Engineering Papers⌕ Search

Engineering topics

Lee, Tien-Lin

Publications and source records attributed to Lee, Tien-Lin.

13 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

Local rare-earth dopant structure in a complex-oxide/semiconductor heterojunction: Molecular beam epitaxy grown Yb-doped SrTiO3 on Si(001)

We have investigated the structural and electronic properties of Yb-doped SrTiO3/Si(001) grown by molecular beam epitaxy. Other rare-earth donor dopants that result in n-type conductivity typically substitute for Sr at the A-sites in the perovskite lattice. In contrast, Yb has been found to substitute predominantly for Ti at the perovskite B-sites based on data from atomically resolved scanning transmission electron microscopy and spectroscopy, as well as extended x-ray absorption fine structure. Yb exhibits two distinct charge states as determined by x-ray absorption spectroscopy and associated modeling, +2.7 and +2.1. These aliovalent substitutional dopants are compensated by donor electrons from oxygen vacancies that form during epitaxial film growth. An atom beam flux mismatch was present during film depositions because it was assumed that Yb would occupy A-sites, leading to a flux matching formula given by Yb + Sr = Ti. However, the formation of YbTi rather than YbSr results in Sr vacancies and extraneous (i.e. non-lattice) Ti atoms in the films, or on the film surfaces. The presence of these defects, together with oxygen vacancies, leads to deep-level electron traps that were detected by resonant photoemission and much higher sheet resistance than that associated with, for instance, La-doped films.

Chambers, Scott A. (ORCID:000000025415043X)↗
DOE OSTI2024

First-Principles Treatment of Vibrational Broadening in X-Ray Excited Valence Band Spectra for n-SrTiO 3 (001)

The valence band maximum (VBM) is an important quantity for semiconductors as it locates the Fermi level relative to the band edge. Accurate measurement of this quantity in near-surface regions of semiconductors by photoemission is a first step toward determining the electronic properties of heterostructures involving these materials. While extrapolating the leading edge of the valence band to the energy axis in photoemission spectra is a widely used way to find the VBM, this method can be ambiguous if the leading edge exhibits multiple slopes. Another way to determine the VBM is to fit the leading edge to an appropriately broadened, cross-section modulated theoretical density of states (DOS). Three kinds of broadening that should be included for maximum accuracy are those due to: (1) finite instrumental resolution, (2) valence hole lifetime, and (3) vibrational excitations. While steps (1) and (2) are straightforward to implement, (3) is more difficult because the appropriate amount of broadening is not known a priori. Here, we demonstrate that explicit inclusion of vibrational broadening using ab initio molecular dynamics facilitates accurate VBM determination for n-SrTiO 3 (001). The total DOS is constructed by summing time-averaged projections at elevated temperature onto s - , p - , and d orbitals for the constituent atoms and modulating with the associated photoemission cross sections. Subsequent convolutions of the total DOS, first with a Gaussian of width equal to the experimental energy resolution and second with a Lorentzian to simulate valence hole lifetime effects, yield line shapes that reproduce the experimental leading edges rather well. The VBM is then given by the energy at which the vibrationally broadened total DOS (prior to the convolutions) goes to zero. The VBMs generated by this method quantitatively agree with those resulting from extrapolating from the middle of the measured leading edge for SrTiO 3 .

36 MATERIALS SCIENCE↗
DOE OSTI2024

Achieving environmental stability in an atomically thin quantum spin Hall insulator via graphene intercalation

Atomic monolayers on semiconductor surfaces represent an emerging class of functional quantum materials in the two-dimensional limit — ranging from superconductors and Mott insulators to ferroelectrics and quantum spin Hall insulators. Indenene, a triangular monolayer of indium with a gap of ~ 120 meV is a quantum spin Hall insulator whose micron-scale epitaxial growth on SiC(0001) makes it technologically relevant. However, its suitability for room-temperature spintronics is challenged by the instability of its topological character in air. It is imperative to develop a strategy to protect the topological nature of indenene during ex situ processing and device fabrication. Here we show that intercalation of indenene into epitaxial graphene provides effective protection from the oxidising environment, while preserving an intact topological character. Our approach opens a rich realm of ex situ experimental opportunities, priming monolayer quantum spin Hall insulators for realistic device fabrication and access to topologically protected edge channels.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Surface termination control of charge transfer and band alignment across a semiconductor–crystalline-oxide heterojunction

