Engineering topics

Lee, S. W.

Publications and source records attributed to Lee, S. W..

At least 37 records · Page 2

NASA NTRS1991

Properties of dust and clouds in the Mars atmosphere: Analysis of Viking IRTM emission phase function sequences

An analysis of emission-phase-function (EPF) observations from the Viking Orbiter Infrared Thermal Mapper (IRTM) yields a wide variety of results regarding dust and cloud scattering in the Mars atmosphere and atmospheric-corrected albedos for the surface of Mars. A multiple scattering radiative transfer model incorporating a bidirectional phase function for the surface and atmospheric scattering by dust and clouds is used to derive surface albedos and dust and ice optical properties and optical depths for these various conditions on Mars.

Clancy, R. T.↗

NASA NTRS1991

Recent studies of the optical properties of dust and cloud particles in the Mars atmosphere and the interannual frequency of global dust storms

The results of research with two distinctly separate sets of observations yield new information on the optical properties of particulate scatterers in the Mars atmosphere, and on the interannual variability of the abundance of such scatterers in the Mars atmosphere. The first set of observations were taken by the IRTM (Infrared Thermal Mapper) instrument onboard the Viking Orbiters, during the period 1976 to 1980. Several hundred emission phase function (EPF) sequences were obtained over the Viking mission, in which the IRTM visual brightness channel observed the same area of surface/atmosphere as the spacecraft passed overhead. The 1 to 2 percent accuracy of calibration and the phase-angle coverage that characterizes these data make them ideally suited to determining both the optical depths and optical properties of dust and cloud scatterers in the Mars atmosphere versus latitude, longitude, seasons (L sub s), and surface elevation over the extended period of Viking observations. The EPF data were analyzed with a multiple scattering radiative transfer code to determine dust single scattering albedos which are distinctly higher than indicated by the Viking Lander observations. The second set of observations regard ground-based observations of the 1.3 to 2.6 mm rotational transitions of CO in the Martian atmosphere. The low-to-mid latitude average of the atmospheric temperature profile (0 to 70 km altitude) were derived from a number of such observations over the 1980 to 1990 period.

Clancy, R. T.↗

NASA NTRS1991

The effects of atmospheric dust on observations of Martian surface albedo

The Mariner 9 and Viking missions provided abundant evidence that aeolian processes are active over much of surface of Mars. A radiative transfer model was developed which allows the effects of atmospheric dust loading and variable surface albedo to be investigated. This model incorporated atmospheric dust opacity, the single scattering albedo, and particle phase function of atmospheric dust, the bidirectional; reflectance of the surface, and variable lighting and viewing geometry. The Cerberus albedo feature was examined in detail using this technique.

Lee, S. W.↗

NASA NTRS1989

A comparison of reflector antenna designs for wide-angle scanning

Conventional reflector antennas are typically designed for up to + or - 20 beamwidths scan. An attempt was made to stretch this scan range to some + or - 300 beamwidths. Six single and dual reflector antennas were compared. It is found that a symmetrical parabolic reflector with f/D = 2 and a single circular waveguide feed has the minimum scan loss (only 0.6 dB at Theta sub 0 = 8 deg, or a 114 beamwidths scan). The scan is achieved by tilting the parabolic reflector by an angle equal to the half-scan angle. The f/D may be shortened if a cluster 7 to 19 elements instead of one element is used for the feed. The cluster excitation is adjusted for each new beam scan direction to compensate for the imperfect field distribution over the reflector aperture. The antenna can be folded into a Cassegrain configuration except that, due to spillover and blockage considerations, the amount of folding achievable is small.

