Engineering Papers⌕ Search

Engineering topics

Li, L

Publications and source records attributed to Li, L.

78 records · Page 5

Desulphurization and simultaneous treatment of wastewater from blast furnace by pulsed corona discharge

Laboratory tests were conducted for removal of SO{sub 2} from simulated flue gas and simultaneous treatment of wastewater from blast furnace by pulsed corona discharge. Tests were conducted for the flue gas flow from 12 to 18 Nm{sup 3}/h, the simulated gas temperature from 80 to 120 {sup o}C, the inlet flux of wastewater from 33 to 57 L/h, applied voltage from 0 to 27 kV, and SO{sub 2} initial concentration was about 1,430 mg/m{sup 3}. Results showed that wastewater from blast furnace has an excellent ability of desulphurization (about 90%) and pulsed corona discharge can enhance the desulphurization efficiency. Meanwhile, it was observed that the SO{sub 2} removal ratio decreased along with increased cycle index, while it increased as the flux of flue gas was reduced, and increased when the flux of wastewater from blast furnace was increased. In addition, results demonstrated that the content of sulfate radical produced in wastewater increase with an increment of applied pulsed voltage, cycle index, or the flux of flue gas. Furthermore, the results indicated that the higher the inlet content of cyanide the better removal effect of it, and the removal rate can reach 99.9% with a residence time of 2.1 s in the pulsed corona zone during the desulphurization process when the inlet content was higher, whereas there was almost no removal effect when the inlet content was lower. This research may attain the objective of waste control, and can provide a new way to remove SO{sub 2} from flue gas and simultaneously degrade wastewater from blast furnace for integrated steel plants.

01 COAL, LIGNITE, AND PEAT↗

An Exploratory Study of the Viscoelasticity of Phase-Transforming Material

Attenuation and modulus dispersion are typically associated with shear stress and strain. Time-dependent volume changes accompanying pressure variations can give rise to bulk modulus attenuation and dispersion. Phase transformations in a two-phase region are candidates for such phenomena. Here we report laboratory data that are consistent with bulk modulus softening as pressure is cycled in a region of coexisting olivine and spinel. We use Fay70For30 olivine as our sample. Experiments are performed in a multi-anvil high-pressure apparatus (Deformation DIA) using synchrotron (NSLS) X-ray radiation as the probing tool. Pressure is up to 12 GPa and temperature is up to 1450 C. Measurements were carried out within the binary loop where the olivine and spinel phases coexist. We apply a uniaxial oscillation stress onto the sample and Young's modulus and Q{sup -1} are measured at frequencies of 0.1-0.01 Hz. Our results indicate that the sinusoidal force applied to the sample in olivine-ringwoodite region has much lower bulk modulus and higher Q{sup -1} than in the single-phase regions. Our data are consistent with the diffusion controlled model of (Jackson, I., 2007. Physical origins of anelasticity and attenuation in rock, In: Price, G.D. (Ed.) Mineral Physics. Treatise On Geophysics. Elsevier), where the characteristic time decreases with decreasing strain.

04 OIL SHALES AND TAR SANDS↗

Studies of Mineral Properties at Mantle Condition using Deformation Multi-Anvil Apparatus

This paper reports recent studies of the rheological and viscoelastic properties of minerals at mantle pressure and temperature using Deformation multi-anvil apparatus (D-DIA). Stress-strain-time relations were measured using synchrotron X-ray radiation to determine these properties. Rheological properties of San Carlos olivine were measured at pressure up to 10 GPa and indicated that the effect of pressure on the viscosity of olivine is much smaller than previous reported. The unique capability of synchrotron X-ray can resolve the stress heterogeneity within a polycrystalline material as well as within a multi-phase mixture and elucidate the stress-strain distribution in an aggregate. Anelasticity measurements were carried out using olivine as the sample at mantle pressure and temperatures. The results showed that grain boundary activity rather than pressure dominate the relaxation processes. The aim of this paper is to illustrate the methods using new tools for high pressure research.

58 GEOSCIENCES↗

Weakening of Calcium Iridate During its Transformation from Perovskite to Post-Perovskite

The lowermost part of the Earth's mantle - the {approx}200-km-thick D{double_prime} layer - shows anomalous seismic properties, and is rheologically distinct from the rest of the lower mantle. The difference is thought to result from a phase transition from silicate perovskite to silicate post-perovskite. However, the rheology of the latter phase remains to be documented owing to experimental difficulties in reproducing pressures equivalent to those in the lowermost mantle. Here we address this problem by conducting laboratory experiments that use calcium iridate, which has been shown to be an appropriate low-pressure analogue. We find that the post-perovskite phase of this analogue is approximately five times weaker than its perovskite phase, and that it further weakens by a factor of two during the phase transformation; these are minimum estimates. If, as is likely, a similar weakening occurs in lower-mantle magnesium - silicate compositions, this could provide an explanation for the behaviour of the lowermost mantle as inferred from geophysical data.

58 GEOSCIENCES↗

Enhanced Electrochemical Lithium Storage Activity of LiCrO2 by Size Effect

Cr8O21 was chemically lithiated using a lithium-biphenyl-dimethoxyethane solution. Lithiated Cr8O21 shows a structure in which as-formed LiCrO2 units are sandwiched between Cr2O3 superlattice layers. Chemically lithiated Cr8O21 shows a delithiation capacity of 200 mAh g-1. It means that LiCrO2 units in lithiated Cr8O21 are electrochemically active. This finding is opposite to previous reports that LiCrO2 materials have very poor Li-storage capacities. Our new result implies that LiCrO2 with extremely small domain size could show enhanced reactivity. This proposal is proved unambiguously by the fact that LiCrO2 powder materials with smaller grain size (<20 nm) show much higher capacities than LiCrO2 materials with larger grain size (>50 nm). In addition, it is found that the cation mixing is more significantly in LiCrO2 materials with smaller grain size, which seems a key factor for the storage and transport of lithium in layered Cr-based materials. The cation mixing may also explain the result that the lattice parameters of LiCrO2 do not change significantly upon lithium extraction and insertion, investigated by in situ and ex situ XRD techniques.

25 ENERGY STORAGE↗

{sigma}{sigma} interactions in finite-density QCD sum rules

The properties of {sigma}-hyperons in pure {sigma} matter are studied with the finite-density quantum chromodynamics sum rule (QCDSR) approach. The {sigma}{sigma} nuclear potential U{sub {sigma}} is most likely strongly attractive, it could be about -50 MeV or even more attractive at normal nuclear density. If this prediction is the case, the interactions between {sigma}-hyperons should play crucial roles in the strange nuclear matter, when there are multi-{sigma} hyperons. The bound state of the double-{sigma} may exist.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