Engineering Papers⌕ Search

Engineering topics

Li, H.

Publications and source records attributed to Li, H..

At least 163 records · Page 9

Microwires fabricated by glass-coated melt spinning

The glass-coated melt spinning method offers a route for the manufacture of metal filaments with a few micrometers in diameter in a single operation directly from the melt. Cobalt-based amorphous wires, Cu-15.0 atomic percent (at. %) Sn shape-memory wires, and Ni{sub 2}MnGa (atomic percent) ferromagnetic wires were successfully produced by this method. The cobalt-based amorphous wire is flexible, and Cu-15.0 at. % Sn shape-memory wires have the tensile elongation of 14%. However, because of chemical reaction with glass and oxidation, it is hard to make Cu–Al–Ni shape-memory wires and Ni–Nb–Sn amorphous wires. Conditions for preparing these materials were summarized, and the differences of the solidification processes among glass-coated amorphous cobalt-based wires, Cu-15.0 at. % Sn shape-memory wires, and Ni{sub 2}MnGa wires were analyzed and discussed.

36 MATERIALS SCIENCE↗

Commissioning dose computation models for spot scanning proton beams in water for a commercially available treatment planning system

Purpose: To present our method and experience in commissioning dose models in water for spot scanning proton therapy in a commercial treatment planning system (TPS). Methods: The input data required by the TPS included in-air transverse profiles and integral depth doses (IDDs). All input data were obtained from Monte Carlo (MC) simulations that had been validated by measurements. MC-generated IDDs were converted to units of Gy mm{sup 2}/MU using the measured IDDs at a depth of 2 cm employing the largest commercially available parallel-plate ionization chamber. The sensitive area of the chamber was insufficient to fully encompass the entire lateral dose deposited at depth by a pencil beam (spot). To correct for the detector size, correction factors as a function of proton energy were defined and determined using MC. The fluence of individual spots was initially modeled as a single Gaussian (SG) function and later as a double Gaussian (DG) function. The DG fluence model was introduced to account for the spot fluence due to contributions of large angle scattering from the devices within the scanning nozzle, especially from the spot profile monitor. To validate the DG fluence model, we compared calculations and measurements, including doses at the center of spread out Bragg peaks (SOBPs) as a function of nominal field size, range, and SOBP width, lateral dose profiles, and depth doses for different widths of SOBP. Dose models were validated extensively with patient treatment field-specific measurements. Results: We demonstrated that the DG fluence model is necessary for predicting the field size dependence of dose distributions. With this model, the calculated doses at the center of SOBPs as a function of nominal field size, range, and SOBP width, lateral dose profiles and depth doses for rectangular target volumes agreed well with respective measured values. With the DG fluence model for our scanning proton beam line, we successfully treated more than 500 patients from March 2010 through June 2012 with acceptable agreement between TPS calculated and measured dose distributions. However, the current dose model still has limitations in predicting field size dependence of doses at some intermediate depths of proton beams with high energies. Conclusions: We have commissioned a DG fluence model for clinical use. It is demonstrated that the DG fluence model is significantly more accurate than the SG fluence model. However, some deficiencies in modeling the low-dose envelope in the current dose algorithm still exist. Further improvements to the current dose algorithm are needed. The method presented here should be useful for commissioning pencil beam dose algorithms in new versions of TPS in the future.

60 APPLIED LIFE SCIENCES↗

Recent progress in R&D on tungsten alloys for divertor structural and plasma facing materials

Tungsten materials are candidates for plasma facing components for ITER and DEMO because of their superior thermophysical properties. Knowledge and strategies to improve properties of tungsten-based materials are still under development, as they are not a common structural material such as steel. Consequently, several activities have started in Europe, Japan, USA and China. Research is directed towards manufacturing of new materials based on alloying, microstructure stabilizing and composite formation involving improved processing steps. Beside experimental analyses, work also focuses on computational treatment of open questions, supporting the development of better tungsten materials. Assuming the availability of an ideal material that is ready to use, there remain the questions of inherent safety, the joining of tungsten to steel and the influence of radiation damage. These are topics of increasing interest when the material comes to application.

