Engineering topics
Publications and source records attributed to Leonard, R..
A low-noise microwave receiver downconverter utilizing thin-film high-critical-temperature superconducting (HTS) passive circuitry and semiconductor active devices has been developed for use in space.
The proposed high temperature superconductivity (HTSC) millimeter-wave communications flight experiment from the payload bay of the Space Shuttle Orbiter to the Advanced Communications Technology Satellite (ACTS) in geosynchronous orbit is described. The experiment will use a Ka-band HTSC phased array antenna and front-end electronics to receive a downlink communications signal from the ACTS. The discussion covers the system configuration, a description of the ground equipment, the spacecraft receiver, link performance, thermal loading, and the superconducting antenna array.
Using the COMSTAR D/4 28.56 GHz beacon as a source, a differential gain experiment was performed by connecting a 5-meter paraboloidal antenna and a 0.6-meter paraboloidal antenna alternately to the same receiver. Substantial differential gain changes were observed during some, but not all, rain events. A site-diversity experiment was implemented which consists of two 28.56 GHz radiometers separated by 9 km. The look-angle corresponds to that of the D/4 beacon, and data were obtained with one radiometer during several weeks of concurrent beacon operation to verify the system calibration. A theoretical study of the effect of scattering from a nonuniform rain distribution along the path is under way to aid in interpreting the results of this experiment. An improved empirical site diversity-gain model was derived from data in the literature relating to 34 diversity experiments. Work on the experiment control and data acquisition system is continuing with a view toward future experiments.
Carbon composite materials are finding limited use in both civil and military aircraft structures to exploit their weight saving potential for improved performance or fuel efficiency. Since these needs are growing, and a manufacturing cost savings potential is also recognized, wider use of composites in the near future may be expected. Carbon composites generally involve fiber volume fractions in excess of 60 percent in a variety of orthotropic sandwich or solid laminates. Bidirectional woven carbon cloth, common in recently designed structure, may provide higher, more uniform laminate conductivities than tape.
A liquid cesium target has been developed which permits the production and identification of the neutron deficient isotopes of xenon. The thick target yields of Xe-127 and Xe-129 m were measured for proton energies between 28 and 40 MeV. Production of Xe-129 m, as indicated by the presence of a 196 keV line in the gamma ray spectra, occurred at all proton energies; Xe-127 was produced at proton energies above 33 MeV. Both accumulated on the target with the same time constant, and the cross sections were comparable in magnitude. The radioxenons were removed from the target by a stream of carrier gas so that chemical separation was unnecessary.
A liquid cesium target has been developed which allows the production and separate identification of the neutron deficient isotopes of xenon. The present report describes irradiations utilizing 34 to 41 MeV protons to produce millicurie quantities of Xe-127 and Xe-129m. At higher energies, however, the target could be used without modification to produce xenon isotopes as light as 119.
Alpha-gamma angular correlations for excitation of 1.452-MeV state of nickel-58