Engineering Papers⌕ Search

Engineering topics

Li, F

Publications and source records attributed to Li, F.

At least 19 records

A Global Methane Observation System to Reduce Uncertainty for Anthropogenic and Natural Sources and Sinks for Detecting and Attributing Climate Feedbacks

Atmospheric methane (CH4) concentrations are accelerating global warming as net emissions increase. Observing systems that quantify sources remain too sparse and fragmented to detect trends—especially in remote regions where climate‐driven natural emissions may be rising. We provide a framework for quantifying uncertainty reductions through the implementation of a global ecosystem‐methane observing system designed to: (i) substantially lower uncertainty in sectoral and regional emissions, (ii) separate co‐occurring anthropogenic and natural fluxes, and (iii) trend detection at regional scales to verify mitigation progress and provide early warning of natural feedbacks. Using bottom‐up inventories and process‐model ensembles for 2014–2023, we show that anthropogenic emissions remain uncertain by ∼32% globally, while natural sources—tropical and boreal‐arctic wetlands, fires, and inland waters—carry far larger uncertainties (+ 70%) and trend uncertainties reaching ∼200%. Additional observations must match spatial emission structure to increase observability of emissions: high‐resolution satellite constellations for point sources combined with expanded flux networks and wetland mapping for diffuse sources, and denser ground‐based atmospheric column measurements to restore observability in under‐sampled tropics and high latitudes. Notional analyses indicate that targeted additions of flux towers and ∼20 in situ atmospheric column concentration instruments per key tropical region could reduce continental‐scale uncertainties at modest cost. Conceptual illustration of a Global Ecosystem Methane Observing System (GEM‐OS) integrating satellites, aircraft, atmospheric networks, and ecosystem measurements to quantify methane emissions from anthropogenic and natural sources. The multi‐scale observing framework improves source attribution, reduces uncertainty in regional methane budgets, and enables early detection of climate‐driven feedbacks from wetlands, fires, permafrost, agriculture, and fossil‐fuel emissions.

Ciais, P↗

Study of the wave packet treatment of neutrino oscillation at Daya Bay

The disappearance of reactor $\bar{\nu}_e$ observed by the Daya Bay experiment is examined in the framework of a model in which the neutrino is described by a wave packet with a relative intrinsic momentum dispersion $\sigma_\text{rel}$. Three pairs of nuclear reactors and eight antineutrino detectors, each with good energy resolution, distributed among three experimental halls, supply a high-statistics sample of $\bar{\nu}_e$ acquired at nine different baselines. This provides a unique platform to test the effects which arise from the wave packet treatment of neutrino oscillation. The modified survival probability formula was used to fit Daya Bay data, providing the first experimental limits: $2.38 \cdot 10^{-17} < \sigma_{\rm rel} < 0.23$. Treating the dimensions of the reactor cores and detectors as constraints, the limits are improved: $10^{-14} \lesssim \sigma_{\rm rel} < 0.23$, and an upper limit of $\sigma_{\rm rel} <0.20$ is obtained. All limits correspond to a 95\% C.L. Furthermore, the effect due to the wave packet nature of neutrino oscillation is found to be insignificant for reactor antineutrinos detected by the Daya Bay experiment thus ensuring an unbiased measurement of the oscillation parameters $\sin^22\theta_{13}$ and $\Delta m^2_{32}$ within the plane wave model.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Response of precipitation extremes to idealized global warming in an aqua-planet climate model: towards a robust projection across different horizontal resolutions

Current climate models produce quite heterogeneous projections for the responses of precipitation extremes to future climate change. To help understand the range of projections from multimodel ensembles, a series of idealized 'aquaplanet' Atmospheric General Circulation Model (AGCM) runs have been performed with the Community Atmosphere Model CAM3. These runs have been analysed to identify the effects of horizontal resolution on precipitation extreme projections under two simple global warming scenarios. We adopt the aquaplanet framework for our simulations to remove any sensitivity to the spatial resolution of external inputs and to focus on the roles of model physics and dynamics. Results show that a uniform increase of sea surface temperature (SST) and an increase of low-to-high latitude SST gradient both lead to increase of precipitation and precipitation extremes for most latitudes. The perturbed SSTs generally have stronger impacts on precipitation extremes than on mean precipitation. Horizontal model resolution strongly affects the global warming signals in the extreme precipitation in tropical and subtropical regions but not in high latitude regions. This study illustrates that the effects of horizontal resolution have to be taken into account to develop more robust projections of precipitation extremes.

