Engineering PapersSearch

Engineering topics

Lee, P.

Publications and source records attributed to Lee, P..

50 records · Page 3

RF optics study for DSS-43 ultracone implementation

The Ultracone feed system will be implemented on DSS 43 to support the S-band (2.3 GHz) Galileo contingency mission. The feed system will be installed in the host country's cone, which is normally used for radio astronomy, VLBI, and holography. The design must retain existing radio-astronomy capabilities, which could be impaired by shadowing from the large S-band feed horn. Computer calculations were completed to estimate system performance and shadowing effects for various configurations of the host country's cone feed systems. Also, the DSS-43 system performance using higher gain S-band horns was analyzed. A new S-band horn design with improved return loss and cross-polarization characteristics is presented.

Lee, P.

Photometric diversity of terrains on Triton

Voyager disk-resolved images of Triton in the violet (0.41 micrometers) and green (0.56 micrometer wavelengths have been analyzed to derive the photometric characteristics of terrains on Triton. Similar conclusions are found using two distinct but related definitions of photometric units, one based on color ratio and albedo properties (A. S. McEwen, 1990), the other on albedo and brightness ratios at different phase angles (P. Lee et al., 1992). A significant diversity of photometric behavior, much broader than that discovered so far on any other icy satellite, occurs among Triton's terrains. Remarkably, differences in photometric behavior do not correlate well with geologic terrain boundaries defined on the basis of surface morphology. This suggests that in most cases photometric properties on Triton are controlled by thin deposits superposed on underlying geologic units. Single scattering albedos are 0.98 or higher and asymmetry factors range from -0.35 to -0.45 for most units. The most distinct scattering behavior is exhibited by the reddish northern units already identified as the Anomalously Scattering Region (ASR), which scatters light almost isotropically with g = -0.04. In part due to the effects of Triton's clouds and haze, it is difficult to constrain the value of bar-theta, Hapke's macroscopic roughness parameter, precisely for Triton or to map differences in bar-theta among the different photometric terrains. However, our study shows that Triton must be relatively smooth, with bar-theta less than 15-20 degs and suggests that a value of 14 degs is appropriate. The differences in photometric characteristics lead to significantly different phase angle behavior for the various terrains. For example, a terrain (e.g., the ASR) that appears dark relative to another at low phase angles will reverse its contrast (become relatively brighter) at larger phase angles. The photometric parameters have been used to calculate hemispherical albedos for the units and to infer likely surface temperatures. Based on these results, we determine that all but the most southerly regions (i.e., mostly south of the equator) of the reddish northern terrains are likely to have been covered with deposits of nitrogen frost at the time of the Voyager flyby, in agreement with the suggestion from the photometry that these units are overlain by a thin veneer of material.

Hillier, J.

Briny lakes on early Mars? Terrestrial intracrater playas and Martian candidates

Recently, salt-rich aqueous solutions have been invoked in the preterrestrial alteration of the Nakhla and Lafayette SNC meteorites. The findings substantiate the long-standing suspicion that salts are abundant on Mars and, more importantly, that brines have played a significant role in Martian hydrogeological history. Adding to the growing body of evidence, I report here on the identification of several unusual intracrater high-albedo features in the ancient cratered highlands of Mars, which I interpret as possible saline playas, or salt pans.

Lee, P.

Effects Of Exercise During Prolonged Bed Rest

Report describes experiment to investigate effects of isotonic and isokinetic leg exercises in counteracting effects of bed rest upon physical and mental conditions of subjects. Data taken on capacity for work, endurance and strength, tolerance to sitting up, equilibrium, posture, gait, atrophy, mineralization and density of bones, endocrine analyses concerning vasoactivity and fluid and electrolyte balances, intermediary metabolism of muscles, mood, and performance.

Arnaud, S.

Report on the international Cambodian crater expedition, 1992

It has been proposed that Tonle Sap, a lake in Cambodia, 100 km long and 30 km wide, marks the location of an elongate basin formed by the oblique impact of a comet or asteroid. The impact is considered to have produced melted ejecta found now as tektites over much of southeast Asia and Australia. The location of the lake, its approximate age, its size, and the orientation of its long axis (toward Australia) are consistent with this hypothesis. Our scientific objectives were to find impact or shock metamorphosed rocks unambiguously related to the Tonle Sap basin, to collect samples of rocks that may represent those melted to produce Australasian tektites, and to learn as much as possible about Cambodian geology. Using 1:200,000-scale geologic maps with fairly detailed descriptions of the rock units, we selected a number of acceptable 'phnoms' (hills that rise abruptly out of the surrounding plain) that may contain rocks affected by the postulated Tonle Sap impact. A map of central Cambodia is shown, and the locations of sites where samples were collected are indicated. A list of those sites, together with a description of the rocks reported to be present at each site, is given. No obviously shock-metamorphosed or suevite-like rocks were observed. Recent alluvium surrounding Tonle Sap is judged to be lake sediment deposited when the lake surface was at a higher elevation.

