Lee, Hyunsoo | Engineering Papers

DOE OSTI2024

Investigation of Interlayer Dielectric in BaTiO 3 /III–Nitride Transistors

In this paper, the impact of varying the thickness of the Al 2 O 3 interlayer dielectric on the electrical characteristics of BaTiO 3 /III-nitride transistors is investigated. In the findings, it is revealed that a minimum thickness of 8 nm for the Al 2 O 3 layer is crucial to maintain high device performance and protect against sputtering-induced damage during BaTiO 3 deposition. The fabricated BaTiO 3 /Al 2 O 3 /AlGaN/GaN high electron mobility transistors exhibit exceptional electrical properties, including a maximum current density of 700 mA mm –1 , an on-resistance of 5 Ω mm, an I ON /I OFF ratio of 10 7 , a subthreshold slope of 119 mV dec –1 , and significantly reduced gate leakage current. The devices with the optimal 8 nm Al 2 O 3 thickness demonstrates excellent agreement between theoretical and experimental values for effective mobility, achieving a value of 1188 cm 2 V –1 ·s at a 2D electron gas density of 10 13 cm –2 . Furthermore, in the study, it is confirmed that increasing the Al 2 O 3 thickness also improves the quality of interface charge density, as evidenced by the results obtained from capacitance–voltage measurements. In these findings, the critical role of controlling the Al 2 O 3 thickness in optimizing the electrical characteristics and overall performance of BaTiO 3 /III-nitride transistors are highlighted.

42 ENGINEERING↗

DOE OSTI2023

Wireless System Development for GaN-Based Transmitters for Advanced Nuclear Reactor Environments

The market for consumer electronics is dominated by Si-based electronics. Many Si-based complementary metal–oxide–semiconductor (CMOS) devices are reaching their limitations in terms of switching frequencies, voltages, currents, and temperatures. Furthermore, these devices are widely known to be susceptible to ionizing radiation and neutrons. Advanced nuclear reactors, especially microreactors and small modular reactors, require wireless electronics that can survive larger neutron and gamma doses than Si CMOS. Because of their size, electronics will need to be placed closer to the reactor cores, and cabling capabilities may be limited. However, GaN high-electron-mobility transistors (HEMTs) have been shown to switch faster with higher gains, and they can achieve current and voltage limits beyond traditional Si CMOS. However, they have less market maturity and have undergone less testing. These GaN HEMTs have been shown to survive ionizing radiation with little effects, but the effects of neutron radiation remain widely unknown. In this report, a wireless electronic system capable of supporting multiple radiation-hardened (rad-hard) sensors is presented. The proposed transmission scheme was designed to be simple to increase the likelihood of success in the immature GaN HEMT process and in high-radiation environments. The transmission system was tested using software-defined radios to emulate the transmission scheme before the transmitter circuitry in the GaN process was developed.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