Zimmerman, M.↗

NASA NTRS1989

A segmented mirror antenna for radiometers

An antenna is designed for the radiometer application of the planned NASA Earth Science Geostationary Platforms in the 1990's. The antenna consists of two parts: a regular parabolic dish of 5 meters in diameter which converts the radiation from feeds into a collimated beam, and a movable mirror that redirects the beam to a prescribed scan direction. The mirror is composed of 28 segmented planar conducting plates, mostly one square meter in size. The secondary pattern of the antenna was analyzed based on a physical optics analysis. For frequencies between 50 and 230 GHz, and for a scan range of + or -8 deg (270 beamwidths scan at 230 GHz), the worst calculated beam efficiency is 95 percent. To cover such a wide frequency and scan range, each of the 28 plates is individually controlled for a tilting less than 4 deg, and for a sliding less than 0.5 cm. The sliding is done at discrete steps. At 230 GHz, a step size of 2 mil is sufficient. The plate positions must be reset for each frequency and for each scan direction. Once the position is set, the frequency bandwidth of the antenna is very narrow.

Lee, S. W.↗

NASA NTRS1989

A comparison of reflector antenna designs for wide-angle scanning

Zimmerman, M.↗

NASA NTRS1989

On physical optics for calculating scattering from coated bodies

The familiar physical optics (PO) approximation is no longer valid when the perfectly conducting scatterer is coated with dielectric material. This paper reviews several possible PO formulations. By comparing the PO formulation with the moment method solution based on the impedance boundary condition for the case of the coated cone-sphere, a PO formulation using both electric and magnetic currents consistently gives the best numerical results. Comparisons of the exact moment method with the PO formulations using the impedance boundary condition and the PO formulation using the Fresnel reflection coefficient for the case of scattering from the cone-ellipsoid demonstrate that the Fresnel reflection coefficient gives the best numerical results in general.

Baldauf, J.↗

NASA NTRS1988

A Method for Producing a Shaped Contour Radiation Pattern Using a Single Shaped Reflector and a Single Feed

Eliminating the corporate feed network in shaped contour beam antennas will reduce the expense, weight, and RF loss of the antenna system. One way of producing a shaped contour beam without using a feed network is to use a single shaped reflector with a single feed element. For a prescribed contour beam and feed, an optimization method for designing the reflector shape is given. As a design example, a shaped reflector is designed to produce a continental U.S. coverage (CONUS) beam. The RF performance of the shaped reflector is then verified by physical optics.

Cherrette, A. R.↗

NASA NTRS1988

Ray-tube integration in shooting and bouncing ray method

Based on three formulations of the Huygen's principle, explicit expressions is given for the far field contribution from a small ray tube. This expression is useful in shooting and bouncing rays for solving complex scattering problems.

Lee, S. W.↗

NASA NTRS1988

Compensation of relector antenna surface distortion using an array feed

The dimensional stability of the surface of a large reflector antenna is important when high gain or low sidelobe performance is desired. If the surface is distorted due to thermal or structural reasons, antenna performance can be improved through the use of an array feed. The design of the array feed and its relation to the surface distortion are examined. The sensitivity of antenna performance to changing surface parameters for fixed feed array geometries is also studied. This allows determination of the limits of usefulness for feed array compensation.

Cherrette, A. R.↗

NASA NTRS1988

Case study of active array feed compensation with sidelobe control for reflector surface distortion

The feasibility of electromagnetically compensating for reflector surface distortions has been investigated. The performance characteristics (gain, sidelobe levels, etc.) of large communication antenna systems degrade as the reflector surface distorts mainly due to thermal effects from a varying solar flux. The techniques described in this report can be used to maintain the design performance characteristics independently of thermal effects on the reflector surface. With the advent of monolithic microwave integrated circuits (MMIC), a greater flexibility in array-fed reflector system design can be achieved. MMIC arrays provide independent control of amplitude and phase for each of many radiating elements of the feed array. It is assumed that the surface characteristics (x,y,z, its first and second derivatives) under distorted conditions are known.