tungsten alloys, divertor structural materials, fu↗

VARIABILITY OF THE PULSED RADIO EMISSION FROM THE LARGE MAGELLANIC CLOUD PULSAR PSR J0529-6652

We have studied the variability of PSR J0529-6652, a radio pulsar in the Large Magellanic Cloud (LMC), using observations conducted at 1390 MHz with the Parkes 64 m telescope. PSR J0529-6652 is detectable as a single pulse emitter, with amplitudes that classify the pulses as giant pulses. This makes PSR J0529-6652 the second known giant pulse emitter in the LMC, after PSR B0540-69. The fraction of the emitted pulses detectable from PSR J0529-6652 at this frequency is roughly two orders of magnitude greater than it is for either PSR B0540-69 or the Crab pulsar (if the latter were located in the LMC). We have measured a pulse nulling fraction of 83.3% {+-} 1.5% and an intrinsic modulation index of 4.07 {+-} 0.29 for PSR J0529-6652. The modulation index is significantly larger than values previously measured for typical radio pulsars but is comparable to values reported for members of several other neutron star classes. The large modulation index, giant pulses, and large nulling fraction suggest that this pulsar is phenomenologically more similar to these other, more variable sources, despite having spin and physical characteristics that are typical of the unrecycled radio pulsar population. The large modulation index also does not appear to be consistent with the small value predicted for this pulsar by a model of polar cap emission outlined by Gil and Sendyk. This conclusion depends to some extent on the assumption that PSR J0529-6652 is exhibiting core emission, as suggested by its simple profile morphology, narrow profile width, and previously measured profile polarization characteristics.

79 ASTRONOMY AND ASTROPHYSICS↗

Laboratory report on iodine ( 129 I and 127 I) speciation, transformation and mobility in Handford groundwater, suspended particles and sediments

The Hanford Site in eastern Washington produced plutonium for several decades and in the process generated billions of gallons of radioactive waste. Included in this complex mixture of waste was 50 Ci of iodine-129 ( 129 I). Iodine-129’s high abundance, due to its high fission yield, and extreme toxicity result in iodine-129 becoming a key risk driver at many Department of Energy (DOE) sites. The mobility of radioiodine in arid environments, such as the Hanford Site, depends largely on its chemical speciation and is also greatly affected by many other environmental factors, especially natural sediment organic matter (SOM). Groundwater radioiodine speciation has not been measured in arid regions with major plumes or large disposed 129 I inventories, including the Hanford Site, Idaho National Laboratory, and Nevada Test Site. In this study, stable iodine-127 and radioiodine-129 speciation, pH, and dissolved organic carbon (DOC) of groundwater samples collected from seven wells located in the 200-West Area of the Hanford site were investigated. The most striking finding was that iodate (IO 3 - ) was the most abundant species. Unexpectedly, iodide (I - ), which was likely the form of iodine in the source materials and the expected dominant groundwater species based on thermodynamic considerations, only accounted for 1-2% of the total iodine concentration. It is likely that the relatively high pH and the low abundance of sedimentary organic matter (SOM) that is present at the site slowed down or even inhibited the reduction of iodate, as SOM abiotically reduce iodate into iodide. Moreover, a study on the kinetics of iodide and iodate uptake and aqueous speciation transformation by three representative subsurface Hanford sediments was performed over a period of about one month. This study was carried out by using iodide-125 or iodate-125 at the ambient iodine-127concentration found at the site. Iodate K d values were on average 89% greater than iodide K d values, and the K d values for both species tended to increase with the amount of organic carbon (OC) present in the sediment. It is especially noteworthy that this trend existed at the very low OC concentrations that naturally exist in the Hanford sediments. Iodine and OC can form essentially irreversible covalent bonds, thereby providing a yet unstudied 129 I retardation reaction at the Hanford Site. In addition to the transformation of iodine species, the sediment collected from the vadose zone also released stable iodide into the aqueous phase. It was found that the three sediments all took up the ambient iodate from the groundwater and slowly transformed it into iodide under the laboratory conditions, likely dependent on the abundance of reducing agents such as organic matter and Fe 2+ . Therefore two competitive iodine processes were identified, the tendency for the sediment to reduce iodate to iodide, and the groundwater chemistry to maintain the iodine as iodate, presumably it is largely the result of natural pH and dissolved O 2 /Eh levels. Suspended carbonate (and silica) particles collected from Hanford groundwater contained elevated amounts of iodine (142 ± 8 μg/g iodine), consisting mainly of iodate (>99%). Iodate was likely incorporated into the carbonate structure during calcite precipitation upon degasing of CO 2 as the groundwater samples were removed from the subsurface. This concentration of groundwater iodate in precipitated carbonate has implication to long-term fate and transport of 129 I and on active in-situ 129 I groundwater remediation. This study provides some of the first groundwater radioiodine speciation studies conducted in arid environments and provides much needed mechanistic descriptions to permit making informed decisions about low-cost/high intellectual input remediation options, such as monitored natural attenuation, or long-term stewardship of nuclear waste disposal sites.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

An analysis of the sliding pressure start-up of SCWR

In this paper, the preliminary sliding pressure start-up system and scheme of supercritical water-cooled reactor in CGNPC (CGN-SCWR) were proposed. Thermal-hydraulic behavior in start-up procedures was analyzed in detail by employing advanced reactor subchannel analysis software ATHAS. The maximum cladding temperature (MCT for short) and core power of fuel assembly during the whole start-up process were investigated comparatively. The results show that the recommended start-up scheme meets the design requirements from the perspective of thermal-hydraulic. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