Charge redistribution across heterojunctions has long been utilized to induce functional response in materials systems. Here we examine how the composition of the terminating surface affects charge transfer across a heterojunction consisting of Si and the crystalline complex oxide SrTiO 3 . Itinerant electrons in Si migrate across the interface toward the surface of SrTiO 3 due to surface depletion. The electron transfer in turn creates an electric field across the interface that modifies the interfacial dipole associated with bonding between SrTiO 3 and Si. The modification in the dipole leads to a change in band alignment, in which the conduction band of SrTiO 3 moves from being above the valence band of Si in energy, to below it. By capping the SrTiO 3 surface with ultrathin (≤ 1 nm) layers of BaO, SrO or TiO 2 , charge transfer across the interface can be weakened or inhibited. Ab initio modeling implicates the adsorption of oxygen associated with exposure to ambient conditions as driving the surface depletion in SrTiO 3 . In conclusion, the electronic coupling between the surface and buried interface expands the functionality of semiconductor-crystalline oxide heterojunctions.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Emergent and robust ferromagnetic-insulating state in highly strained ferroelastic LaCoO 3 thin films

Transition metal oxides are promising candidates for the next generation of spintronic devices due to their fascinating properties that can be effectively engineered by strain, defects, and microstructure. An excellent example can be found in ferroelastic LaCoO 3 with paramagnetism in bulk. In contrast, unexpected ferromagnetism is observed in tensile-strained LaCoO 3 films, however, its origin remains controversial. Here we simultaneously reveal the formation of ordered oxygen vacancies and previously unreported long-range suppression of CoO 6 octahedral rotations throughout LaCoO 3 films. Supported by density functional theory calculations, we find that the strong modification of Co 3d-O 2p hybridization associated with the increase of both Co-O-Co bond angle and Co-O bond length weakens the crystal-field splitting and facilitates an ordered high-spin state of Co ions, inducing an emergent ferromagnetic-insulating state. Our work provides unique insights into underlying mechanisms driving the ferromagnetic-insulating state in tensile-strained ferroelastic LaCoO 3 films while suggesting potential applications toward low-power spintronic devices.

36 MATERIALS SCIENCE↗
DOE OSTI2022

P-type conductivity in Sn-doped Sb 2 Se 3

Abstract Antimony selenide (Sb 2 Se 3 ) is a promising absorber material for thin-film photovoltaics. However, certain areas of fundamental understanding of this material remain incomplete and this presents a barrier to further efficiency gains. In particular, recent studies have highlighted the role of majority carrier type and extrinsic doping in drastically changing the performance of high efficiency devices (Hobson et al 2020 Chem. Mater. 32 2621–30). Herein, Sn-doped Sb 2 Se 3 bulk crystals are shown to exhibit p-type conductivity using Hall effect and hot-probe measurements. The measured conductivities are higher than those achieved through native defects alone, but with a carrier density (up to 7.4 × 10 14 cm −3 ) several orders of magnitude smaller than the quantity of Sn included in the source material. Additionally, a combination of ultraviolet, x-ray and hard x-ray photoemission spectroscopies are employed to obtain a non-destructive depth profile of the valence band maximum, confirming p-type conductivity and indicating a majority carrier type inversion layer at the surface. Finally, these results are supported by density functional theory calculations of the defect formation energies in Sn-doped Sb 2 Se 3 , showing a possible limit on the carrier concentration achievable with Sn as a dopant. This study sheds light on the effectiveness of Sn as a p-type dopant in Sb 2 Se 3 and highlights avenues for further optimisation of doped Sb 2 Se 3 for solar energy devices.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Probing electronic dead layers in homoepitaxial n-SrTiO 3 (001) films

We combine state-of-the-art oxide epitaxial growth by hybrid molecular beam epitaxy with transport, x-ray photoemission, and surface diffraction, along with classical and first-principles quantum mechanical modeling to investigate the nuances of insulating layer formation in otherwise high-mobility homoepitaxial n-SrTiO 3 (001) films. Our analysis points to charge immobilization at the buried n-SrTiO 3 /undoped SrTiO 3 (001) interface as well as within the surface contamination layer resulting from air exposure as the drivers of electronic dead-layer formation. As Fermi level equilibration occurs at the surface and the buried interface, charge trapping reduces the sheet carrier density (n 2D ) and renders the n-STO film insulating if n 2D falls below the critical value for the metal-to-insulator transition.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Boron nitride on SiC(0001)

