Engineering topics

Lewis, J. R.

Publications and source records attributed to Lewis, J. R..

9 records

NASA NTRS1985

Design overview of fiber-reinforced superalloy composites for the Space Shuttle main engine

This preliminary design study evaluated the potential of fiber-reinforced superalloys (FRS) for hot-section components of Space Shuttle Main Engine turbopumps. Emphasis was placed on uncooled turbine blades, with a more limited evaluation of FRS turbine stator vanes. The study included FRS properties evaluation, current structural design capability, and preliminary design and structural analysis. In addition, key technology needs were identified, and a plan was generated to develop operational hardware for advanced versions of the SSME. Based on projections of design properties for FRS composites comprising 50 volume percent of W-4Re-0.38Hf-0.02C wire filaments in a ductile superalloy matrix, it was concluded that FRS turbine blades offer the potential of significant improved operating life and higher temperature capability over the MAR-M-246(Hf) (DS) blades currently used in the SSME.

Lewis, J. R.↗

NASA NTRS1981

Position surveillance using one active ranging satellite and time-of-arrival of a signal from an independent satellite

A satellite-aided mobile communication service was tested for position surveillance, with an automatic responder circuit connected between the vehicle receiver and transmitter, and a receiver coded for signals from another satellite. Using the ATS-6 and GOES satellites, a tone-code ranging transponder was connected between the receiver and transmitter, and a 468 MHz receiver was connected to the responder unit for passive reception of the 100 bit per second timing and data signal. Results showed lines of position derived from the active ranging through ATS-6 to be accurate to approximately 0.1 nautical mile, while the NOAA-GOES signals were accurate to about 1.6 miles. The active ranging bandwidth was 2.44 kHz, and the integration time was 0.1 second, while the limitation on accuracy was the 100 Hz bandwidth. This technique of position surveillance was concluded to be feasible and simple to operate, providing needed, good quality communications to the inland waterways industry.

Anderson, R. E.↗

NASA NTRS1980

Satellite-aided mobile communications limited operational test in the trucking industry

An experiment with NASA's ATS-6 satellite, that demonstrates the practicality of satellite-aided land mobile communications is described. Satellite communications equipment for the experiment was designed so that it would be no more expensive, when mass produced, than conventional two-way mobile radio equipment. It embodied the operational features and convenience of present day mobile radios. Vehicle antennas 75 cm tall and 2 cm in diameter provided good commercial quality signals to and from trucks and jeeps. Operational applicability and usage data were gathered by installing the radio equipment in five long-haul tractor-trailer trucks and two Air Force search and rescue jeeps. Channel occupancy rates are reported. Air Force personnel found the satellite radio system extremely valuable in their search and rescue mission during maneuvers and actual rescue operations. Propagation data is subjectively analyzed and over 4 hours of random data is categorized and graded as to signal quality on a second by second basis. Trends in different topographic regions are reported. An overall communications reliability of 93% was observed despite low satellite elevation angles ranging from 9 to 24 degrees.

Anderson, R. E.↗

NASA NTRS1980

Position surveillance using one active ranging satellite and time-of-arrival of a signal from an independent satellite

Position surveillance using one active ranging/communication satellite and the time-of-arrival of signals from an independent satellite was shown to be feasible and practical. A towboat on the Mississippi River was equipped with a tone-code ranging transponder and a receiver tuned to the timing signals of the GOES satellite. A similar transponder was located at the office of the towing company. Tone-code ranging interrogations were transmitted from the General Electric Earth Station Laboratory through ATS-6 to the towboat and to the ground truth transponder office. Their automatic responses included digital transmissions of time-of-arrival measurements derived from the GOES signals. The Earth Station Laboratory determined ranges from the satellites to the towboat and computed position fixes. The ATS-6 lines-of-position were more precise than 0.1 NMi, 1 sigma, and the GOES lines-of-position were more precise than 1.6 NMi, 1 sigma. High quality voice communications were accomplished with the transponders using a nondirectional antenna on the towboat. The simple and effective surveillance technique merits further evaluation using operational maritime satellites.

Anderson, R. E.↗

NASA NTRS1980

Satellite-aided mobile communications, experiments, applications and prospects

NASA's ATS-series of satellites were used in a series of communications and position fixing experiments with automotive vehicles, ships and aircraft. Applications of the communications were demonstrated and evaluated for public services including law enforcement, search and rescue, and medical emergency, and for commercial uses in the land and maritime transportation industries. The technical success of the experiments and the demonstrated potential value of the communications prompted a study that concluded an operational satellite-aided system would be a valuable augmentation of planned trunking or cellular type terrestrial mobile radio telephone systems.

Anderson, R. E.↗

NASA NTRS1978

Technology of welding aluminum alloys-IV

Skate-weld carriage and track assembly were developed for controlled fusion welding on compound-curvature surfaces. Unlike fixed-position carriage used for vertical, horizontal, and circumferential welding, carriage has suspension system that permits angular positioning of weld head on carriage. It also has carriage-and-drive track mechanism capable of traveling over compound curvatures. Carriage is designed with universal mounting platform so that slim tools, weld heads, or X-ray units can be interchanged without need for realinement.

Ginez, R.↗

NASA NTRS1977

Automatic transponder

A method and apparatus for the automatic, remote measurement of the internal delay time of a transponder at the time of operation is provided. A small portion of the transmitted signal of the transponder is converted to the receive signal frequency of the transponder and supplied to the input of the transponder. The elapsed time between the receive signal locally generated and the receive signal causing the transmission of the transmitted signal is measured, said time being representative of or equal to the internal delay time of the transponder at the time of operation.

Anderson, R. E.↗

NASA NTRS1977

Experiments in data collection technology using satellites

A variety of techniques potentially useful to data collection have been tested. An automatic data collection platform with a minicomputer collects and preprocesses data, then sends desired information when interrogated through a communication satellite. Position surveillance by tone-code ranging through communication satellites is automatic, real time and accurate. Emergency medical data transmissions from ambulances to hospitals can be extended to rural and remote areas by direct satellite links. A small platform can send emergency-related data through a satellite while the satellite is routinely relaying powerful communication signals. A low orbit satellite provides means to locate existing emergency locator beacons.

Anderson, R. E.↗

NASA NTRS1972

Portable electron beam weld chamber

Development and characteristics of portable vacuum chamber for skate type electron beam welding are discussed. Construction and operational details of equipment are presented. Illustrations of equipment are provided.

Lewis, J. R.↗