Acosta, R. J.↗

NASA NTRS1987

Reduction of the radar cross section of arbitrarily shaped cavity structures

The problem of the reduction of the radar cross section (RCS) of open-ended cavities was studied. The issues investigated were reduction through lossy coating materials on the inner cavity wall and reduction through shaping of the cavity. A method was presented to calculate the RCS of any arbitrarily shaped structure in order to study the shaping problem. The limitations of this method were also addressed. The modal attenuation was studied in a multilayered coated waveguide. It was shown that by employing two layers of coating, it was possible to achieve an increase in both the magnitude of attenuation and the frequency band of effectiveness. The numerical method used in finding the roots of the characteristic equation breaks down when the coating thickness is very lossy and large in terms of wavelength. A new method of computing the RCS of an arbitrary cavity was applied to study the effects of longitudinal bending on RCS reduction. The ray and modal descriptions for the fields in a parallel plate waveguide were compared. To extend the range of validity of the Shooting and Bouncing Ray (SBR) method, the simple ray picture must be modified to account for the beam blurring.

Chou, R.↗

NASA NTRS1987

Observations of industrial sulfur flows and implications for Io

The possibility of sulfur flows on the Jovian satellite Io is discussed. Although the primary problem is lack of sufficient information to resolve the issue, interpretations of existing data are hampered by poor knowledge of the thermal properties and rheologic behavior of sulfur flows, especially under conditions present on Io. Relatively few natural sulfur flows occur on Earth and only one has been seen in active flow. However, recent observations of industrial sulfur flows, which are much larger than those produced experimentally, may provide important information concerning natural sulfur flows on both Earth and Io.

Lee, S. W.↗

NASA NTRS1987

Radar cross section of an open-ended circular waveguide Calculation of second-order diffraction terms

The radar cross section of an open-ended, semi-infinite circular waveguide is calculated by the geometrical theory of diffraction and the equivalent-current (EC) method. Both single- and double-diffraction terms are included. It is found that the double-diffraction term is stronger than the single-diffraction term for the horizontal polarization at wide-angle incidence. Its inclusion is necessary in order to check with experimental data and the asymptotic expansion of the exact Wiener-Hopf solution. The EC method is used for the single diffraction. On the other hand the double-diffraction term is obtained by using the EC method for axial incidence and geometrical theory of diffraction for wide-angle incidence. These two solutions are matched with a proper matching function. This technique is computationally more efficient than the matching technique of integration over the equivalent currents.

Lee, C. S.↗

NASA NTRS1986

Phobos, Deimos, and the moon - Size and distribution of crater ejecta blocks

Ejecta block characteristics observed on Phobos, Deimos, and the moon are examined. The analyzed source craters on Deimos are 0.8-2.3 km in diameter, those on Phobos are 1.5-10 km, and the lunar craters are between 0.2-3.5 km in diameter. The size and radial distribution of the ejecta blocks for the three bodies are compared. It is observed that the size distribution of the ejecta blocks surrounding craters on the three objects are basically similar, and the radial distribution of the blocks for Phobos and the moon are the same (within 2 radii of the crater center); however, the ejecta on Deimos are more dispersed (greater than or equal to 2 radii from the crater center).

Lee, S. W.↗

NASA NTRS1986

Near-field spillover from a subreflector: Theory and experiment

In a dual reflector antenna, the spillover from the subreflector is important in determining the accuracy of near-field measurements. This is especially so when some of the feed elements are placed far away from the focus. In this paper, we present a high-frequency GTD analysis of the spillover field over a plane just behind the subreflector. Special attention is given to the field near the incident shadow boundary and the role played by the slope diffraction term. Our computations are in excellent agreement with experimental results.

Lee, S. W.↗

NASA NTRS1986

A simple circular-polarized antenna: Circular waveguide horn coated with lossy magnetic material

A circular waveguide horn coated with a lossy material in its interior wall can be used as an alternative to a corrugated waveguide for radiating a circularly polarized (CP) field. To achieve good CP radiation, the diameter of the structure must be larger than the free-space wavelength, and the coating material must be sufficiently lossy and magnetic. This device is cheaper and lighter in weight than the corrugated one.

Lee, C. S.↗

NASA NTRS1986

Calculating Directivities of Planar-Array Antenna Feeds

Design of planar-array antennas and antenna feeds aided by new approach to calculation of array directivity. Technique takes into account polarizations, asymmetries in element patterns, nonuniform element spacings, and arbitrary excitations. Gives numerical results faster than previous integration methods, and results agree with those obtained by older methods.

Rahmat-Samii, Y.↗