Here, in the field of van der Waals heterostructures, the twist angle between stacked two-dimensional layers has been identified to be of utmost importance for the properties of the heterostructures. In this context, we previously reported the growth of a single layer of unconventionally oriented epitaxial graphene that forms in a surfactant atmosphere [F. C. Bocquet et al., Phys. Rev. Lett. 125, 106102 (2020)]. The resulting G-R0° layer is aligned with the SiC lattice, and hence represents an important milestone towards high-quality twisted bilayer graphene, a frequently investigated model system in this field. Here, we focus on the surface structures obtained in the same surfactant atmosphere, but at lower preparation temperatures at which a boron nitride template layer forms on SiC(0001). In a comprehensive study based on complementary experimental and theoretical techniques, we find—in contrast to the literature—that this template layer is a hexagonal B x N y layer, but not high-quality hBN. It is aligned with the SiC lattice and gradually replaced by low-quality graphene in the 0° orientation of the B x N y template layer upon annealing.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Epitaxial SrTiO 3 films with dielectric constants exceeding 25,000

Significance Semiconductor interfaces are among the most important in use in modern technology. The properties they exhibit can either enable or disable the characteristics of the materials they connect for functional performance. While much is known about important junctions involving conventional semiconductors such as Si and GaAs, there are several unsolved mysteries surrounding interfaces between oxide semiconductors. Here we resolve a long-standing issue concerning the measurement of anomalously low dielectric constants in SrTiO 3 films with record high electron mobilities. We show that the junction between doped and undoped SrTiO 3 required to make dielectric constant measurements masks the dielectric properties of the undoped film. Through modeling, we extract the latter and show that it is much higher than previously measured.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Manipulating the metal-to-insulator transition and magnetic properties in manganite thin films via epitaxial strain

Strain engineering of epitaxial transition metal oxide heterostructures offers an intriguing opportunity to control electronic structures by modifying the interplay between spin, charge, orbital, and lattice degrees of freedom. Here, we demonstrate that the electronic structure, magnetic and transport properties of La 0.9 Ba 0.1 MnO 3 thin films can be effectively controlled by epitaxial strain. Spectroscopic studies and first-principles calculations reveal that the orbital occupancy in Mn eg orbitals can be switched from the d 3z 2 -r 2 orbital to the d x 2 -y 2 orbital by varying the strain from compressive to tensile. Further, the change of orbital occupancy associated with Mn 3d-O 2p hybridization leads to dramatic modulation of the magnetic and electronic properties of strained La 0.9 Ba 0.1 MnO 3 thin films. Under moderate tensile strain, an emergent ferromagnetic insulating state with an enhanced ferromagnetic Curie temperature of 215 K is achieved. These findings not only deepen our understanding of electronic structures, magnetic and transport properties in the La 0.9 Ba 0.1 MnO 3 system, but also demonstrate the use of epitaxial strain as an effective knob to tune the electronic structures and related physical properties for potential spintronic device applications.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2022

Mapping hidden space-charge distributions across crystalline metal oxide/group IV semiconductor interfaces

The electronic structures of semiconducting heterojunctions are critically dependent on composition including the presence and concentrations of dopants, both intended and unintended. Dopant profiles in the interfacial region can have major effects on band energies which in turn drive transport properties. Here, in this study, we use core-level photoelectron line shapes excited with hard x rays to extract information about electric fields resulting from internal charge transfer in epitaxial La 0.03 Sr 0.97 Zr x Ti 1–x O 3 /Ge(001) (0.1≤x≤0.7) heterostructures. Experiments were carried out for heterojunctions involving both n- and p-type Ge substrates. These heterojunctions were not amenable to electronic characterization of all regions by transport measurements because the doped substrates act as electrical shunts, precluding probing the more resistive films and masking interface conductivity. However, the core-level line shapes were found to be a rich source of information on built-in potentials that exist throughout the heterostructure, and yielded valuable insight into the impact of band bending on band alignment at the buried interfaces. The electronic effects expected for Ge with uniform n- and p-type doping are eclipsed by those of unintended oxygen dopants in the Ge near the interface. This study illustrates the power of hard x-ray photoemission spectroscopy and related modeling to determine electronic structure in material systems for which insight from traditional transport measurements is limited.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Atomic-Scale Structure of Chemically Distinct Surface Oxygens in Redox Reactions

During redox reactions, oxide-supported catalytic systems undergo structural and chemical changes. Improving subsequent catalytic properties requires an understanding of the atomic-scale structure with chemical state specificity under reaction conditions. For the case of 1/2 monolayer vanadia on α-TiO 2 (110), we use X-ray standing wave (XSW) excited X-ray photoelectron spectroscopy to follow the redox induced atomic positional and chemical state changes of this interface. Furthermore, while the resulting XSW 3D composite atomic maps include the Ti and O substrate atoms and V surface atoms, our focus in this report is on the previously unseen surface oxygen species with comparison to density functional theory predictions.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