Hartung, J.

Wideband waveguide polarizer development for SETI

A wideband polarizer for the Deep Space Network (DSN) 34 meter beam waveguide antenna is needed for the Search for Extraterrestrial Intelligence (SETI) project. The results of a computer analysis of a wideband polarizer are presented.

Lee, P.

Thermophysical property measurements in electromagnetic levitators

Proper measurements of thermophysical properties of hot levitated liquid drops require the following: accurate temperature measurement (brightness measurement, emissivity measurement); precise drop shape measurements with submillisecond time resolution (density determination, rotational and vibrational shape information); precise control of drop shape (high symmetry variable gap levitators); accurate energy transfer measurements (direct measurements of energy transfer rates for defined gas flows over samples with quantitative measurements of energy transfer rates for defined flows over samples with known shapes); and precise measurements of repetitive sample motions (rapid repetitive shape measurements, frequency measurements with reflected laser light, measurements in the levitator and as a freely falling drop). Recent advances in coil design and control of sample rotation in an electromagnetic levitator are discussed with respect to the above requirements.

Hauge, Robert H.

Time-resolved measurements of nonthermal X-ray emission of Ti XXI lines in electron-cyclotron-heated tokamak plasmas

The observation of heliumlike titanium spectra with 20 ms temporal resolution during high-power injection of electron cyclotron heating (ECH) of up to 250 ms pulse length into the Doublet III tokamak is reported. The prominent lines in the spectra and the observed dielectronic satellite lines from the autoionizing lithiumlike ionization states are given. The intensity of the resonance line 1s2 1S0 - 1s 2p 1P1 is found to be extremely sensitive to the ECH power. Time-resolved line ratios are also presented. It is concluded that a significant departure from a Maxwellian distribution of electrons exists in the present ECH plasmas.

Lee, P.

Strength Modeling Report

Strength modeling is a complex and multi-dimensional issue. There are numerous parameters to the problem of characterizing human strength, most notably: (1) position and orientation of body joints; (2) isometric versus dynamic strength; (3) effector force versus joint torque; (4) instantaneous versus steady force; (5) active force versus reactive force; (6) presence or absence of gravity; (7) body somatotype and composition; (8) body (segment) masses; (9) muscle group envolvement; (10) muscle size; (11) fatigue; and (12) practice (training) or familiarity. In surveying the available literature on strength measurement and modeling an attempt was made to examine as many of these parameters as possible. The conclusions reached at this point toward the feasibility of implementing computationally reasonable human strength models. The assessment of accuracy of any model against a specific individual, however, will probably not be possible on any realistic scale. Taken statistically, strength modeling may be an effective tool for general questions of task feasibility and strength requirements.

Badler, N. I.

Greenhouse effect of trace gases, 1970-1980

Increased abundances were measured for several trace atmospheric gases in the decade 1970-1980. The equilibrium greenhouse warming for the measured increments of CH4, chlorofluorocarbons and N2O is between 50% and 100% of the equilibrium warming for the measured increase of atmospheric CO2 during the same 10 years. The combined warming of CO2 and trace gases should exceed natural global temperature variability in the 1980's and cause the global mean temperature to rise above the maximum of the late 1930's.

Lacis, A.

Optimum design of hybrid phase locked loops

The design procedure of phase locked loops is described in which the analog loop filter is replaced by a digital computer. Specific design curves are given for the step and ramp input changes in phase. It is shown that the designed digital filter depends explicitly on the product of the sampling time and the noise bandwidth of the phase locked loop. This technique of optimization can be applied to the design of digital analog loops for other applications.

Lee, P.

Climatic effects of atmospheric aerosols

It is shown quantitatively how radiative climatic forcing by aerosols depends on the physical properties of the aerosols. The special case of atmospheric aerosols produced by volcanic explosions is considered, and evidence is presented which indicates that even the simple climate models available today may be able to capture some of the basic effects of aerosols on global climate. Possible effects of anthropogenic aerosols are briefly examined. It is noted that additional evidence for the significant influence of aerosols on climate may be found in data obtained from recent spacecraft missions to Venus and Mars.

Hansen, J. E.

Nonreciprocal gain control for ring laser

Nonreciprocal gain control is used in a ring laser where the two contracirculating beams may have differing intensities because of the residual Faraday rotation and other secondary nonreciprocal effects.

Dueker, G.