54 ENVIRONMENTAL SCIENCES↗

SU-C-BRC-04: Efficient Dose Calculation Algorithm for FFF IMRT with a Simplified Bivariate Gaussian Source Model

Purpose: To develop an efficient and accurate independent dose calculation algorithm with a simplified analytical source model for the quality assurance and safe delivery of Flattening Filter Free (FFF)-IMRT on an Elekta Versa HD. Methods: The source model consisted of a point source and a 2D bivariate Gaussian source, respectively modeling the primary photons and the combined effect of head scatter, monitor chamber backscatter and collimator exchange effect. The in-air fluence was firstly calculated by back-projecting the edges of beam defining devices onto the source plane and integrating the visible source distribution. The effect of the rounded MLC leaf end, tongue-and-groove and interleaf transmission was taken into account in the back-projection. The in-air fluence was then modified with a fourth degree polynomial modeling the cone-shaped dose distribution of FFF beams. Planar dose distribution was obtained by convolving the in-air fluence with a dose deposition kernel (DDK) consisting of the sum of three 2D Gaussian functions. The parameters of the source model and the DDK were commissioned using measured in-air output factors (Sc) and cross beam profiles, respectively. A novel method was used to eliminate the volume averaging effect of ion chambers in determining the DDK. Planar dose distributions of five head-and-neck FFF-IMRT plans were calculated and compared against measurements performed with a 2D diode array (MapCHECK™) to validate the accuracy of the algorithm. Results: The proposed source model predicted Sc for both 6MV and 10MV with an accuracy better than 0.1%. With a stringent gamma criterion (2%/2mm/local difference), the passing rate of the FFF-IMRT dose calculation was 97.2±2.6%. Conclusion: The removal of the flattening filter represents a simplification of the head structure which allows the use of a simpler source model for very accurate dose calculation. The proposed algorithm offers an effective way to ensure the safe delivery of FFF-IMRT.

60 APPLIED LIFE SCIENCES↗

SU-F-T-273: Using a Diode Array to Explore the Weakness of TPS DoseCalculation Algorithm for VMAT and Sliding Window Techniques

Purpose: To identify the weakness of dose calculation algorithm in a treatment planning system for volumetric modulated arc therapy (VMAT) and sliding window (SW) techniques using a two-dimensional diode array. Methods: The VMAT quality assurance(QA) was implemented with a diode array using multiple partial arcs that divided from a VMAT plan; each partial arc has the same segments and the original monitor units. Arc angles were less than ± 30°. Multiple arcs delivered through consecutive and repetitive gantry operating clockwise and counterclockwise. The source-toaxis distance setup with the effective depths of 10 and 20 cm were used for a diode array. To figure out dose errors caused in delivery of VMAT fields, the numerous fields having the same segments with the VMAT field irradiated using different delivery techniques of static and step-and-shoot. The dose distributions of the SW technique were evaluated by creating split fields having fine moving steps of multi-leaf collimator leaves. Calculated doses using the adaptive convolution algorithm were analyzed with measured ones with distance-to-agreement and dose difference of 3 mm and 3%.. Results: While the beam delivery through static and step-and-shoot techniques showed the passing rate of 97 ± 2%, partial arc delivery of the VMAT fields brought out passing rate of 85%. However, when leaf motion was restricted less than 4.6 mm/°, passing rate was improved up to 95 ± 2%. Similar passing rate were obtained for both 10 and 20 cm effective depth setup. The calculated doses using the SW technique showed the dose difference over 7% at the final arrival point of moving leaves. Conclusion: Error components in dynamic delivery of modulated beams were distinguished by using the suggested QA method. This partial arc method can be used for routine VMAT QA. Improved SW calculation algorithm is required to provide accurate estimated doses.

60 APPLIED LIFE SCIENCES↗

SU-F-T-518: Development and Characterization of a Gated Treatment System Implemented with An In-House Optical Tracking System and the Elekta Response Interface

Purpose: To report the development and characterization of the first in-house gating system implemented with an optical tracking system (OTS) and the Elekta Response™ interface. Methods: The Response™ connects a patient tracking system with a linac, enabling the tracking system to control radiation delivery. The developed system uses an in-house OTS to monitor patient breathing. The OTS consists of two infrared-based cameras, tracking markers affixed on patient. It achieves gated or breath-held (BH) treatment by calling beam ON/OFF functions in the Response™ dynamic-link library (DLL). A 4D motion phantom was used to evaluate its dosimetric and time delay characteristics. Two FF- and two FFF-IMRT beams were delivered in non-gated, BH and gated mode. The sinusoidal gating signal had a 6 sec period and 15 mm amplitude. The duty cycle included 10%, 20%, 30% and 50%. The BH signal was adapted from the sinusoidal wave by inserting 15 sec BHs. Each delivery was measured with a 2D diode array (MapCHECK™) and compared with the non-gated delivery using gamma analysis (3%). The beam ON/OFF time was captured using the service graphing utility of the linac. Results: The gated treatments were successfully delivered except the 10% duty cycle. The BH delivery had perfect agreement (100%) with non-gated delivery; the agreement of gated delivery decreased from 99% to 88% as duty cycle reduced from 50% to 20%. The beam on/off delay was on average 0.25/0.06 sec. The delivery time for the 50%, 30% and 20% duty cycle increased by 29%, 71% and 139%, respectively. No dosimetric or time delay difference was noticed between FF- and FFF-IMRT beams. Conclusion: The in-house gating system was successfully developed with dosimetric and time delay characteristics in line with published results for commercial systems. It will be an important platform for further research and clinical development of gated treatment.

