suggesting a 6‐order reduction in depolymerization time under ambient conditions compared to that of PET homopolymer. This study provides new insight to the design of polymers for end‐of‐life while maintaining key properties like service temperature and mechanical properties. Moreover, this chemical recycling procedure is more environmentally friendly compared to traditional approaches since water is the only needed material, which is green, sustainable, and cheap.
Anion exchange member (AEM) fuel cells have gained great attention recently mainly owing to the advantages of non-precious metal catalysts application. Despite of the similar oxygen reduction reaction (ORR) kinetics in acid and base, the reaction kinetics of hydrogen oxidation reaction (HOR) is two orders of magnitude slower in alkaline systems than in acid. To understand the slower kinetics of HOR in base, two major interpretations have been proposed, including 1) hydrogen binding energy as a major descriptor for HOR in both acid and base; and 2) bifunctional theory based on the contributions from both hydrogen and hydroxide adsorption for HOR in alkaline electrolyte. Here, we discuss the possible HOR mechanisms in alkaline electrolytes with the corresponding Tafel behavior change. Besides the discussion of traditional Tafel-Volmer and Heyrovsky-Volmer HOR mechanisms, the recently proposed hydroxide adsorption step is discussed to illustrate the HOR mechanism difference in acid and base. We further correlate the hydroxide adsorption step involved mechanism with HOR catalyst design, and summarize its role in HOR and HER activities improvement in alkaline electrolyte over the same catalyst. The representative works of alkaline HOR catalyst development were briefly introduced, and the strategy of strengthening interaction between H2 desorption and H2O recombination was finally proposed for future HOR catalyst design in alkaline environment.
Quinones are appealing targets as organic electrolytes for aqueous redox flow batteries (RFBs), but their utility continues to be constrained by limited stability under operating conditions. The present study evaluates the stability of a series water-soluble quinones, with redox potentials ranging from 605–885 mV vs. NHE, under acidic aqueous conditions (1 M H2SO4). Four of the quinones are examined as cathodic electrolytes in an aqueous RFB, paired with anthraquinone-2,7-disulfonate (AQDS) as the anodic electrolyte. The RFB data complement the solution stability measures and show that the most stable electrolyte is a tetrasubstituted quinone containing four sulfonated thioether substituents. The results highlight the importance of substituting all C–H positions of the quinone in order to maximize the quinone stability and set the stage for design of improve organic electrolytes for aqueous RFBs. The authors thank Joseph Fourie for assisting in the synthesis of compound 8. Financial support for this work was provided by the Center for Molecular Electrocatalysis, an Energy Frontier Research Center funded by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences (SSS, TWR, JBG, CWA, YP), with supplemental contributions by the Wisconsin Alumni Research Foundation (WARF) through the WARF Accelerator Program (YQ and partial support for JBG, CWA, YP). NMR spectroscopy facilities were partially supported by the NSF (CHE-0342998 and CHE-1048642), a UW Madison Instructional Laboratory Modernization Award, and a gift from Paul J. and Margaret M. Bender.