Engineering Papers⌕ Search

Engineering topics

Li, Danyang

Publications and source records attributed to Li, Danyang.

Flash ironmaking drop tube furnace system

A flash ironmaking drop tube furnace includes a primary reaction section having a refractory, an induction coil around the refractory, insulation located between the refractory and the induction coil, and a susceptor located inside the refractory, the susceptor being formed of a material that is heated by induction when electrical current flows through the induction coil, and having at least one interior channel through which particles can pass. The furnace further includes a muffle, located below the primary reaction section; an outer shell surrounding the muffle; at least one heater located adjacent to the muffle; insulation located between the at least one heater and the outer shell; at least one particle feeder that feeds a predetermined volume of particles into the furnace above the primary reaction section; and an inlet port for injecting gas into the furnace, the inlet port being located so that the gas flows through the susceptor and muffle in parallel with the particles.

Green, Edward↗

A Novel Flash Ironmaking Process

The project goal is to develop an entirely new transformational process for alternate ironmaking based on the direct gaseous reduction of iron oxide concentrates in a flash reduction process, with the ultimate objective of significantly increasing energy productivity (by reducing energy consumption by up to 57 %) and reducing environmental emissions, especially CO 2 emissions, versus the conventional blast furnace ironmaking route.The Novel Flash Ironmaking Process uses gaseous reducing agents, such as natural gas, hydrogen, other syngas, or a combination thereof. The proposed technology is to be applied to the production of iron as a feed to the steelmaking process, eventually replacing the blast furnace and other alternate ironmaking processes. The process can also be a part of a continuous direct steelmaking process.

36 MATERIALS SCIENCE↗

High elongation achieved by band-like distribution of reinforcements in aluminum matrix composites

Highlights: • The high elongation of composites with high reinforcement content has been achieved by band-like distribution of ABO. • The band-like distribution of ABO could lead to more homogenous strain distribution by scattering the damages. • The cracks played a key role in the strain non-localization process, but have negligible contribution to the tensile strain. • A model of the relationship between the ductility enhancement and the band-like distribution of ABO was established. • The residual stresses induced by band-like distribution of ABO were theoretically calculated and experimentally measured. - Abstract: Ductile aluminum matrix composites reinforced by Al{sub 18}B{sub 4}O{sub 33} whisker (ABO) with band-like distribution (Band-like Aluminum Matrix Composites, BAMCs) were fabricated by powder metallurgy and extrusion followed by annealing. The cracks tend to nucleate in the ABO-rich bands, but the band-like structure induces compressive residual stress then suppresses the crack propagation and improves the strain transferring ability in the BAMCs. The denser and smaller cracks formed in the BAMCs with higher ABO volume fraction during tensile test. These cracks play an important role in the strain non-localization process, but have negligible contribution to the tensile strain.

36 MATERIALS SCIENCE↗

Suppression of CD36 attenuates adipogenesis with a reduction of P2X7 expression in 3T3-L1 cells

Adipogenesis is a process of differentiation from preadipocyte into adipocyte, and is regulated by several transcription factors, including the peroxisome proliferator-activated receptor gamma (PPARγ) and the CCAAT-enhancer-binding protein alpha (C/EBPα). CD36 is a membrane protein which contributes to the metabolic disorders such as obesity. Although the previous study demonstrated CD36 participated in the progression of adipogenesis, the mechanism is still unclear. We report here that knockdown of CD36 expression by CD36 small interfering RNA (siRNA) resulted in a reduction of adipocyte differentiation and adipogenic protein expression. In addition, purinergic receptor P2X, ligand-gated ion channel 7 (P2X7) was downregulated in CD36-knockdown 3T3-L1 cells, suggesting that the suppression of CD36 attenuates adipogenesis via the P2X7 pathway in 3T3-L1 cells. - Highlights: • CD36 regulated adipogenesis in 3T3-L1 cells. • Suppression of CD36 downregulated the expression of adipogenic gene. • P2X7 was downregulated in CD36-knockdown 3T3-L1 cells.

60 APPLIED LIFE SCIENCES↗