43 PARTICLE ACCELERATORS↗

The novel phase transition of NaBi(WO{sub 4}){sub 2} under high pressure

The Raman and synchrotron angle-dispersive X-ray diffraction studies have been performed on NaBi(WO{sub 4}){sub 2} under high pressure up to 30.7 and 36.2 GPa, respectively, at room temperature. With pressure increases to ∼7.0 GPa, the structure of NaBi(WO{sub 4}){sub 2} begins to transform from tetragonal (I4{sub 1}/a) into monoclinic (P2/m), and the phase transition completes around 13 GPa. With pressure higher than 29.0 GPa, the NaBi(WO{sub 4}){sub 2} turns into amorphous state. The random arrangement of Na{sup +} and Bi{sup 3+} in short-range ordered scheelite NaBi(WO{sub 4}){sub 2} results in the tetragonal to monoclinic phase transition, which is different from that observed in AWO{sub 4} tungstates and AMoO{sub 4} molybdates (A=Ca, Sr, Ba, Pb, Eu, Cd). - Graphical abstract: The NaBi(WO{sub 4}){sub 2} transforms from tetragonal into monoclinic, which starts around 7 GPa and completes at about 13 GPa. With pressure higher than 29 GPa, the NaBi(WO{sub 4}){sub 2} turns into amorphous state. Highlights: ► Raman and X-ray diffraction studies performed on NaBi(WO{sub 4}){sub 2} up to 30.7 and 36.2 GPa, respectively. ► The tetragonal (I4{sub 1}/a) into monoclinic (P2/m) phase transition is determined. ► With pressure higher than 29 GPa, the NaBi(WO{sub 4}){sub 2} ultimately turns into amorphous state. ► The ambient pressure bulk modulus and volume of tetragonal and monoclinic phases are obtained.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

MP-Pic simulation of CFB riser with EMMS-based drag model

MP-PIC (multi-phase particle in cell) method combined with the EMMS (energy minimization multi- scale) drag force model was implemented with the open source program MFIX to simulate the gas–solid flows in CFB (circulatingfluidizedbed) risers. Calculated solid flux by the EMMS drag agrees well with the experimental value; while the traditional homogeneous drag over-predicts this value. EMMS drag force model can also predict the macro-and meso-scale structures. Quantitative comparison of the results by the EMMS drag force model and the experimental measurements show high accuracy of the model. The effects of the number of particles per parcel and wall conditions on the simulation results have also been investigated in the paper. This work proved that MP-PIC combined with the EMMS drag model can successfully simulate the fluidized flows in CFB risers and it serves as a candidate to realize real-time simulation of industrial processes in the future.

97 MATHEMATICS AND COMPUTING↗

Pressure-induced Structrual Transitino in CaF2 Nanocrystals

The structural transition of CaF{sub 2} nanocrystals was studied by in situ high pressure synchrotron radiation X-ray diffraction measurements up to about 46.5?GPa at ambient temperature. A pressure-induced fluorite structure (Fm3m) to orthorhombic PbCl{sub 2}-type structure (Pnma) transition starts at 14.0?GPa, and phase transition is sluggish. The orthorhombic phase of nanocrystalline CaF{sub 2} is stable up to 46.5?GPa. The enhancement of transition pressure in CaF{sub 2} nanocrystals as compared with the corresponding bulk material is mainly caused by the surface energy difference between the phases involved.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Rotator Phases of n-Heptane under High Pressure: Raman Scattering and X-ray Diffraction Studies

We performed high-pressure Raman scattering and angle-dispersive synchrotron X-ray diffraction measurements on n-heptane at room temperature. It has been found that n-heptane undergoes a liquid to rotator phase III (R{sub III}) transition at 1.2 GPa and then transforms into another rotator phase R{sub IV} at about 3 GPa. As the pressure reaches 7.5 GPa, a transition from an orientationally disordered R{sub IV} phase to an ordered crystalline state starts and is completed around 14.5 GPa. Our results clearly present the high-pressure phase transition sequence (liquid-R{sub III}-R{sub IV}-crystal) of n-heptane, similar to that of normal alkanes.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