Engineering Papers⌕ Search

Engineering topics

Lee, Joseph W.

Publications and source records attributed to Lee, Joseph W..

25 records · Page 2

Investigation of Measurement Errors in Doppler Global Velocimetry

While the initial development phase of Doppler Global Velocimetry (DGV) has been successfully completed, there remains a critical next phase to be conducted, namely the determination of an error budget to provide quantitative bounds for measurements obtained by this technology. This paper describes a laboratory investigation that consisted of a detailed interrogation of potential error sources to determine their contribution to the overall DGV error budget. A few sources of error were obvious; e.g., iodine vapor adsorption lines, optical systems, and camera characteristics. However, additional non-obvious sources were also discovered; e.g., laser frequency and single-frequency stability, media scattering characteristics, and interference fringes. This paper describes each identified error source, its effect on the overall error budget, and where possible, corrective procedures to reduce or eliminate its effect.

Meyers, James F.↗

Doppler global velocimetry measurements of the vortical flow above an F/A-18

A Doppler global velocimeter is employed to study the vortical flow above an F/A-18 at 25 degree angle of attack. The measurements indicate that the flow possessed the same characteristics as the vortical flow above a standard delta wing. Image to image comparisons clearly indicate that the flow striking the vertical stabilizers is not chaotic.

Lee, Joseph W.↗

Investigation of the Vortical Flow Above an F/A-18 Using Doppler Global Velocimetry

The flow above an F/A-18 model, set to 25-degrees angle of attack, was measured using a Doppler global velocimeter, (DGV). The investigation indicated that the complex flow contained many similarities to the vortical flow above a simple delta wing set to a high-angle of attack, including flow standard deviations greater than 30-percent of free- stream. These standard deviation levels were also comparable to results found during a previous investigation of the vortical flow above a YF-17 using fringe-type laser velocimetry. The global measurement capability of the DGV provided the first evidence that the burst vortices above the model were structured. These structures were found to maintain their spatial coherence while the flow varied in an overall sense.

Meyers, James F.↗

Doppler Global Velocimetry Measurements of the Vortical Flow Above an F/A-18

A Doppler global velocimeter was used to investigate the vortical flow above an F/A-18 model at 25-degrees angle of attack. The measurements indicate that the flow had the same characteristics as the vortical flow above a standard delta wing. The flow pattern indicating transition from stable to burst conditions found above the delta wing was also found at the 440 station above the F/A-18. Measurements downstream at the 524 station found that the flow velocity varied considerably, with standard deviations reaching 30 percent of free stream. However, individual data images indicated that the flow was spatially coherent, and not chaotic as expected.

Lee, Joseph W.↗

Three Component Doppler Global Velocimeter Measurements of the Flow Above A Delta Wing

A new measurement technique is being developed by NASA to measure off-surface flow fields. This method, Doppler global velocimetry, will allow quantification of complex three-dimensional flow fields at video camera rates. The entire flow field structure within a selected plane is measured simultaneously rather than by scanned, point-by-point measurements using conventional laser velocimetry. To assess the capability of this new technique, three - component velocity measurements of the vortical flow field above a thin 75-degree delta wing were made in the NASA Langley Basic Aerodynamics Research Tunnel. Measurements were made of the flow field at the 70-percent chord location at angles-of-attack of 20.5 and 40.0 degrees to investigate unburst and burst vortices. For comparison, previous fringe-type laser velocimeter measurements of the flow field at the same conditions are included.

Meyers, James F.↗

Signal processing schemes for Doppler global velocimetry

Two schemes for processing signals obtained from the Doppler global velocimeter are described. The analog approach is a simple, real-time method for obtaining an RS-170 video signal containing the normalized intensity image. Pseudocolors are added using a monochromatic frame grabber producing a standard NTSC video signal that can be monitored and/or recorded. The digital approach is more complicated, but maintains the full resolution of the acquisition cameras with the ability to correct the signal image for pixel sensitivity variations and to remove background light. Prototype circuits for each scheme are described, and example results from the investigation of the vortical flow field above a 75-deg delta wing are presented.

Meyers, James F.↗

Signal Processing Schemes for Doppler Global Velocimetry

Two schemes for processing signals obtained from the Doppler global velocimeter are described. The analog approach is a simple, real time method for obtaining an RS-170 video signal containing the normalized intensity image. Pseudo colors are added using a monochromatic frame grabber producing a standard NTSC video signal that can be monitored and/or recorded. The digital approach is more complicated, but maintains the full resolution of the acquisition cameras with the capabilities to correct the signal image for pixel sensitivity variations and to remove of background light. Prototype circuits for each scheme are described and example results from the investigation of the vortical flow field above a 75-degree delta wing presented.

Meyers, James F.↗