Engineering topics

Levine, J. I.

Publications and source records attributed to Levine, J. I..

4 records

NASA NTRS1988

The Mark III VLBI System

Geodetic measurements have errors in centimeter range. Collection of three reports describes both equipment and results of some measurements taken with Mark III very-long-baseline interferometry (VLBI) system. Has demonstrated high accuracy over short baselines, where phase-delay measurements used. Advanced hardware, called Mark III A, developed to improve system performance and efficiency. Original Mark III hardware and III A subsystem upgrades developed as part of NASA Crustal Dynamics Project at Haystack Observatory.

Rogers, A. E. E.↗

NASA NTRS1983

Very-long-baseline radio interferometry - The Mark III system for geodesy, astrometry, and aperture synthesis

Up to 112 megabit/sec from each radio telescope of an interferometric array can be recorded and processed by the Mark III VLBI system. Sample results are given for baseline lengths between three antennas in the U.S. and three in Europe, as well as for the arc lengths between the positions of six extragalactic radio sources. No significant change is detected in any of these quantities. Signals of a given polarization or of pairs of orthogonal polarizations may be recorded in up to 28 contiguous bands, each nearly 2 MHz wide, for mapping the brightness distribution of compact radio sources. The demonstrated ability to record large bandwidths, and to link many large radio telescopes, allows compact sources with flux densities below 1 millijansky to be detected and studied.

Rogers, A. E. E.↗

NASA NTRS1980

Mark 3 real-time fringe detection system

A RAM memory built into the Mark 3 decoder module allows the capture of 1 Megabit of data. Data may be collected either in real time or from a pre-recorded tape. Once collected, the data may be retrieved using a standard EIA serial data link. The data may be transmitted to a remote computer for cross correlation processing with similar data from other stations to verify fringes in real time. The data may also be analyzed by a local computer to verify phase calibration, bandpass, format, etc., during a Mark 3 observing session.

Levine, J. I.↗

NASA NTRS1976

A very-long-baseline interferometer system for geodetic applications

A very-long-baseline interferometer system was designed and built for geodetic applications. Each interferometer terminal records a 360-kHz spectral band of noise from a compact extragalactic radio source. The center frequency of the spectral band can be selected to sample sequentially bands covering a much wider frequency range to obtain subnanosecond accuracy in group-delay measurements. A tunnel-diode pulse generator is used to calibrate the delays in the receiver. The necessary sets of algorithms and computer programs have been developed to analyze the data and have allowed the system to be employed to make accurate determinations of vector baselines, radio-source positions, polar motion, and universal time.

Whitney, A. R.↗